DeLonghi ECAM23210B/SB - Manuals

9 Description of the accessories (page 2 - C ) C1� Measure C2� Cleaning brush C3� Descaler bottle C4� Water softener filter (certain models only) Description of lights Light flashing: the machine is heating up or a rinse cycle is underway� The appliance is delivering two cups of coffee� “Energy Savi...

10 • You should customize water hardness as soon as possible following the instructions in the section “Setting water hardness” on page 17� Follow the instructions: 1� Remove the water tank, fill to the MAX line with fresh water (fig� 1A) then put back in the appliance (fig� 1B)� 2. Place a containe...

12 tens oF thoUsAnDs hUnDReDs thoUsAnDs tens UnIts x1 x3 x7 4 - how many times the water softener filter has been replaced� 5� The quantities are indicated by the flashing beans as follows: Example: you want to know how many cof- fees have been made� Enter the menu and select the light� Count the fl...

13 tips for a hotter coffee For a hotter coffee, before delivery you are re - commended to: • rinse the appliance through by pressing the button� Hot water flows out of the coffee spouts and heats the internal circuit of the machine so that the coffee delivered will be hotter� • warm the cups with h...

14 rature (about 41°F/5°C). To avoid milk with poor froth or large bub- bles, always clean the cappuccino maker as described in the section “Cleaning the cap- puccino maker after use”� 3. Press the button� The light flashes� 4� After a few seconds, the light flashes telling you to turn the steam kno...

16 Infuser support PUSH Important! The infuser may not be extracted when the ma- chine is on� 1� Make sure the machine is correctly turned off (see “Turning the appliance off” on page 10)� 2� Remove the water tank� 3� Open the infuser door (fig� 27) on the right side� 4. Press the two red release bu...

17 Avoid contact with splashes of water� 9. Press the button to confirm introduc- tion of the solution� The light flashes telling you to turn the steam knob� 10� Turn the steam knob to the I position The descaling program starts and the desca- ler liquid comes out of the cappuccino ma- ker� The desc...

18 bubbles to escape (fig� 31)� 5� Insert the filter in the filter housing (fig� 32A) and press as far as it will go� 6� Close the tank with the lid (fig� 32B), then replace the tank in the machine� When you install the filter, you must notify the appliance of its presence� 7. Press the P button to ...

19 eXPlAnAtIon oF lIGhts lIGht PossIBle CAUse ReMeDy Insufficient water in the tank� Fill the tank with water and insert it correctly, pushing it as far as it will go until it clicks into place� The tank is not correctly in place� Insert the tank correctly and press as far as it will go� The grounds...

21 tRoUBleshootInG Below is a list of some of the possible malfunctions� If the problem cannot be resolved as described, contact Customer Service� PRoBleM PossIBle CAUse ReMeDy The coffee is not hot The cups were not preheated� Warm the cups by rinsing them with hot water (Please note you can use th...

22 lIMIteD WARRAnty This warranty applies to all products with De’Longhi or Kenwood brand names. What does the warranty cover? We warrant each appliance to be free from defects in material and workmanship� Our obligation under this warranty is limited to repair at our factory or authorized service c...