DeLonghi Magnifica ESAM 3600- Manuals

28 Empty the grounds container and clean thoroughly, making sure all residues deposited on the bottom areremoved. IMPORTANT: when removing the drip tray, the grounds container MUST be emptied, even if it is not com-pletely full. If this is not done, when next making coffee the grounds in the contain...

9 PREPARING ESPRESSO COFFEE WITH PRE-GROUND COFFEE (INSTEAD OF BEANS) 1. Press the button (fig. 16) to select the ground coffee function. This disables the coffee mill function. The appliance displays: READY PRE-GROUND 2. Lift the lid in the centre, place one level measure of ground coffee in the fu...

11 CHANGING THE QUANTITY OF HOT WATER The appliance is factory preset to automatically deliver 250 ml of hot water.To change these quantities, proceed as follows:1. Attach the water spout (fig. 4).2. Position a container under the spout (fig. 3).3. Press the button for at least 8 seconds then releas...

13 PREPARING FROTHED MILK (WITHOUT COFFEE) 1. Remove the lid of the milk container.2. Fill the container with the quantity of milk you want to prepare (fig.19).3. Replace the milk container lid.4. Attach the milk container to the appliance (fig. 22).5. Place a sufficiently large cup under the milk s...

32 CORRECT INCORRECT The two red buttons have snapped out CORRECTLY The two red buttons have notsnapped out 1. turn the appliance off by pressing the button (fig. 6) (do not unplug) and wait for the display to go off; 2. open the service door (Fig. 14);3. remove the drip tray and the grounds contain...

GB 33 NOTE 3: If it is still hard to insert the infuser, leave it out of the appliance, close the service door, unplug from the mains, then plug in again. Wait for all the lights to go off after the self-diagnosis, then open the door andreplace the infuser. 15.3 CLEANING THE MILK CONTAINER Proceed a...

34 3. Press the button to set the auto-start time. (If you hold the button down, the time is changed rapidly). 4. Press the button to confirm the value;5. Press once and the appliance displays the message: AUTO-START NO Press the button to modify the function (the appliance displays: AUTO-START Yes ...

RINSING 15. When the water tank is empty, the appliance displays the message: RINSING COMPLETE PRESS OK 16. Press the OK button and refill the water tank with clean water.17. The descale programme is now terminated and the appliance is ready to make coffee again. NOTE: if the descaling cycle is inte...

16.7 RESETTING FACTORY DEFAULT SETTINGS (RESET) If you change the original values, the factory default values can be reset as follows:1. Press the button then press repeatedly until the appliance displays: RESET TO DEFAULT NO 2. Press the button and the appliance displays "RESET TO DEFAULT YES:3...

37 GB PRESS NEXT CHANGE • After cleaning, the infuser has probablybeen left out of the coffee maker. • Leave the service door closed and theinfuser out of the appliance, then followthe instructions displayed. CLOSE DOOR • The service door is open • If the service door cannot be closed,check that the...

38 The coffee does not comeout of the spouts, butrather around the servicedoor. • The holes in the spouts are clogged with dry coffee. • The mobile drawer inside the service door is blocked and cannot swing. • Scrape the holes with a needle (see section 15.1, Fig. 27). • Thoroughly clean the mobile ...