DeLonghi ESAM2800 - Manuals

8 DESIGNATED USE This appliance is designed and made to prepare coffee and heat drinks. All other use is considered improper. This appliance is not suitable for commercial use. The manufacturer is not liable for damage deri- ving from improper use of the appliance. This is a household appliance only...

9 B12. light: grounds container full B13. light: general alarm B14. Rinsing or descaling button with light B15. ECO energy saving mode button with light PRELIMINARY CHECKS Checking the appliance After removing the packaging, make sure the product is complete and undamaged and that all accessories ar...

10 tion of this cycle. Danger of burns! During rinsing, a little hot water comes out of the coffee spouts and is collected in the drip tray underneath. Avoid contact with splashes of water. • To turn the appliance on, press the but- ton (fig. 4). The and lights flash while the appliance is heating u...

12 damage the appliance. • Never use more than one level measure or it could dirty the inside of the machine or block the funnel. Please note: If you use pre-ground coffee, you can only make one cup of coffee at a time. 1. Turn the coffee taste selection knob to the position. 2. Make sure the funnel...

13 2. Wait for a few minutes for the cappuccino maker to cool down. Grip the handle of the cappuccino maker tube firmly in one hand and with the other rotate the cappuccino maker anticlockwise (fig. 14) and remove by pulling downwards (fig. 15). 3. Wash all parts of the cappuccino maker tho- roughly...

14 Cleaning the drip tray Important! If the drip tray is not emptied regularly, the water could overflow from the edge and seep inside or around the machine. This could damage the machine, the surface it rests on or the surrounding area. The drip tray is fitted with a level indicator (red) showing t...

15 red buttons have snapped out. 8. Close the infuser door. 9. Replace the water tank. DESCALING Descale the appliance when the light on the panel flashes. Important! Descaler contains acids which may irritate the skin and eyes. It is vital to respect the manufacturer’s safety warnings given on the ...

16 Level 3 Level 4 Set water hardness 1. Make sure the appliance is off (but connec- ted to the mains electricity supply and with the main switch in the I position); 2. Press and hold the button for at least 6 seconds. The lights come on; 3. Confirm the selection by pressing the button. 4. Turn the ...

19 TROUBLESHOOTING Below is a list of some of the possible malfunctions. If the problem cannot be resolved as described, contact Customer Services. PROBLEM POSSIBLE CAUSE SOLUTION The coffee is not hot • The cups were not preheated. • Warm the cups by rinsing them with hot water (N.B. you can use th...

20 ELECTRICAL REqUIREMENTS Before using this appliance ensure that the voltage indicated on the product corresponds with the main voltage in your home, if you are in any doubt about your supply contact your local electricity company. The flexible mains lead is supplied connected to a B.S. 1363 fused...