DeLonghi DEGH60BG - Manuals

DeLonghi DEGH60BG – Manual in PDF format online.

Manuals:

Manual

Manual DeLonghi DEGH60BG

Summary

Page 3 - PRODUCT LABEL; AS/NZS CISPR 14.1 Electromagnetic Compatibility Requirements

3 Dear Customer, Thank you for having purchased and given your preference to our product. The safety precautions and recommendations reported below are for your own safety and that of others. They will also provide a means by which to make full use of the features offered by your appliance. Please k...

Page 4 - IMPORTANT PRECAUTIONS AND RECOMMENDATIONS; After use, ensure that the knobs are in the off position.

4 IMPORTANT PRECAUTIONS AND RECOMMENDATIONS FOR USE OF ELECTRICAL APPLIANCES Use of any electrical appliance implies the necessity to follow a series of fundamental rules. In particular: ■ Never touch the appliance with wet hands or feet. ■ Do not operate the appliance barefooted. ■ The appliance is...

Page 5 - INSTALLATION; This appliance shall be only be serviced by authorized personnel.; ELECTRICAL REQUIREMENTS; withstand the load specified on the plate.

5 INSTALLATION CAUTION: ■ This appliance must be installed in accordance with these installation instruc- tions, local gas fitting regulations, municipal building codes, water supply regu - lations, electrical wiring regulations, - Gas Installations and ony other relevant statutory regulations. ■ Th...

Page 7 - CLEARANCES

7 M o d e l : D E G H 6 0 B G M o d e l : D E G H 7 0 B G M o d e l : D E G H 9 0 B G CLEARANCES Installation clearances and protection of combustible surfaces shall comply with the current local regulations e.g. AS/NZS5601 - Gas Installations code. (1) 54 mm from top of countertop. (2) At least 60 ...

Page 9 - partition; between the base of the hob and the cupboard below; should be fitted 30; surface if the cupboard is to be used for storage.; Overhead clearances; - In no case shall the clearance between the highest part of the; Standards requirement; Temperature of nearby surfaces.; Australian and New Zealand Gas Installation Stan-; mm; Space for; Figure 5

9 The installation shall comply with the dimensions in Figures 3a, 3b or 3c and 4a, 4b or 4c, bearing in mind that: ■ A partition between the base of the hob and the cupboard below should be fitted 30 mm below the workbench surface if the cupboard is to be used for storage. ■ If the hob is installed...

Page 10 - FASTENING THE COOKTOP; Cut the unit according to the dimensions in fig. 3a or 3b.; min; Rear Fixing Brackets

10 FASTENING THE COOKTOP Each cooktop is provided with an installation kit including brackets and screws for fastening the cooktop to benches from 30 to 40mm thick.The kit includes two “ F ” type brackets (for the front of the cooktop), two “ R ” type brackets (for the rear of the cooktop) and four ...

Page 11 - GAS SUPPLY; Do NOT force the ”elbow“ rotation prior to loosening nut.; Gas connection for; Figure 8a

11 GAS SUPPLY ■ This appliance is suitable for use with Natural Gas or ULPG (Check the “gas type” sticker attached to the appliance). ■ For Natural Gas the gas supply must be regulated to obtain a pressure of 1 kPa with the two semi-rapid (SR) burners operating at the maximum. ■ For ULPG models conn...

Page 12 - authorized Delonghi Service Agent.; INSTALLATION WITH A FLEXIBLE HOSE ASSEMBLY; After connection the installer must check that the hose is; Figure 9

12 5. Check the minimum burner setting by quickly rotating the gas control knob from the maximum to the minimum position, the flame must not go out. If adjustment is required carry out the “minimum burner setting adjustment” procedure described below. 6. If satisfactory performance cannot be obtaine...

Page 13 - TABLE FOR THE CHOICE OF THE INJECTORS

13 Natural Gas ULPG Test Point Pressure [kPa] 1.0 2.75 BURNER Injector Orifice Dia. [mm] Gas Consumption [MJ/h] Injector Orifice Dia. [mm] Gas Consumption [MJ/h] Auxiliary (AUX) 0.85 3.60 0.53 3.60 Semi-rapid (SR) 1.12 6.30 0.70 6.30 Rapid (R) 1.45 10.40 0.91 10.80 Triple-ring (TR) (*) 1.60 12.70 0....

Page 14 - IMPORTANT; Only for the models with triple-ring

14 CONVERSION PROCEDURE (to convert to Natural gas or to ULPG) REPLACING THE INJECTORS The conversion procedure must be carried out only by an authorised person. This appliance is suitable for use with Natural gas or Universal LPG (check the “gas type” sticker attached to the appliance). The nominal...

