Page 2 - PACKAGE CONTENTS; HARDWARE CONTENTS; Tools required for assembly:; DD
PACKAGE CONTENTS 2 HARDWARE CONTENTS 1. Canopy 2. Canopy Cover 3. Mounting Bracket Screw (x4) 4. Mounting Bracket 5. Downrod 6. Downrod Pin 7. Downrod Clip 8. Yoke Cover 9. Set Screw (x2)10. Motor Screw (x6) 11. Motor Assembly12. Fitter Plate13. Fitter Plate Screw (x3)14. Light Pan15. Light Pan Scre...
Page 3 - Two Mounting Options; Choose one of the following mounting options:; Downrod Mount; not steeper than 16°.
3 A. 16.55 in. B. 12.38 in. C. 7.4 in. D. 5.13 in. DIMENSION REFERENCE MOUNTING OPTIONS Two Mounting Options Downrod Mount Angled Ceiling Mount (Up to 16 degrees) Choose one of the following mounting options: Downrod Mount is best suited for ceilings 8 ft. or higher. For taller ceilings you may want...
Page 4 - SAFETY INSTRUCTIONS
4 READ ALL SAFETY INFORMATION AND INSTALLATION INSTRUCTIONS BEFORE YOU BEGIN INSTALLING THE FAN AND SAVE INSTRUCTIONS. This fan is intended for indoor, damp, or outdoor use.All set screws of the fan must be checked and retightened where necessary before installation.To reduce the risk of personal in...
Page 5 - cloth to clean the ceiling fan.
WARNING: To avoid risk of electric shock, be sure to shut off power at the main fuse or circuit breaker box before installing or servicing this fixture. Turning off the electrical power by using the light switch is not sufficient to prevent electrical shock. To reduce the risk of injury, install the...
Page 6 - ASSEMBLY INSTRUCTIONS
Downrod Clip Set Screw Yoke Downrod Pin Downrod 6 Phillips-head Motor Screw ASSEMBLY INSTRUCTIONS 1 3 Mounting Bracket Screw 2 4 2. Loosen all four mounting bracket screws located on the mounting bracket and completely remove the two screws from the round holes in the canopy. Save the screws for lat...
Page 8 - Skip to; For installation in Canada:
8 ASSEMBLY INSTRUCTIONS Secondary Support Screw Open Loop Support Washer Secondary Spring Washer 10 9. Install secondary support screw, secondary spring washer, and support washer partly into the side of the brace installed in the ceiling. Then lift the braided cable up and over the ceiling brace an...
Page 10 - Assembly is complete.
Pull Chain Extension 10 ASSEMBLY INSTRUCTIONS 15. Connect the 9-pin connector from the fitter plate to the 9-pin connector from the light pan. 16. Remove one of the three light pan screws preassembled to the light pan and loosen the other two but do not remove. Then, connect the single- pin connecto...
Page 11 - OPERATING INSTRUCTIONS; In warmer weather
11 Reverse Switch Fan Pull Chain Light Pull Chain OPERATING INSTRUCTIONS 1. Using a ceiling fan will allow you to raise your thermostat setting in summer and lower your thermostat setting in winter without feeling a difference in your comfort. In warmer weather , push the reverse switch left which w...
Page 12 - TROUBLESHOOTING
12 PROBLEM SUGGESTED REMEDY TROUBLESHOOTING If you have difficulty operating your new ceiling fan, it may be the result of incorrect assembly, installation or wiring. In some cases, these installation errors may be mistaken for defects. If you experience any faults, please check the Troubleshooting ...
Page 13 - Model Name: 56” Ceiling Fan; LIMITED LIFETIME WARRANTY; To obtain Service, please contact the Service Department:; licensed electrician will render the warranty invalid.
13 Model Name: 56” Ceiling Fan Model No: 51862 LIMITED LIFETIME WARRANTY To obtain Service, please contact the Service Department: 1-877-706-3267, 8 a.m. - 5 p.m. Central, Monday - Friday. Set forth below, the manufacturer, Hong Kong China Electric appliance Company (HKC) warrants the fan motor for ...