DeLonghi DE 91 MPS - Manuals

Page 2 - PRODUCT LABEL; General Requirements for Domestic electrical appliances

2 Dear Customer, Thank you for having purchased and given your preference to our product. The safety precautions and recommendations reported below are for your own safety and that of others. Theywill also provide a means by which to make full use ofthe features offered by your appliance. Please kee...

Page 4 - IMPORTANT PRECAUTIONS AND RECOMMENDATIONS; WARNING; WARNING: Taking care NOT to lift the oven by the door handle.

4 IMPORTANT PRECAUTIONS AND RECOMMENDATIONS After having unpacked the appliance, check to ensure that it is not damaged.In case of doubt, do not use it and consult your supplier or a professionally qualified technician.Packing elements (i.e. plastic bags, polystyrene foam, nails, packing straps, etc...

Page 5 - INSTALLATION; This appliance shall only be serviced by authorized personnel.; ELECTRICAL REQUIREMENTS; accordance with current regulations.; If the supply cord is damaged it must be replaced by the

5 INSTALLATION CAUTION: ■ This appliance must be installed in accordance with these installationinstructions. ■ This appliance shall only be serviced by authorized personnel. ■ This appliance is to be installed only by an authorised person. ■ Incorrect installation, for which the manufacturer accept...

Page 6 - hooks; FEEDER CABLE SECTION TYPE HO5RR-F; Figure 2

6 REPAIRS REPLACING THE POWER SUPPLY CABLE ■ Unhook the terminal board cover by inserting a screwdriver into the two hooks A (fig. 2). ■ Open the cable gland by unscrewing screw F (fig. 3), unscrew the terminal screws and remove the cable. ■ The new supply cable, of suitable type and section, is con...

Page 7 - ELECTRIC DIAGRAM; Figure 4

7 ELECTRIC DIAGRAM Figure 4 F1 Oven switch TM Oven thermostat TL Thermal overload (N.C.) TL1 Thermal overload (N.O.) PR Electronic programmer LF Oven lamps S1 Thermostat pilot lamp S2 Line pilot lamp C Top element G Grill element S Bottom element CIR Circular element V Fan motor CF Cooling fan motor...

Page 8 - FITTING REQUIREMENTS; Figure 5; Figure 6

8 WARNINGWhen correctly installed,y o u r p ro d u c t m e e t s a l ls a f e t y re q u i re m e n t s l a i ddown for this type of prod-uct category.H o w e v e r s p e c i a l c a re should be taken aroundthe rear or the underneathof the appliance as theseareas are not designed orintended to be t...

Page 9 - Figure 7; FIXING THE OVEN

9 Figure 7 FIXING THE OVEN Introduce the oven into the furniture opening and fix it with 4 screws (not supplied)as figure 7. It is essential that the oven rests on a surface which will support itsweight, as the screw fixing is only complementary. Adjust the hinges of furniture doors adjacent to the ...

Page 10 - Figure 8

10 Figure 8 OVEN DOOR LOWER TRIM AIR FLOW IMPORTANT:To avoid damage to the lower trim please note the following instruc-tions. The lower trim is designed to allow for good air circulation and the correct openingof the oven door. To ensure the trim is not damaged due to the appliance being placed on ...

Page 11 - USING THE OVEN FOR THE FIRST TIME; Operate as follows:; USE and CARE; Figure 9

11 CAUTION: ■ This appliance must be used only for the task it has explicitly been designedfor, that is for domestic cooking of foodstuffs. Any other form of usage is to beconsidered as inappropriate and therefore dangerous. ■ Do NOT place combustible materials or products on this appliance at any t...

Page 12 - GREASE FILTER; mainly when meat is being roasted.

12 ■ Unscrew the fixing screws and slideoff the wire racks and the catalyticliners to the oven wall as in fig. 9. The grill is secured to the rear wallof the oven on a hinge system thatallows it to be lowered to allowproper access when cleaning theoven ceiling (see next chapter TILT-ING GRILL). ■ Le...

Page 13 - Unlocking the tilting grill; TILTING GRILL

13 Figure 12 Figure 14 Figure 13 A 2 1 1 2 A - B A - B B UNLOCKING THE TILTING GRILL LOCKING THE TILTING GRILL Unlocking the tilting grill (fig. 12) 1. Open the hooks A and B . 2. Gently pull down the grill as shown in the figure 14. Locking the tilting grill (fig. 13) 1. Gently lift up the grill. 2...