Page 16 - USE and CARE; NOT use or store flammable materials near this appliance.; Do NOT modify this appliance.

16 USE and CARE CAUTION: ■ This appliance must be used only for the task it has explicitly been designed for, that is for domestic cooking of foodstuffs. Any other form of usage is to be considered as inappropriate and therefore dangerous. Do not use this appliance as a space heater. ■ Do NOT place ...

Page 17 - The models have a safety valve system fitted, (probe “; M o d e l : D E G H 7 0 B G

17 GAS BURNERS 1. Auxiliary (AUX) 3.60 MJ/h 2. Semi-rapid (SR) 6.30 MJ/h 3. Rapid (R) 10.40 MJ/h (NG) 10.80 MJ/h (ULPG) 4. Triple ring (TR) 12.70 MJ/h (NG) 11.90 MJ/h (ULPG) CONTROL KNOBS 5. Burner 1 (Auxiliary) 6. Burner 2 (right Semi-rapid) 7. Burner 4 (Triple-ring) 8. Burner 2 (left Semi-rapid) 9...

Page 18 - USING GAS BURNERS; Check that the electricity is switched on to allow spark ignition.

18 USING GAS BURNERS ■ Check that the electricity is switched on to allow spark ignition. ■ Make sure that all controls are turned to zero. ■ The gas flow to the burner is controlled by a tap incorporating a safety cut-off valve. If the burner flame should go out for some reason, the safety valve wi...

Page 19 - Always ensure that you use the correct size of

19 LIGHTING GAS BURNERS FITTED WITH FLAME FAILURE SAFETY DEVICE In order to light the burner, you must: 1. Turn the knob (figs. 13a - 13b) in anti-clockwise direction up to the maximum aperture (symbol ), push in and hold the knob; this will light the gas. If there is no mains electrical supply, bri...

Page 20 - To use the WOK, you must place the wok stand in the; CORRECT; position as shown; MUST BE PLACED ONLY; over the pan-rest for; WRONG

20 CORRECT USE OF TRIPLE-RING BURNER (ONLY FOR THE MODELS DEGH70BG, DEGH90BG) ■ The flat-bottomed pans are to be placed directly onto the pan-support. ■ To use the WOK, you must place the wok stand in the CORRECT position as shown in fig. 15b. IMPORTANT: The special grille for wok pans (fig. 15b) MU...

Page 22 - CLEANING and MAINTENANCE; GENERAL ADVICE; Do not use cleaning products with a chlorine or acidic base.; GLASS SURFACE; which do not contain abrasives or chlorine-based acids.; ENAMELLED PARTS; Dry preferably with a soft cloth.; GAS TAPS

22 CLEANING and MAINTENANCE GENERAL ADVICE ■ Before you begin cleaning you must ensure that the hob is switched off. ■ It is advisable to clean when the appliance is cold and especially when cleaning the enamelled parts. ■ All enamelled surfaces have to be washed with soapy water or some other non-a...

Page 23 - BURNERS AND GRIDS; These parts can be removed and cleaned with appropriate products.; Both the probe and ignition plug must be very carefully cleaned.; IMPORTANT WARNING

23 BURNERS AND GRIDS ■ These parts can be removed and cleaned with appropriate products. ■ After cleaning, the burners and their flame spreaders must be well dried and correctly replaced. ■ It is very important to check that the burner flame spreader and the cap have been correctly positioned. Failu...

Page 24 - flame spreader “; NOT; to fit the triple-ring bur; IS

24 F C Flame failureprobe “ T ” Ignitor “ S ” CORRECT POSITIONING OF THE AUXILIARY, SEMI-RAPID AND RA-PID BURNERS It is very important to check that the burner flame spreader “ F ” and the cap “ C ” have been correctly positioned (see figs. 18 and 19). ■ They shall be level and must not ro-tate. ■ F...

Page 25 - The burner ribs must be fitted in their

25 CORRECT POSITIONING OF THE TRIPLE RING BURNER (ONLY FOR THE MODELS DEGH70BG, DE-GH90BG) The triple ring burner must be correctly po- sitioned (see figs. 21, 22 and 23). ■ The burner ribs must be fitted in their housing as shown by the arrow. ■ The burner correctly positioned must not rotate. ■ Th...

Page 26 - SERVICE AND MAINTENANCE; Burner is reassembled and located correctly.; Servicing the appliance:; LUBRICATION OF THE GAS TAPS

26 SERVICE AND MAINTENANCE If the ignition spark fails to ignite or does not light the gas, check the following items before calling our Customer Service Centre to obtain the nearest Authorised Delonghi Service Agent: ■ Burner is reassembled and located correctly. ■ Spark electrode and white ceramic...