Crimestopper RS-840 - Manuals

Page 2 - VENDORS

TABLE OF CONTENTS Operation Cautions & Warnings…….……………..….…………………………………….…………………………2 Remote Control Diagrams………...……………………………………………………………………………...…….3 Remote Engine Control…………….…..…………………………………………………………………….……….4-6 Turbo Timer Mode……………………………….……………………………………...………………………………7 Convenience and Saf...

Page 3 - REMOTE CONTROL DIAGRAM; LOCK; “COOLFLASH” BLUE LED FLASHLIGHT; NOTE: REMOTE START BUTTON DELAY

REMOTE CONTROL DIAGRAM #3 #1 #2 #4 LOCK TRUNK ENGINE UNLOCK VEHICLE #2 FLASHLIGHT (AUX.) START/STOP RS-840 SYSTEM The transmitter supplied with the RS-840 system has a total of 6 buttons. The button configuration of the RS-840 is Factory-set and unchangeable. See Page 11 for additional information o...

Page 4 - REMOTE ENGINE CONTROL; REMOTE ENGINE STARTING - SUCCESSFUL START:; IGN; REMOTE ENGINE STARTING - UNSUCCESSFUL START; NO FURTHER ATTEMPTS; TURNING OFF A REMOTE STARTED ENGINE:; RUN TIME RESET

REMOTE ENGINE CONTROL REMOTE ENGINE STARTING - SUCCESSFUL START: 1) Press the remote start button for at least 1 second. 2) Parking lights flash once; return solid, and the Ignition/Accessory circuits turn on. 3) After a few seconds the Starter Motor engages, Parking lights and Accessory circuits wi...

Page 5 - ENTERING YOUR REMOTE STARTED VEHICLE:; now controlling your vehicle.; SOLID; UNLOCK

REMOTE ENGINE CONTROL ENTERING YOUR REMOTE STARTED VEHICLE: 1) With engine running, Remote Unlock system or open door with key. 2) Enter vehicle and be careful not to step on brake pedal! (Remote Start Reset) 3) Turn Ignition to ON/RUN position, then press brake pedal to reset the Remote Starter &am...

Page 6 - INFINITY RUN MODE; INDEFINITELY after the programmed run time elapses; INFINITY RUN MODE – EXITING THE VEHICLE:; then press and release the remote start button a second time.; ENTERING A VEHICLE DURING IDLE-DOWN or INFINITY RUN MODES:; See “Entering Your Remote Started Vehicle” on Last page.; SELECTABLE HOURLY COLD-START MODE – EXITING THE VEHICLE:; the remote start has turned on and doors will unlock.

REMOTE ENGINE CONTROL INFINITY RUN MODE This mode can only be activated when "Idle Down" procedure. The Infinity Run mode allows the vehicle engine to remain running INDEFINITELY after the programmed run time elapses . This mode will allow the vehicle to be left running and unattended withou...

Page 7 - should remain running for the selected number of minutes.

TURBO TIMER MODE (OPTIONAL) The optional Turbo Timer mode allows the CoolStart system to keep a Turbo or Turbo Diesel vehicle running for 1 to 5 minutes [selectively] after you remove the key, exit the vehicle, and lock the doors remotely. This is handy for turbo cool-down without the need for expen...

Page 8 - CONVENIENCE AND SAFETY FEATURES; CAR FINDER ASSIST

CONVENIENCE AND SAFETY FEATURES KEYLESS ENTRY (POWER DOOR LOCK CONTROL, Optional) This system enables you to remotely lock and unlock the vehicle’s doors (if equipped with power locks) via remote control for safety and convenience. Note: This feature may require extra labor and/or parts to install. ...

Page 9 - HOOD OPEN SAFETY (Requires grounding hood pin installation); TRANSMITTER PROGRAMMING; for a 2; turn key off and close hood. See diagram next page.

CONVENIENCE AND SAFETY FEATURES HOOD OPEN SAFETY (Requires grounding hood pin installation) This feature prevents the engine from being remote started when hood is open. Helps eliminates risk of injury to someone working under the hood of the vehicle with a properly working hood pin installed. If Re...

Page 10 - TRANSMITTER PROGRAM DIAGRAM:; WAIT FOR; PRESS

TRANSMITTER PROGRAMMING TRANSMITTER PROGRAM DIAGRAM: IGN OFF WAIT FOR 4 FLASHES PRESS 4X's FLASH 2, 3, or 4 X's (GRAY WIRE GROUNDED) IGN OFF PRESS LOCK BUTTON COMPLETE 10

Page 11 - TROUBLESHOOTING: “BEFORE YOU CALL” SECTION; UNIT WILL NOT ATTEMPT A START (KEYLESS ENTRY FUNCTIONS NORMALLY):

2-VEHICLE OPERATION The RS-840 system can be used for 2 vehicle operation. A single remote can control a second vehicle with an RS-840 or other CoolStart system installed. There are some exceptions. See “Multi-Vehicle Notes” section below. VEHICLE #2 Press lower side buttonfirst, then you have3 seco...

Page 12 - UNIT FLASHES LIGHTS ONCE AND WILL NOT ATTEMPT A START:; ONLINE TECHNICAL SUPPORT

TROUBLESHOOTING: “BEFORE YOU CALL” SECTION UNIT FLASHES LIGHTS ONCE AND WILL NOT ATTEMPT A START: The unit senses a fault at the Brake (Purple wire is active) or the Hood is OPEN (Gray wire grounded). This is a safety feature of the unit. Check installation for faults and make sure hood is closed an...