EverFocus EPTZ1000 - Manuals

2-17 2.3.4. Video Format Setting The 6 th bits of the SW2 on the PCB board are used to set the video format. The default video format depends on the factory setting. Please do not change it. ON 123 45 67 8 SW 2 Protocol Baud Rate PAL / NTSC Maching Resistance ON 123 45 6 78 PAL NTSC ON 123 45 6 78 N...

2-19 2. Thread the cable through the hole in the wall mount bracket, and screw in 4 M8 nuts for mounting the bracket. 3. Take off the housing from the packing, and take off the baseboard (4 bolts on it.) inside the housing. Thread the cable through the top of the housing. Fix the housing on the wall...

2-20 5. Align the two screw holes on the bottom of mechanical part to the two bolts on the base of the housing, and twist the mechanical part clockwise a little bit in order to engage it with the base. Screw the two bolts on the base, and then connect and fix the connection bus to the PCB board on t...

2-21 Notice: In order to protect the bulb from dirt and scrape, please put on the gloves before installing the bulb. 7. Turn on the power, and start to operate the EPTZ1000. Note: When turning on the power, the EPTZ1000 will enter self-inspection mode, and carry out a self-testing program. After fin...

3-23 3. EPTZ1000CAMERA SETUP MENU In this section, setup and operation guide of EPTZ1000will be introduced. There are 25 items of the setting menu. However, there is only one line on the line display, so using some combination keys to operate is necessary. 3.1. Structure of the Setup Menu Press MENU...

4-30 4. EPTZ1000FUNCTION SETUP AND OPERATION 4.1. Manual Control Mode ¾ Manual control: Shift Joystick Up/Down/Left/Right, and turn it Clockwise/Counterclockwise to control speed dome. Use the control keys which are Zoom, Focus and IRIS function keys on the keyboard to zoom In/Out, focus N (near)/F ...

4-31 to enter 360° auto pan speed (1~239). The camera will turn 360° automatically, but not tilt. 4.3. Position Setting ¾ Focus on a preset position: Press the number key, and then press Position to focus on the number of preset position; or you can press Position, then enter the preset position num...

4-34 If you set the position number to 99, the dome will do a 360 degree auto scan or AB two point pan if limit is ON. If you set the position number to 98, the dome will do a frame scan. ¾ Delete an alarm link: Press Clr + F1 to delete a link of alarm to position/tour. Note 1: After alarm output si...

4-36 EverFocus Electronics Corp. P/N: MW01G0040B Ver. C Your EverFocus product is designed and manufactured with high quality materials and components which can be recycled and reused. This symbol means that electrical and electronic equipment, at their end-of-life, should be disposed of separately ...