Crimestopper CS-2012TW1 - Manuals

Crimestopper CS-2012TW1 – Manual in PDF format online.

Manuals:

Manual

Manual Crimestopper CS-2012TW1

Summary

Page 2 - TABLE OF CONTENTS; OPERATION CAUTIONS & WARNINGS; VENDORS

TABLE OF CONTENTS Operation Cautions & Warnings……..………..………………………………………………………….….………2 2-Way LED Paging Remote………………………………………………………….………..….……….…..……..3 1-Way “SideKick” Non-Paging Remote……………….………..………………………………….……..…..……..4 Paging Tones & LEDs……….………………………………………….………..…………………..….….…..…….5 ....

Page 3 - -WAY LED PAGING REMOTE

2-WAY LED PAGING REMOTE PAGER / REMOTE TRANSCEIVER: The hand-held remote transceiver is used to send and receive information from the vehicle. The Control Module transmits confirmation signals from the vehicle to your pager. Your range will vary depending on location, terrain, and local RF noise/int...

Page 5 - FEATURE; BUTTON

PAGING TONES & LEDs CS-2012TW1 PAGING LEDs Orange/Green LED: Red LED: Blue LED: Yellow LED: Doo r Trigger Shock sensor,Trunk pop Remote Start,Ignitio n Lock/Unlock, Hood/Trunk PAGE-BACK: FEATURE BUTTON ACTION BEEPS LED COLOR & FLASH LOCK #1 (Lock) Press & Release 1X, then 1X Orange - 1X ...

Page 6 - OPERATING INSTRUCTIONS - ALARM; Remote Panic Protection

OPERATING INSTRUCTIONS - ALARM Active Arming / Locking: Press and release button #1 (Lock symbol) on the transmitter. The system will arm and confirm with one siren chirp, one light flash, and the LED will begin to flash. Power locks will lock (if equipped). Starter disable circuit will turn on. Aft...

Page 7 - Alarm Triggering

OPERATING INSTRUCTIONS - ALARM Alarm Triggering An intrusion into the vehicle or hard impact to the body will sound the alarm and flash the lights for 1 minute. After 1 minute the trigger cycle will automatically stop and alarm will remain armed to continue protecting the vehicle. If a door is left ...

Page 8 - Valet Mode (Enter manually or using the remote)

OPERATING INSTRUCTIONS - ALARM Remote AUX. Output 2 (Optional) This system contains a second auxiliary output to activate other accessories or devices. To activate the systems’ Second Auxiliary Output, press and hold Button #3 (Trunk Symbol) on the transmitter for more than 2 seconds. This is a mome...

Page 9 - Shock Sensor = 1 Flash; REMOTE ENGINE CONTROL; REMOTE ENGINE STARTING - SUCCESSFUL START; be turned off with remote transmitter.

OPERATING INSTRUCTIONS - ALARM Optional M.A.P. (Mobile Accessories Protection) This system can be programmed to provide Crimestopper’s unique M.A.P. (Mobile Accessories Protection) feature that allows you to prevent unauthorized access of your vehicles Audio, Cellular, Navigation, or Entertainment s...

Page 10 - REMOTE ENGINE STARTING - SUCCESSFUL START DIAGRAM:; time. For hard starting engines, the unit will allow a starter crank; NO FURTHER; TURNING OFF A REMOTE STARTED ENGINE:

REMOTE ENGINE CONTROL REMOTE ENGINE STARTING - SUCCESSFUL START DIAGRAM: REMOTE ENGINE STARTING - UNSUCCESSFUL START In the event that the engine does not start on the first attempt, the system shuts down for a few seconds, then attempts to restart the engine a 2 nd and 3 rd time. For hard starting ...

Page 11 - ENTERING YOUR REMOTE STARTED VEHICLE:; is now controlling your vehicle.; ENTERING A VEHICLE DURING “IDLE-DOWN” or “INFINITY RUN” MODES:; See “ENTERING YOUR REMOTE STARTED VEHICLE” section above.

