Page 7 - Übersicht/Overview Mainboard D1931
A26361-D1931-Z120-1-7419 Umschlag/Cover Übersicht/Overview Mainboard D1931 Interne Anschlüsse und Steckplätze / Internal connectors and slots PCI 2 PCI 1 sl o t 1 sl o t 3 sl o t 4 sl o t 2 Channel B C h a nnel A 5 8 12 6 9 10 11 15 16 13 17 19 18 20 21 7 14 PCI Express x16 PCI Express x1 12 3 4 1 =...
Page 9 - Contents
A26361-D1931-Z120-1-7419, Edition 1 English Contents Übersicht/Overview Mainboard D1931 Mainboard D1931 ............................................................................................................................. 1 Notational conventions.................................................
Page 11 - Notational conventions
A26361-D1931-Z120-1-7419, Edition 1 English - 1 Mainboard D1931 Your mainboard is available in different configuration levels. Depending on the configuration chosen, some of the hardware components described may not be available on your mainboard. Additional information Information on the BIOS Setup...
Page 12 - Important notes; Information about boards
Important notes 2 - English A26361-D1931-Z120-1-7419, Edition 1 Important notes With the mainboard installed you must open the system to access the mainboard. How to dismantle and reassemble the system is described in the operating manual accompanying the system. Connecting cables for peripherals mu...
Page 13 - List of features
List of features A26361-D1931-Z120-1-7419, Edition 1 English - 3 List of features Onboard features D1931-A Chipset Intel ® 915G Board size µATX VGA ! Audio / 8-channel / S/PDIF ! / - / - Buzzer / int. Speaker Support - / ! LAN 1 Gbit / 100 Mbit / 10 Mbit ! / ! / ! LAN ASF / Alert-on-LAN / WoL / Boot...
Page 15 - Special features
List of features A26361-D1931-Z120-1-7419, Edition 1 English - 5 Special features Your mainboard is available in different configuration levels. Depending on the configuration, your mainboard is equipped with or supports the features described in the following. Silent Fan LT A controller regulates t...
Page 17 - Brief instructions on installing mainboard; Prior to installation; Installation
A26361-D1931-Z120-1-7419, Edition 1 English - 7 Brief instructions on installing mainboard If you have purchased a separate mainboard, you can install the mainboard in your system in accordance with the following brief instructions. The activities described here assume a basic knowledge of PCs and c...
Page 18 - Driver installation
Brief instructions on installing mainboard 8 - English A26361-D1931-Z120-1-7419, Edition 1 ► Should no suitable connection field be provided in the case, then you must install the connection field (1) provided. Ensure the plate is aligned properly so that the connections are suitable for the mainboa...
Page 19 - Interfaces and connectors; LAN; LAN connector
A26361-D1931-Z120-1-7419, Edition 1 English - 9 Interfaces and connectors The positions of the interfaces and connectors are shown on page "Cover". The components and connectors marked are not necessarily present on the mainboard. External ports The positions of the external ports are shown ...
Page 20 - Graphics port; Internal ports and connectors; Hard disk connection
Internal ports and connectors 10 - English A26361-D1931-Z120-1-7419, Edition 1 Graphics port Technical data Function: 2D/3D graphics controller, Dynamic Video memory Technology, 400 Mhz integrated 24-bit RAMDAC Features: Display Data Channel (DDC), 2 DVO channels (up to 165 megapixels per channel), ...
Page 21 - Audio front panel
Internal ports and connectors A26361-D1931-Z120-1-7419, Edition 1 English - 11 Audio front panel If you want to use the internal connection for the audio front panel for the front side of the system, then proceed as follows: ► Remove all plug-in jumpers from the audio front panel connection. ► Conne...
Page 22 - Pin assignment of internal ports; Front panel
Pin assignment of internal ports 12 - English A26361-D1931-Z120-1-7419, Edition 1 Pin assignment of internal ports The pin assignment of some internal connections is shown in English in the following. i Some of the following connectors may be optional! Front panel Watch the poling of the LEDs. The p...
Page 23 - Serial ATA
Pin assignment of internal ports A26361-D1931-Z120-1-7419, Edition 1 English - 13 Pin Signal Pin Signal 1 GND 2 Speaker - 3 "Stand by" LED + 4 Key 5 Key 6 GND 7 "Power On" LED + 8 Speaker + 9 "Power On" LED + 10 Reserved 11 "Power On" LED - "Stand by" LED - (G...
Page 24 - ATA interface
Pin assignment of internal ports 14 - English A26361-D1931-Z120-1-7419, Edition 1 ATA interface 1 2 Pin Signal Pin Signal 1 Reset drive (low asserted) 2 GND 3 Data 7 (high asserted) 4 Data 8 (high asserted) 5 Data 6 (high asserted) 6 Data 9 (high asserted) 7 Data 5 (high asserted) 8 Data 10 (high as...
Page 25 - Audio Input
Pin assignment of internal ports A26361-D1931-Z120-1-7419, Edition 1 English - 15 Audio Input 1 Pin Signal 1 Left audio input 2 Audio GND 3 Audio GND 4 Right audio input Power control (system monitoring) 1 Pin Signal 1 Power Guard Control 2 PS FAN Control 3 4 PS FAN Sense 5 6 7 8 Audio port front 1 ...
Page 27 - Power supply BTX
Pin assignment of internal ports A26361-D1931-Z120-1-7419, Edition 1 English - 17 Power supply BTX (ATX compatible) 1 13 Pin Signal Pin Signal 1 +3,3 V (P3V3P) 13 +3,3 V (P3V3P) 2 +3,3 V (P3V3P) 14 -12 V (P12VN) 3 GND 15 GND 4 +5V (VCC) 16 PS on (low asserted) 5 GND 17 GND 6 +5V (VCC) 18 GND 7 GND 1...