Page 14 - TELESCOPIC SLIDING SHELF SUPPORTS

14 TELESCOPIC SLIDING SHELF SUPPORTS The telescopic sliding shelf supports make it safer and easier to insert and remove theoven shelf and tray. They stop when they are pulled out to the maximum position. Important! When fitting the sliding shelf supports, make sure that you fit: ■ The slides to the...

Page 15 - To remove the telescopic sliding shelf supports:; sliding shelf support underneath.; Cleaning the sliding shelf supports; – Wipe the supports with a damp cloth and a mild detergent only.

15 To remove the telescopic sliding shelf supports: – Remove the side racks and the catalytic liners by unscrewing the fixing screws (Fig. 16). – Lay down the telescopic sliding shelf support and side racks, with the telescopic sliding shelf support underneath. – Find the safety locks. These are the...

Page 16 - Cooking with multifunction oven

16 Cooking with multifunction oven Figure 18 Clock and Timer with “Touch-control” keys Function selector Thermostat Power on light Temperature light

Page 17 - Heating and cooking in the; a. by normal convection; The heat is produced by the upper and lower heating elements.; b. by forced convection; The food is grilled by the infra red grill element.; e. by radiant heat and ventilation; The food is defrosted by using the fan only function without heat.

17 GENERAL FEATURES With your new Multi-Function oven it is possible to cook a variety of food using the7 different cooking functions.These 7 functions are obtained using a combination of the 4 different heating ele-ments plus a defrost function using the fan only. OPERATING PRINCIPLES Heating and c...

Page 18 - FUNCTION SELECTOR KNOB; OVEN LIGHT; THERMOSTAT KNOB; TRADITIONAL CONVECTION COOKING

18 FUNCTION SELECTOR KNOB (fig. 20) Rotate the knob clockwise to set the oven for one of the following functions. OVEN LIGHT By setting the knob to this position, only the oven lights come on. They ramain on in all the cooking modes. THERMOSTAT KNOB (fig. 19) This only sets the cooking temperature a...

Page 19 - GRILLING; oven door closed; and the thermostat knob to position between 50 °C; UPPER HEATING ELEMENT

19 GRILLING The infrared grill element at the top of the oven and the rotisserie come on. The heat is dispersed by radiation. Use with the oven door closed and the thermostat knob to position between 50 °C and 225°C maximum. For cooking hints, see the chapter “USE OF THE GRILL”.For cooking with the ...

Page 20 - Only the oven fan comes on. Use with the thermostat knob set to “

20 FAN GRILL Both the grill and the fan come on. Most of the cooking is done by grilling and thenthe hot air circulated around the oven. Use with the oven door closed and the ther-mostat knob to position between 50 °C and 225°C maximum.The oven should be preheated for 5 minutes before cooking. For f...

Page 21 - USING THE ROTISSERIE

21 USING THE ROTISSERIE 1. Prepare the rotisserie support (fig. 21). • Place the grill tray on the bench- top. • Insert the supports into the lock studs. • P u s h t h e s u p p o r t s a l l t h e w a y down to lock them in firmly. 2. Secure the meat (fig. 22). Important!Take care, the forks are sh...

Page 22 - USE OF THE GRILL; COOKING ADVICE; GRILLING AND COOKING AU GRATIN; Always grill with the oven door closed.

22 USE OF THE GRILL Preheat the oven for about 5 minutes with the door closed. Introduce the food to be cooked, positioning the rack as close to the grill as possible.The dripping pan should be placed under the rack to catch the cooking juicesand fats. COOKING ADVICE Remember to keep children away f...

Page 23 - ROASTING; SIMULTANEOUS COOKING OF DIFFERENT FOODS; WARMING BREAD

23 ROASTING To obtain classical roasting, it is necessary to remember: • that it is advisable to maintain a temperature between 180 °C and 200 °C. • that the cooking time depends on the quantity and the type of foods. SIMULTANEOUS COOKING OF DIFFERENT FOODS The oven set on position can cook several ...

Page 24 - MODE; Illuminated symbols:; AUTO; AUTO

24 Figure 25 Clock/Timer with “Touch control” keys keys and Touched simultaneously (formore than 2 seconds): • setting the clock; • setting the timer volume(by touching once, alongwith the “ MODE ” key); • to cancel automatic cook-ing at any time. MODE Function selection (touchedfor more than 2 seco...

