DeLonghi CP 20 ARE 290- Manuals

5 You can also use the “adjustable bar” accessory (T).• Fit the window outlet in the housing in the bar (fig. 4) • Position the bar on the window sill and adjust until it fits in the guides of the blind (the length can be blocked with the pin pro-vided), then lower the blind (fig. 5). • Fit the air ...

6 Keep the air hose as short and free of cur- ves as possible to avoid bottlenecks. Air-conditioning with installation If required, your appliance can be installed semi-permanently (Fig. 8).Proceed as follows:• Drill a 134 mm dia. hole in an outside wall or through a window pane, respecting the heig...

7 PREPARING FOR OPERATION IN WATER MODE Once the appliance has been installed, it is ready for use. However, its efficiency can be enhanced by ope-rating it in the exclusive De’longhi water mode. The water in the tank increases the cooling po-wer of your Pinguino and at the same time redu-ces noise ...

8 ling hole. It holds a maximum of 10 litres. Replace the cap correctly and close the tank, pu- shing it in as far as it will go. The tank hole has a mesh filter to prevent the introduction of foreign matter. If necessary, this filter can be unscrewed and removed for cleaning under running water. • ...

9 DESCRIPTION OF THE CONTROL PANEL WITH ADVANCED LCD DISPLAY 1 Air conditioning symbol2 Dehumidifying symbol3 Heating symbol4 Fan symbol5 SMART symbol6 BOOST symbol7 SLEEP symbol8 Alarm symbol9 Temperature indicator10 “No water” symbol11 Timer symbol12 Speed indicator13 AUTOFAN indicator 14 FAN butt...

11 23 1 2 3 5 4 6 9 11 13 12 16 17 20 21 22 23 24 25 19 18 15 14 10 8 7 nutes before the appliance starts giving out hot air. - In this mode, the fan may operate for short periods, even though the set temperature has already been reached. - In this mode, if the alarm “ hl ” is displayed, empty the i...

13 USING THE REMOTE CONTROL • Point the remote control at the receiver on the appliance. The remote control must be no more than 7 metres away from the ap-pliance (without obstacles between the re-mote control and the receiver). • The remote control must be handled with extreme care. Do not drop it ...

14 BOOST function (fig. 28) Ideal for the summer to cool rooms rapidly. Activate by simply pressing the button. The appliance operates in air conditioning mode at maximum fan speed and maximum power. While this function is selected, it is not possible to set the temperature or change fan speed. When...

15 If you need to disable the timer on or off pro- gramme in advance, press the or but- ton respectively twice. PROGRAMMING THE TIMER The timer can be programmed to start and stop the appliance when required. Programming start up • Press the button. The start-up time and symbol flash on the remote c...

16 SELF-DIAGNOSIS The appliance has a self diagnosis system to identify a number of malfunctions. Error messages are displayed on the appliance display. IF ... IS DISPLAYED, ...WHAT SHOULD I DO? Low Temperature (frost prevention) The appliance is fitted with a frost protection device to avoid excess...

18 Certain models have a silver ion dust filter and an additional electrostatic filter in the grill at the back Silver ion filter This dust filter is treated with silver ions which not just retain dust particles, but also have an efficient antibacterial action. It also greatly redu- ces concentratio...

19 Cleaning of the silver ion filter and of the electrostatic filter (certain models only) To clean the silver ion dust filter, the electrostatic filter must be temporarily removed. To clean the filters, use a vacuum cleaner at me- dium power. The silver ion filter can be washed with lukewarm water....

20 TECHNICAL CHARACTERISTICS: Power supply voltage Maximum absorbed power in air conditioning Refrigerant Cooling capacity Limit conditions R oom temperature for air conditioning 21÷35°C Room temperature for heating 10÷27°C GUARANTEE The terms of the guarantee and technical assi- stance are given in...

21 PROBLEM CAUSE SOLUTION The air conditioner does not come on • there is no current • it is not plugged into the mains • the internal safety device has tripped • wait • plug into the mains • call the Service Centre The air conditioner works for a short time only • there are bends or kinks in the ai...