Haier HDY-E60 - Manuals - manualsarea.com

Page 4 - Read all instructions before using this dryer.; SAVE THESE INSTRUCTIONS.; have just purchased due to technical improvements.

Extra Dry 100min 30min 60min 30min Read all instructions before using this dryer. This dryer has been designed for domestic use only. SAVE THESE INSTRUCTIONS. This diagram may be slightly different from the layout of the dryer you have just purchased due to technical improvements. Power supply cord ...

Page 5 - towel; Turning on power; accordance with the value indicated on the name plate.; Preparation of laundry load; is still dripping wet or has excess water.; Load to dry

Attention: 1.Before operation, clean off any dust and dirt inside the drum of the dryer with a damp towel . 2.Clean off any debris on the lint filter and in the duct to increase the drying efficiency. Turning on power Before turning on the power of the dryer check whether the supply voltage is in ac...

Page 6 - You may choose to start the dryer after a preset time.

1. Power up Insert the power plug into an appropriate power outlet that is properly installed and grounded. Operating power supply: 220-240V~50Hz. 2. Laundry loading Open the door and load the laundry into the drum of the dryer. For a more energy efficient and better drying result, make sure the loa...

Page 7 - A - Program control knob; Heat Dry

Extra Dry 100min 30min 60min 30min A - Program control knob D - Start/Pause button F - Indicator light E - Program setting Heat Dry Extra dry* Normal** 6 A D E Sensor Program The drying time will depend on the type of fabric. The maximum time is 4 hours. Choose the program according to the type of f...

Page 8 - WARNING! Unplug the power cord prior to any cleaning

WARNING! Unplug the power cord prior to any cleaning Cleaning the surface Wipe off any dust or dirt. Note: Do not use excessive water,. a damp cloth is fine. Do not use solvent. Do not use spray cleaners when cleaning the interior. Do not use harsh or abrasive cleaners. Cleaning the filter screen To...

Page 9 - Unpacking your dryer

Remove the transport packaging (fig.1) Remove the tape on the door (fig.2), the wall mounting kit and the inverted panel film attached to the inside of the drum (fig.3) before starting the dryer. Packing accessories Check list of the accessories and materials provided with the machine: To ensure the...

Page 10 - INSTALLATION INSTRUCTIONS; Tools required; Free standing

Extra Dry 100min 30min 60min 30min INSTALLATION INSTRUCTIONS 9 Tools required For plaster/ Drill & 3mm Bit 1 Wooden wall Philips head screwdriver 1 Wall mounting kit includes Plastic spacers 2Wall hanging brackets 2 Hanging hook 2 Wood screws, 12gx50mm 4Screws for hanging hooks 6 and plastic spa...

Page 11 - INSTALLATION INSTRUCTIONS; brackets onto the slat. The distance between each is 553 mm as per

INSTALLATION INSTRUCTIONS 10 2.Fix the wall hanging brackets to the wall securely (eg. into the stud). If the studs are too far apart, fit a timber slat to the studs then mount the brackets onto the slat. The distance between each is 553 mm as per diagram (Fig.1). Wood screw 553 mm 3. Install the ho...

Page 12 - Caution; Stacking installation; Screws; other program, until the inversion is displayed.

INSTALLATION INSTRUCTIONS 5. With assistance, mount dryer on wall brackets. See Fig.4. 6. A second control panel with inverted symbols is supplied. Peel the release paper from the back of inverted film then place new control panel film on the surface so that the writing is the correct way around. 11...

Page 13 - sure the included screws are used. Fix the stacking kit on the top; Dryer

INSTALLATION INSTRUCTIONS 2. Install the dryer with stacking kit on the top of the front load washing machine (Fig.3). Drill two holes on both sides of washer with 2.9mm diameter drill. Detailed drill postion as shown on the stacking kit. Make sure the included screws are used. Fix the stacking kit ...

Page 14 - Rear venting

INSTALLATION INSTRUCTIONS 13 Rear venting If you want to choose the rear venting mode, the exhaust grill at the front of the dryer needs to be replaced with the outlet cover from the back panel of the dryer. Gently open the grill, using a thin tool such as a key. Next, remove the cover from the back...

Page 15 - Control board; NTC

14 The following must be confirmed before calling for service: Problem Possible Cause The dryer does not start The drying result is not good Is the dryer plugged in? Is the power on? Is the door closed properly? Has a drying program been set? Has the Start/Pause button been pressed? Was the correct ...

Page 16 - ITEM

Power supply Maximum operating current (A) Rated load (kg) Drying program Maximum power (W) Dimensions (HxDxW) mm Weight (kg) （ 220-240)V~ · 50Hz 10 6 7 2100 830x560x600 30 IPX4 W aterproof degree ITEM TYPE HDY-E60 15 0180500432