Page 27 - CLEANING and MAINTENANCE; GENERAL ADVICE; Before you begin cleaning, you must ensure that the appliance is; cleaning the enamelled parts.; Do not use a steam cleaner because the moisture can get into the

27 CLEANING and MAINTENANCE GENERAL ADVICE ■ Before you begin cleaning, you must ensure that the appliance is switched off. ■ It is advisable to clean when the appliance is cold and especially when cleaning the enamelled parts. ■ Avoid leaving alkaline or acidic substances (lemon juice, vinegar, etc...

Page 28 - PAINTED PARTS AND SILKSCREEN PRINTED SURFACES; Clean using an appropriate product. Always dry thoroughly.; IMPORTANT; sion. You are advised to use a soft cloth and neutral soap.; GLASS CONTROL PANEL; Dry preferably with a microfibre or soft cloth.; STAINLESS STEEL SURFACE

28 PAINTED PARTS AND SILKSCREEN PRINTED SURFACES Clean using an appropriate product. Always dry thoroughly. IMPORTANT : these parts must be cleaned very carefully to avoid scratching and abra- sion. You are advised to use a soft cloth and neutral soap. CAUTION: Do not use abrasive substances or non-...

Page 29 - and should be washed regularly in hot soapy water (fig. 11 at page 12).; ADVICE FOR USE AND MAINTENANCE OF CATALYTIC PANELS; INSIDE OF OVEN; The oven should always be cleaned after use when it has cooled down.; Do not store flammable material in the oven.

29 GRILL HEATING ELEMENT ■ The heating element is self-cleaning and does not require maintenance. The grill is secured to the rear wall of the oven on a hinge system that allowsit to be lowered to allow proper access when cleaning the oven ceiling (fig.14at page 13). GREASE FILTER ■ Clean the filter...

Page 30 - REPLACING THE OVEN LAMPS; NOTE

30 REPLACING THE OVEN LAMPS WARNING: Ensure the appliance is switched off before replacing the lampto avoid the possibility of electric shock. ■ Let the oven cavity and the heating elements to cool down; ■ Switch off the electrical supply; ■ Remove the protective cover A (fig. 26); ■ Unscrew and rep...

Page 32 - REMOVING THE DOOR

32 B A C Figure 27 Figure 27a Figure 27b Figure 27c Figure 27d C A B REMOVING THE DOOR The oven door can easily be removedas follows: – Open the door to the full extent (fig. 27a). – Open the lever A completely on the left and right hinges (fig. 27b). – Hold the door as shown in fig. 27. – Gently cl...

Page 33 - REMOVE THE INNER GLASS RETAINER; REMOVING THE INNER PANE OF GLASS

33 2 1 2 1 2 REMOVE THE INNER GLASS RETAINER 1. Remove the oven door and place it on a soft surface. IMPORTANT : The door shall be placed horizontally as per figure 28. 2. Press down on both tabs to release the glass retainer. 3. Remove the glass retainer . REMOVING THE INNER PANE OF GLASS The oven ...

Page 34 - REMOVE THE INNER GLASS PANE; Lift and remove the inner pane slightly, as shown in the figure 29.

34 REMOVE THE INNER GLASS PANE Lift and remove the inner pane slightly, as shown in the figure 29. Figure 29 1 1 2 2 1 2

Page 35 - AFTER CLEANING, REPLACE THE INNER GLASS PANE; When replacing the inner glass pane, make sure that:

35 AFTER CLEANING, REPLACE THE INNER GLASS PANE When replacing the inner glass pane, make sure that: • You replace the pane correctly, as shown. The pane must be in the position described below in order to fit into the door and to ensure that the oven operates safely andcorrectly. • You take extra c...

Page 36 - REPLACE THE GLASS RETAINER; edge of the outer glass. Check that the clamps

36 Figure 31 REPLACE THE GLASS RETAINER 1. Position the glass retainer, as shown in the figure 31. It should sit on the bottom edge of the outer glass. Check that the clamps M are not deformed or damaged. 2. Gently push the glass retainer back into place. You should be able to hear the tabs on both ...

Page 37 - REFIT THE DOOR; place as shown in the figure 33.

37 REFIT THE DOOR 1. Hold the door firmly (fig. 32). 2. Insert the hinge tongues into the slots, making sure that the groove drops into place as shown in the figure 33. 3. Open the door to its full extent. 4. Fully close the levers “ A ” on the left and right hinges, as shown in the figure 34. 5. Cl...