DeLonghi ETAM36.365 - Manuals

8 Please note: Keep these instructions. If the appliance is passed to other per-sons, they must also be provided with these instructions. DEscripTion Description of appliance (page 3 - A ) A1. Top lid A2. Beans container A3. Pre-ground coffee funnel lid with pressure closure A4. Pre-ground coffee fu...

9 connecting the appliance Important! Check that the mains power supply voltage corresponds to the value indicated on the rating plate on the bottom of the ap-pliance. Connect the appliance to an efficiently earthed and correctly installed socket with a minimum current rating of 10A only.If the powe...

10 MEnu sETTinGs To access the settings menu, press the button corresponding to MEnu . Scroll through the menu by pressing the scrolling arrow (< or >) (fig. 9). rinsing Use this function to deliver hot water from the spout to heat the internal circuit and make the coffee delivered hotter. To ...

12 To display, proceed as follows:1. Press the MEnu/Esc button to enter the menu; 2. Press the scrolling arrow (< or >) (fig. 9) until “Statistics” is displayed; 3. Press the button; 4. By pressing the scrolling arrow (< or >) (fig. 9), you can check: - how many coffees have been made;- ...

13 - 1 cup, if you want 1 coffee (fig. 15); - 2 cups if you want 2 coffees (fig. 17). 3. Lower the spout as near as possible to the cups (fig. 16). This makes a creamier coffee . 4. Press the button corresponding to the number of coffees required (1 cup or 2 cups ). 5. Preparation begins. The amount...

14 No froth FLAT WHITE/MILK (hot milk) Min. froth LATTE Max. froth CAPPUCCINO/MILK (frothed milk) Making milk based drinks automatically The FLAT WHITE, CAPPUCCINO, LATTE and MILK buttons on the control panel enable these drinks to be prepared automatically. Proceed as follows:1. Fill the milk conta...

15 avoid splashes). 3. Press the button (fig. 3). “Preparation underway” is displayed (if required). Then hot water is delivered and “HOT WATER” is displayed, together with a progress bar which fills gradually as preparation proceeds. 4. The machine delivers about 250 ml of hot water, then delivery ...

17 Please note! If the infuser is difficult to insert, before insertion, squeeze the two levers shown in the figure to make it smaller. 8. Once inserted, make sure the two red buttons have snapped out. PUSH 9. Close the infuser door.10. Replace the water tank. cleaning the milk container Clean the m...

18 soft water ● slightly hard water ●● hard water ●●● very hard water ●●●● setting water hardness 1. Press the MEnu/Esc button to enter the menu. 2. Press the scrolling arrow (< or >) until “Water Hardness” is displayed. 3. Press the button to confirm the selection. 4. Press the scrolling arro...

20 DispLAYED MEssAGEs DispLAYED MEssAGE possiBLE cAusE soLuTion FILL TANK Insufficient water in the tank. Fill the tank with water and/or insert it correctly, pushing it as far as it will go until it clicks into place. EMPTY GROUNDS CONTAINER The grounds container (A18) is full. Empty the grounds co...

21 TrouBLEshooTinG Below is a list of some of the possible malfunctions.If the problem cannot be resolved as described, contact customer services. proBLEM possiBLE cAusE soLuTion The coffee is not hot. The cups were not preheated. • Enable the cup warmer, leave the cups at least 20 minutes to warm u...