Haier HDV50E1 - User Manual

SAFETY AND WARNINGS 4 Spontaneous combustion IMPORTANT! To reduce the risk of fire in a tumble dryer the following should be observed: ■ Items that have been spotted or soaked with vegetable oil or cooking oil are a fire hazard and should not be placed in a tumble dryer. ■ Oil-affected items can ign...

INSTALLATION INSTRUCTIONS Please read and follow the ‘Safety and warnings’ and ‘Installation instructions’ sections carefully before using your dryer. Unpacking 1 Remove all the packaging. 2 Tilt the dryer backwards and ‘walk’ it off the base one foot at a time. 3 Remove all packaging and accessorie...

INSTALLATION INSTRUCTIONS Venting Correct installation is very important for all dryers to ensure maximum efficiency and safety. IMPORTANT! Never run the dryer unless the airflow system is free from obstruction. There must be adequate ventilation to avoid the back flow of gases into the room from ap...

INSTALLATION INSTRUCTIONS Free standing The dryer stands on the floor and can easily be moved into position. 1 Move the dryer into the desired position. Do not lift the dryer by the top panel. 2 Have a minimum clearance on all sides of at least 20mm. 3 Have a minimum clearance at the rear of 75mm. T...

INSTALLATION INSTRUCTIONS Mounting dryer on wall 1 Determine the position of the dryer on the wall and mark the bracket position. A minimum of 50mm is needed between the top of the dryer and the ceiling for ease of installation. If mounting above a washing machine, allow sufficient room to open the ...

INSTALLATION INSTRUCTIONS Stacking installation Your dryer has been designed to be able to be stacked on the top of a Haier front load washing machine, ensure the washing machine is the same width as your dryer. Tools and parts required: ■ Drill and 2.9mm bit ■ Phillips head screwdriver 1 Remove 4 s...

INSTALLATION INSTRUCTIONS Before a rear venting option is installed the dryer must be changed from the front venting factory setup. Remove the outlet grille from the front left-hand side and replace with the outlet cover from the rear left-hand side. These covers should be gently pried at the sides ...

INSTALLATION INSTRUCTIONS Electrical connection 1 This appliance must be connected to a 220V-240V, 50Hz, sinusoidal, 10A electrical supply. 2 Uncoil the power cord, remove and discard the plastic pin cover and plug into a power socket. 3 Connect the appliance to an earthed outlet protected by a fuse...

CONTROL PANEL 12 A Press ‘Power’ button to activate your dryer. Press it again to switch the dryer off. B ‘Key Lock’ can be used to lock the buttons on your dryer.This will avoid accidental button presses. C There are two drying settings with your dryer, Sensor Dry and Time Dry. The default cycle is...

DRYING CYCLES DESCRIPTION MAX. LOAD SIZE (KG) CYCLE TEMPERATURE 6 High 4 Med Low Sensor dry Your dryer has three dryness levels from ‘Damp’ through to ‘Extra’. Choose the dryness level to suit your load depending on how dry you wish for your load to be. The default temperature for sensor dry cycle i...

USING YOUR DRYER IMPORTANT! ■ Check the lint filter is clean before every load. Ensure it is replaced correctly before using your dryer. ■ The lint filter indicator light will be on at the beginning of every cycle as a reminder to check the lint filter. ■ Sort and load items into the dryer drum, ens...

CLEANING YOUR DRYER IMPORTANT! ■ If you wish to stop the dryer before the cycle has finished you MUST remove the clothes IMMEDIATELY and spread them out to cool. DO NOT leave the clothes in the dryer or bunched up in a clothes basket. Take extreme care as the drum and the load items may be extremely...

BEFORE YOU CALL FOR SERVICE To clean the filter: 1 Open the dryer door. 2 Remove the lint filter by pulling it up and out of the filter slot. 3 Open it out and wipe the surface clean with your hand. 4 Close the lint filter and place it back in the opening. Ensure the filter is fitted correctly back ...

TROUBLESHOOTING The following is a list of problems you may encounter when using this appliance and some suggestions that may help to correct the problem. If you still have problems, please contact your Haier Repairer. PROBLEM POSSIBLE CAUSES WHAT TO DO Pressing ‘Power’ does not turn on the dryer. F...