REMOTE ENGINE CONTROL ENTERING YOUR REMOTE STARTED VEHICLE: 1) With engine running, Remote Unlock/Disarm system (If armed) or open door with key. 2) Enter vehicle and be careful not to step on brake pedal! (Remote Start Reset) 3) Turn Ignition to ON/RUN position, then press brake pedal to reset the ...

Page 12 - INFINITY RUN MODE; This mode allows the vehicle’s engine to remain running; INFINITY RUN MODE – EXITING THE VEHICLE:; FLASH FOR PROGRAMMED; See “ENTERING YOUR REMOTE STARTED VEHICLE” section at top of page 11.

REMOTE ENGINE CONTROL INFINITY RUN MODE This mode allows the vehicle’s engine to remain running INDEFINITELY. This mode can be beneficial to law enforcement vehicles or commercial vehicles that need to remain running unattended for long periods of time. INFINITY RUN MODE – EXITING THE VEHICLE: 1) Fo...

Page 13 - TIMED SELF START MODE; confirmation that the unit is in Timed Self-Start Mode.; PRESS 1X; RESETTING TIMED SELF START MODE

REMOTE ENGINE CONTROL TIMED SELF START MODE This mode allows the vehicle to be programmed to self-start every 4 hours and run for the programmed run time. This can be helpful during extremely cold conditions where engine fluid freeze-up is a concern. THE VEHICLE MUST BE OUTDOORS OR IN A WELL VENILAT...

Page 14 - OPTIONAL TURBO TIMER MODE; OPTIONAL TURBO TIMER MODE:; should remain running for the selected number of minutes.

OPTIONAL TURBO TIMER MODE OPTIONAL TURBO TIMER MODE: IMPORTANT NOTE: This mode requires the use of an extra part called a momentary switch or button that is not included with the kit. Check with your installer about adding this feature. The optional Turbo Timer mode allows the your system to keep yo...

Page 15 - ANTI CARJACK PROTECTION; REMOTE OPERATED CARJACK PROTECTION

ANTI CARJACK PROTECTION REMOTE OPERATED CARJACK PROTECTION This feature provides Active Carjack protection through the remote control. When the Ignition is on (vehicle is running), press and hold the #1 LOCK Button and #3 TRUNK Button for 3 seconds. The parking lights will flash 2 times and the LED ...

Page 16 - TRANSMITTER PROGRAMMING; WAIT FOR

TRANSMITTER PROGRAMMING Note: Remotes Transmitters come pre-programmed from the Factory. When re-learning remotes or adding remotes, ALL your system’s remote codes must be learned at time of programming!! This system allows storage of up to 4 different remote codes in memory. 1. Open hood (ground th...

Page 17 - PAGER REMOTE BATTERY REPLACEMENT

PAGER REMOTE BATTERY REPLACEMENT CS-2012TW1 PAGER (LOW BATTERY WARNING) The CS-2012TW1 Pager LED has a low battery warning system. When the battery voltage is low, the Orange & Green LEDs flash 6 times with any button that is pressed. We recommend replacing the battery for proper operation. To r...

Page 18 - TROUBLESHOOTING: “BEFORE YOU CALL SECTION”; SYSTEM LED FLICKERS WHEN PRESSING REMOTE CONTROL BUTTONS:

TROUBLESHOOTING: “BEFORE YOU CALL SECTION” Before calling your dealer or Crimestopper, read the following for tips that may remedy the problem. RANGE QUESTIONS (2-Way Pager/Remote): Your CS-2012TW1 system uses Am & FM High-Frequency signals to send/receive data between the pager and the vehicle ...

Page 19 - TROUBLESHOOTING cont.; UNIT FLASHES THE LIGHTS ONCE AND WILL NOT ATTEMPT A REMOTE START:

TROUBLESHOOTING cont. UNIT FLASHES THE LIGHTS ONCE AND WILL NOT ATTEMPT A REMOTE START: The system is in Valet mode. Check the systems LED light and if it is on solid Red LED (with doors closed) then the system is in VALET mode. To exit VALET, turn the Ignition on, press and hold valet/programming b...