Henny Penny HCS-2 - Manuals

Page 3 - LIMITED WARRANTY FOR HENNY PENNY EQUIPMENT

Model HCS-2/HCW-3/HCW-5/HCW-8 FM05-019-F Revised 02-14-07 LIMITED WARRANTY FOR HENNY PENNY EQUIPMENT Subject to the following conditions, Henny Penny Corporation makes the following limited warranties to the original purchaser only for Henny Penny appliances and replacement parts: NEW EQUIPMENT: Any...

Page 4 - Distributor Lists - Domestic and International

Model HCS-2/HCW-3/HCW-5/HCW-8 TABLE OF CONTENTS Section Page Section 1. INTRODUCTION ....................................................................................................... 1-1 1-1. Heated Display Cabinet ..................................................................................

Page 5 - SECTION 1. INTRODUCTION; CABINET

Model HCS-2/HCW-3/HCW-5/HCW-8 SECTION 1. INTRODUCTION 1-1. HEATED DISPLAY The Henny Penny Heated Display Cabinet is a basic unit of food CABINET processing equipment used to display the food product andmaintain the temperature of hot foods in the commercial foodservice operation. This highly efficie...

Page 6 - NOTICE is used to highlight especially important information.

Model HCS-2/HCW-3/HCW-5/HCW-8 1-5. SAFETY The only way to ensure safe operation of the Henny Penny HeatedDisplay Cabinet is to fully understand the proper installation,operation, and maintenance procedures. The instructions in thismanual have been prepared to aid you in learning the properprocedures...

Page 7 - SECTION 2. INSTALLATION

Model HCS-2/HCW-3/HCW-5/HCW-8 SECTION 2. INSTALLATION 2-1. INTRODUCTION This section provides the installation instructions for the HennyPenny Heated Display Cabinet. Installation of this unit should be performed only by a qualifiedservice technician. Do not puncture the skin of the unit with drills...

Page 8 - The unit is now ready for location and set-up.

Model HCS-2/HCW-3/HCW-5/HCW-8 2-2. UNPACKING (Continued) 2. Open top flaps and remove packing. 3. Lift carton off skid. 4. Remove four bolts from under skid. The unit is now ready for location and set-up. 2-2 103 Step 2 Step 3 Step 4

Page 9 - Remove the seven screws fastening the end panel to the cabinet.; PANEL; Slide bottom of end panel out first allowing top to drop below

Model HCS-2/HCW-3/HCW-5/HCW-8 2-3. LOCATION Place the unit on a table, preferably with a cut-out opening belowthe cabinet to allow easy service connections and serviceability.When setting up the Henny Penny Heated Display Cabinet, be sureto level the table. The unit has built-in draining capabilitie...

Page 11 - The electrical power can be connected from the bottom or from the; Model; The automatic water system has a 1/4 inch compression fitting for; CONNECTION; Reinstall the end panel.

Model HCS-2/HCW-3/HCW-5/HCW-8 2-6. ELECTRICAL CONNECTION The electrical power can be connected from the bottom or from the (Continued) operator’s side. There is a 1-3/32 inch diameter hole for eitherconnection. Again, we recommend the bottom connection as thiswill give a cleaner appearance to the un...

Page 15 - SECTION 3. OPERATING INSTRUCTIONS

Model HCS-2/HCW-3/HCW-5/HCW-8 SECTION 3. OPERATING INSTRUCTIONS 3-1. INTRODUCTION This section provides operating procedures for the heated displaycabinets. The Introduction, Installation and Operation sectionsshould be read, and all instructions should be followed beforeoperating the cabinet. 3-2. ...

Page 21 - PRODUCT

Model HCS-2/HCW-3/HCW-5/HCW-8 4. Install the perforated bun pans over the water well. This will help in a more rapid heat up of the water. 5. Close the doors. 6. Turn the power switch to the ON position. 7. Turn the light switch to the ON position. 8. Turn the radiant heat switch to the desired sett...

Page 22 - CLEANUP

Model HCS-2/HCW-3/HCW-5/HCW-8 3-5. SHUT-DOWN AND 1. Turn the water thermostat to OFF. CLEANUP 2. Turn the radiant heat to OFF. 3. Turn the water control switch to OFF. 4. Open the doors. 5. Remove all the pans. 6. Remove the drain standpipe. 7. Remove the grids from the water pan and clean with soap...

Page 23 - SECTION 4. TROUBLESHOOTING

Model HCS-2/HCW-3/HCW-5/HCW-8 4-1. TROUBLESHOOTING GUIDE Product not • Doors are not kept closed • Keep doors closed when holding possible temperature • Product held too long • Only hold product forrecommended times • Water temperature too low • Turn to higher setting • Radiant heat too low • Turn t...

Page 24 - G L O S S A R Y

Model HCS-2/HCW-3/HCW-5/HCW-8 G L O S S A R Y HENNY PENNY HOLDING CABINETS air temperature probe a round device located inside the cabinet that measures the inside airtemperature and sends that information to the control panel concentration ring assembly a metal assembly located in the water pan in ...