Page 28 - Jumper settings
Pin assignment of internal ports 18 - English A26361-D1931-Z120-1-7419, Edition 1 Jumper settings Your mainboard is equipped with jumpers. The positions of the jumpers are shown on page "Cover". Setting via control-panel plug connector A C 12 12 B 12 Pin pair A inserted = Skipping system and...
Page 29 - Replacing processor; Installing processor with heat sink
A26361-D1931-Z120-1-7419, Edition 1 English - 19 Add-on modules / Upgrading ! Exit energy-saving mode, switch off the system and remove the power plug from the mains outlet, before carrying out any of the procedures described in this chapter! Even when you have run down the device, parts of the devi...
Page 31 - Mounting heat sink
Replacing processor A26361-D1931-Z120-1-7419, Edition 1 English - 21 Mounting heat sink Be sure to use heat conducting material between the processor and the heat sink. If a heat conducting pad (rubber-like foil) is already applied to the heat sink, then use it. Otherwise you must apply a very thin ...
Page 32 - Upgrading main memory
Upgrading main memory 22 - English A26361-D1931-Z120-1-7419, Edition 1 Upgrading main memory Technical data Technology: DDR 333 or DDR 400 unbuffered DIMM modules 184-Pin; 2.5 V; 64 Bit, no ECC Size: 128 Mbytes to 4 Gbyte DDR 333 SDRAM 128 Mbytes to 4 Gbyte DDR 400 SDRAM Granularity: 128, 256, 512 o...
Page 34 - Adding PCI Express cards; PCI bus interrupts - Selecting correct PCI slot
Adding PCI Express cards 24 - English A26361-D1931-Z120-1-7419, Edition 1 Adding PCI Express cards The PCI Express x16 slot is intended for graphics cards, and the PCI Express x1 slot for PCI Express x1 cards. Adding PCI cards Technical data: 32 bit / 33 MHz PCI slots 5 V and 3.3 V supply voltage 3....
Page 35 - Adding PCI cards
Adding PCI cards A26361-D1931-Z120-1-7419, Edition 1 English - 25 Multifunctional expansion cards or expansion cards with integrated PCI-PCI bridge: These expansion cards require up to four PCI interrupts: INT A, INT B, INT C, INT D. How many and which of these interrupts are used is specified in th...
Page 36 - Replacing the lithium battery
Adding PCI cards 26 - English A26361-D1931-Z120-1-7419, Edition 1 Replacing the lithium battery In order to permanently save the system information, a lithium battery is installed to provide the CMOS-memory with a current. A corresponding error message notifies the user when the charge is too low or...
Page 37 - BIOS update
BIOS update A26361-D1931-Z120-1-7419, Edition 1 English - 27 BIOS update When should a BIOS update be carried out? Fujitsu Siemens Computers makes new BIOS versions available to ensure compatibility to new operating systems, new software or new hardware. In addition, new BIOS functions can also be i...
Page 38 - BIOS Recovery - Recovering System BIOS
BIOS Recovery - Recovering System BIOS 28 - English A26361-D1931-Z120-1-7419, Edition 1 BIOS Recovery - Recovering System BIOS i All BIOS settings are reset to the default values. ► Open the casing as described in the operating manual. ► Set the switch for "Restore system BIOS" to ON . ► Clo...
Page 39 - Microcode Update
Microcode Update A26361-D1931-Z120-1-7419, Edition 1 English - 29 Microcode Update What is a microcode update? As there are no drivers for processors, Intel offers the possibility from the P6 family (Pentium Pro) on to update the command set (microcode) of the processor. This enables minor errors to...
Page 40 - Drivers
Drivers 30 - English A26361-D1931-Z120-1-7419, Edition 1 Drivers Only when no drivers are installed on your system, or you want to update these, proceed as follows: ► Insert the CD "Drivers & Utilities Collection" into the CD-ROM drive. ► If the CD does not start automatically, run the S...
Page 41 - Annex; Electrical Properties
A26361-D1931-Z120-1-7419, Edition 1 English - 31 Annex Electrical Properties Loadability for connections and fuses i Make sure that the connected devices do not overload the connections. Fuse no. Fuse Connection Maximum loadability 1 750 mA Keyboard Not specified Mouse Not specified VGA port Not spe...
Page 42 - APM and ACPI system status, energy-saving modes
APM and ACPI system status, energy-saving modes 32 - English A26361-D1931-Z120-1-7419, Edition 1 The specifications apply to the onboard components and represent the least favourable case. In addition, at least 350 mA is required for PCI on 3.3 V, and 500 mA per connected device for USB on 5 V. APM ...
Page 43 - Mainboard Revision and BIOS Version
Mainboard Revision and BIOS Version A26361-D1931-Z120-1-7419, Edition 1 English - 33 Mainboard Revision and BIOS Version The compatibility, e.g. with new processors, can be independent of the BIOS version or the revision status of the mainboard used. The CPU and BIOS compatibility lists are availabl...
Page 44 - Error messages
34 - English A26361-D1931-Z120-1-7419, Edition 1 Error messages This chapter contains error messages generated by the mainboard. Available CPUs do not support the same bus frequency - System halted! Memory type mixing detected Non Fujitsu Siemens Memory Module detected - Warranty void There are more...
Page 48 - Glossary
38 - English A26361-D1931-Z120-1-7419, Edition 1 Glossary The technical terms and abbreviations given below represent only a selection of the full list of common technical terms and abbreviations. Not all technical terms and abbreviations listed here are valid for the described mainboard. AC'97 Audi...
