Fujitsu M3000 - Manuals - manualsarea.com

Page 2 - Note –; Installation Steps for SPARC Enterprise M3000 Server; SPARC; Prepare items required for installing the server.; See the; Caution –; Connect the power cords to the power supply system.; SPARC Enterprise M3000 Server Installation Guide; Administration

2 Note – AC power supply model and DC power supply model are available for the M3000 server. The chapters of each document are written based on AC power supply model. If there is any specific information on DC power supply model, it is indicated in the appendix “DC Power Supply Model“ of each docume...

Page 3 - Rear Panel of the Server; connect the administration console to the serial port (see; Be careful not to connect a LAN cable to the serial port.; Power supply unit; AC Power Supply Model

3 FIGURE 1 Rear Panel of the Server 7. Use the RS232C cable (serial cable, RJ-45 to DB-9) supplied with the server in the Accessory Kit, and connect the administration console to the serial port (see FIGURE 1 , #3) on the rear panel of the server. You can use any of the following devices with a DB-9...

Page 4 - a. Set the mode switch on the operator panel to the Service mode (; The key for the mode switch is supplied with the server.; Operator Panel; c. After the XSCF initialization completes, enter; A login authentication timeout will occur after one minute.; POWER LED; default; Leave it in that position for at least 5 seconds.

4 8. The following steps will log in to the XSCF Shell and initialize the XSCF settings. XSCF is a system control facility to set up and control the server. To initialize the XSCF settings, use the XSCF default user account. a. Set the mode switch on the operator panel to the Service mode ( ). The k...

Page 5 - The following steps will power on the server.; This switches you from the XSCF Shell to the domain console.; ) on the operator panel to power on the server.; The ok prompt is displayed after the self-diagnosis completes.; Date and time settings; Altitude administration setting; Dual power feed option setting

5 e. Confirm that the XSCF Shell prompt is displayed on the administration console. f. Initialize the XSCF settings. The following are the required settings for installation. For details on the setting procedure, see the SPARC Enterprise M3000/M4000/M5000/M8000/M9000 Servers XSCF User’s Guide . g. L...

Page 6 - This switches you from the domain console to the XSCF Shell.; fmdump; connected to the system control network.; To switch from the XSCF console to the ok prompt, enter the; showhardconf

6 g. Press the Enter key, and then press the "#" and “.“(period) keys. This switches you from the domain console to the XSCF Shell. h. From the XSCF Shell, execute the fmdump command or showlogs command, and confirm that no errors are found. 10. Connect the system control network to a LAN po...

Page 7 - Oracle VTS User’s Guide; Make the initial settings for the domain.; For details, see the; boot

7 14. The following steps will boot the Oracle Solaris Operating System. The Oracle Solaris OS is preinstalled in the slot 0 of the hard disk drives. a. From the ok prompt of the domain console, execute the boot command. b. After the login prompt is displayed, log in with root account. 15. Confirm h...

Page 8 - FUJITSU LIMITED; Documentation Feedback

Manual Code: C120-E536-04ENMarch 2012, Revision A 8 FUJITSU LIMITED Documentation Feedback If you have any comments or requests regarding this document, or if you find any unclear statements in the document, please state your points specifically on the form at the following website: http://www.fujit...