Henny Penny CW-216 - Manuals

Page 3 - LIMITED WARRANTY FOR HENNY PENNY EQUIPMENT

Model CW-216/CW-114 FM05-020-F Revised 11-27-07 LIMITED WARRANTY FOR HENNY PENNY EQUIPMENT Subject to the following conditions, Henny Penny Corporation makes the following limited warranties to the original purchaser only for Henny Penny appliances and replacement parts: NEW EQUIPMENT: Any part of a...

Page 4 - Distributor Lists - Domestic and International

Model CW-216/CW-114 TABLE OF CONTENTS Section Page Section 1. INTRODUCTION ....................................................................................................... 1-1 1-1. Display Counter Warmer ..................................................................................... 1-1...

Page 5 - SECTION 1. INTRODUCTION; WARMER

Model CW-216/CW-114 SECTION 1. INTRODUCTION 1-1. DISPLAY COUNTER The Henny Penny Display Counter Warmer is a basic unit of WARMER food processing equipment used to display the food product andmaintain the temperature of hot foods in the commercial foodservice operation. This highly efficient, qualit...

Page 6 - NOTICE is used to highlight especially important information.

Model CW-216/CW-114 1-2 203 1-5. SAFETY The only way to insure safe operation of the Henny PennyDisplay Counter Warmer is to fully understand the properinstallation, operation, and maintenance procedures. Theinstructions in this manual have been prepared to aid you inlearning the proper procedures. ...

Page 7 - SECTION 2. INSTALLATION

Model CW-216/CW-114 SECTION 2. INSTALLATION 2-1. INTRODUCTION This section provides the installation instructions for the HennyPenny Display Counter Warmer. Installation of this unit should be performed only by a qualifiedservice technician. Do not puncture the skin of the unit with drills orscrews ...

Page 9 - Remove the seven screws fastening the end panel to the; PANEL; Slide bottom of end panel out first allowing top to drop

Model CW-216/CW-114 2-3. LOCATION Place the unit on a table, preferably with a cut-out opening belowthe cabinet to allow easy service connections and serviceability.When setting up the Henny Penny Display Counter Warmer,be sure to level the table. The unit has built-in draining capabilities, but thi...

Page 11 - TABLE; Model Volts; CONNECTION; Reinstall the end panel.

Model CW-216/CW-114 2-6. ELECTRIC CONNECTION The electrical power can be connected from the bottom or from (Continued) the operator’s side. There is a 1-3/32 inch diameter hole fromeither connection. Again, we recommend the bottom connectionas this will give a cleaner appearance to the unit. Please ...

Page 16 - Figure 3-11

Model CW-216/CW-114 1107 3-3 3-2. OPERATING CONTROLS (Continued) Figure 3-6 Figure 3-7 Figure 3-10 Figure 3-11 Figure 3-8 Figure 3-9

Page 19 - PRODUCT

Model CW-216/CW-114 3. Place pans into the water pan insert. 4. Install and close the doors. 5. Turn the power switch to the ON position. 6. Turn the light switch to the ON position. 7. Turn the radiant heat switch to the desired setting. We recommend stating at 6 for the lower radiant. If you haveu...

Page 21 - SECTION 4. TROUBLESHOOTING

Model CW-216/CW-114 4-1. TROUBLESHOOTING GUIDE Product not • Doors are not kept closed • Keep doors closed when holding possible temperature • Product held too long • Only hold product forrecommended times • Water temperature too low • Turn to higher setting • Radiant heat too low • Turn to higher s...

Page 22 - G L O S S A R Y

Model CW-216/CW-114 G L O S S A R Y HENNY PENNY HOLDING CABINETS air temperature probe a round device located inside the cabinet that measures the inside airtemperature and sends that information to the control panel concentration ring assembly a metal assembly located in the water pan in the bottom...