Honeywell S9361A - Manuals

S9360A, S9361A, S9370A, S9371A INTEGRATED BOILER CONTROLLERS 69-2076—01 6 NOTE: Cable length must be 36 in. (0.9 m) or less. The cable must not be in continuous contact with a metal surface or spark voltage will be greatly reduced. Use ceramic or plastic standoff insulators as required. 1. Connect o...

S9360A, S9361A, S9370A, S9371A INTEGRATED BOILER CONTROLLERS 69-2076—01 8 Fig. 5. Hot Surface Ignition Wiring (S937X). Common Connectors SENSOR 1 SENSOR 2 GASCONTROL MV MV PRESSURE SWITCH LIMIT SWITCH M24218 ENVIRACOMDISPLAY ENVIRACOMDIAGNOSTIC 24 VACTRANSFORMER L2 L1 GND FLAMESENSE HOT SURFACEIGNIT...

S9360A, S9361A, S9370A, S9371A INTEGRATED BOILER CONTROLLERS 9 69-2076—01 a Indicates optional connection based on configuration. HSI Model Specific Connectors In addition to the common connectors listed above, Table 4 identifies connectors available on the HSI model board assemblies. a Indicates op...

S9360A, S9361A, S9370A, S9371A INTEGRATED BOILER CONTROLLERS 11 69-2076—01 “SP_” Setpoint. “Df_” Setpoint Differential (select models). “°F_” Degrees Fahrenheit Then press the UP or DOWN button until the parameter has reached the desired value. After 60 seconds without any button inputs, the control...

S9360A, S9361A, S9370A, S9371A INTEGRATED BOILER CONTROLLERS 69-2076—01 12 Mounting Sensor and Thermowell The remote upper temperature sensor is installed in an immersion well (Fig. 8) that extends into the supply water side of the boiler. Immersion Well Fitting The immersion well must snugly fit th...

S9360A, S9361A, S9370A, S9371A INTEGRATED BOILER CONTROLLERS 69-2076—01 14 TROUBLESHOOTING IMPORTANT 1. The following service procedures are provided as a general guide. Follow appliance manufac-turer’s service instructions if available. 2. On lockout and retry models, meter readings between gas con...