DeLonghi DGS 61 ST- Manuals

During use the appliance becomes hot. Care should be taken to avoid touch-ing heating elements inside the oven.Attention: the oven door becomes very hot during operation.Keep children away. 1 2 3 CONTROL PANEL - Controls description 1. Oven/grill gas control knob2. Oven light selector3. 60’ timer. G...

THERMOSTAT KNOB The values from to printed on the facia panel around the thermostatknob (fig. 1.2) show in a growingsequence the oven temperature in °C. CAUTION: If the burner is accidentally extinguished, turn the gas off at the control knob andwait at least 1 minute before attempting to relight. C...

LIGHTING OF OVEN BURNER The thermostatic tap controlling the gas supply to the burner is equipped with a safe-ty device which automatically stops the gas flow in case of flame extinction. The tem-perature is constantly maintained on the set value. The electric ignition starts up by pressing the ther...

LIGHTING OF GAS GRILL BURNER The thermostatic tap controlling the gas supply to the burner is equipped with asafety device which automatically stops the gas flow in case of flame extinction. The electric ignition starts up by pressing the thermostat knob. A safety device prevents the electric igniti...

TRADITIONAL GRILLING Very important: always use with the door ajar and with shield "A” mount-ed (Fig. 1.8). Fit the screen A (Fig. 1.8) which protects the control panel from the heat. Switch the grill on, setting the knob to position . Leave to warm up for approximately 5 minutes with the door a...

Temperature and times given are approximate, as they will vary depending on the qualityand amount of food being cooked.Remember to use ovenproof dishes and to adjust the oven temperature during cookingif necessary. Cooking guide 2 2 10 KNOB SETTING APPROX. TEMPERATURE HEAT OF OVEN TYPE OF DISH TO CO...

Installation, and any demonstration, information or adjustments are not included inthe warranty. This appliance must be installed and serviced only by a suitably qualified and regis-tered person, and in accordance with the current editions of the relevant standardsand regulations or other locally ap...

• Do not grill with oven door closed . Always fit the heat shield supplied with the oven under the front panel before commencing operations. • Do read the user instructions carefully before using the oven for first time. • Do allow the oven to heat for one and a half hours, before using for the firs...

WARNING When correctly installed, your product meets all safety requirements laiddown for this type of product category. However special care should betaken around the rear or the underneath of the appliance as these areasare not designed or intended to be touched and may contain sharp orrough edges...

REPLACING THE OVEN LIGHT BULB Switch the oven off at the mains . When the oven is cool, unscrew and replace the bulb with another one resistant to high temperatures (300°C), voltage 230 V(50 Hz), E14 and same power (check watt power as stamped in the bulb itself) of thereplaced bulb. Note: Oven bulb...

INSIDE OF OVEN The oven should always be cleanedafter use when it has cooled down. The cavity should be cleaned using amild detergent solution and warmwater. Suitable proprietary chemicalcleaners may be used after first con-sulting with the manufacturers recom-mendations and testing a small sampleof...

17 Advice for the installer IMPORTANT – This appliance must be installed and serviced only by a suitably qualified and reg- istered person, and in accordance with the current editions of the relevant stan-dards and regulations or other locally applicable regulations. – The appliance must be installe...

560 5 9 1 594 5 9 4 54 0 20 555 m in . 55 0 WARNINGW h e n c o r re c t l y i n s t a l l e d , y o u rproduct meets all safety require-ments laid down for this type ofproduct category.However special care should bet a k e n a ro u n d t h e re a r o r t h eunderneath of the appliance asthese areas ...

20 Gas installation 5 5 IMPORTANT NOTE This appliance is supplied for use on NATURAL GAS or LPG (check the gas regulationlabel attached on the appliance). ✓ Appliances supplied for use on NATURAL GAS: they are adjusted for this gas onlyand cannot be used on any other gas (LPG) without modification. ...

21 The installation of the gas appliance to Natural Gas or LP Gas must be carried outby a suitably qualified and registered installer. Installers shall take due account of theprovisions of the relevant British Standards Code of Practice, the Gas Safety Regulationsand the Building Standards (Scotland...

22 If installation is to be carried out using a flexible connector (to BS669), then thefollowing points must be adhered to: Note: The gas installation pipes and the final connection to the appliance connecting pipe shall be sufficient size to maintain the heat output of the appliance as specifiedund...

24 TABLE FOR THE CHOICE OF THE INJECTORS BURNERS G 30 - 28-30 mbar G 20 G 31 - 37 mbar 20 mbar OVEN 3,000 0,650 42 83 15 * 125 4 * GRILL 2,300 - - 76 fully open * - 115 4 * Nominal Power [kW] Reduced Power [kW] Ring opening [mm] Ø injector [1/100 mm] By-pass [1/100 mm] Ring opening [mm] Ø injector [...

25 FLAME REGULATION OF THE OVEN AND GRILL BURNERS Using a cross-head screwdriver, slacken the screw securing the air flow regulation col-lar (figs. 5.8 and 5.9) and move the collar forward or backward to increase or reducethe air aperture in accordance with gas type and the indications in the “TABLE...

26 REGULATION OF THE MINIMUM FLAME This needs to be done only for the oven burner (the grill is a fixed capacity) by act-ing on the thermostat. Considering that in the minimum position the flame must have a length of about 4mm and must remain lit even with a brusque passage from the maximum position...

27 Electrical section 6 6 IMPORTANT: Installation must be carried out according to the manufacturer'sinstructions. Incorrect installation may cause harm and damage to people, ani-mals or property, for which the manufacturer accepts no responsibility.Before carrying out any work on the electrical sec...

29 ✓ The power supply cord must not touch against any hot surfaces and must be placedso that its temperature does not exceed 75°C at any point along its length. ✓ After having installed the appliance, the power switch or power plug must alwaysbe in a accessible position. ✓ The appliance must have it...