Page 2 - LOUVERED SIDE PANELS.; and secure panel in place.; ELECTRICAL CONNECTION; wiring conforms to local standards.; connection diagrams for 120V or 240V installations.; INSTALLATION; PARTS AND TOOLS NEEDED:; /16 Wrench or Crescent Wrench; Before installing the cooler, note the following items:; Installation inside attic areas is NOT recommended.; and DO NOT reconnect until installation is complete.
110524-1 2 LOUVERED SIDE PANELS. The louver panels have a locking latch on each top corner to secure it in place. To remove the louvered panel you will need to loosen the latch screws on either side of the panel. Loosen the screws enough to rotate the latch handle, but do not remove completely. Rota...
Page 3 - thermostat electrical box. This cable is not supplied.; ELECTRICAL WIRING DIAGRAMS - STANDARD MODEL 4000RLD4
110524-1 3 Contractor Model 4000CRLD4 Note: This unit comes with the motor, pulley, and thermostat control box installed. The unit is factory wired and for 120V power. The supply power should be adequately protected against overloads and short circuits. Supply Power to Unit 1. A disconnect switch (n...
Page 4 - WATER CONNECTION; Do not connect the water supply to any soft water applications.; OVERFLOW INSTALLATION; pan and the head of the drain nipple.; WATER SUPPLY INSTALLATION; and tightening the nut until water tight.; FLOAT VALVE INSTALLATION (Refer to illustration below); tighten until water tight.; ELECTRICAL WIRING DIAGRAM - CONTRACTOR 4000CRLD4 COOLER
110524-1 4 WATER CONNECTION Note: Do not connect the water supply to any soft water applications. OVERFLOW INSTALLATION 1. Remove nut and place nipple through the hole in the pan with the rubber washer between the pan and the head of the drain nipple. 2. Screw nut onto nipple and draw up tight again...
Page 5 - AMPERAGE DRAW AND BELT TENSION; listed on the specification label on motor.; DO NOT operate cooler with larger amperage draw than; SCALE BUILDUP PREVENTION; end out of the cooler through the overflow pipe.
110524-1 5 AMPERAGE DRAW AND BELT TENSION CAUTION: No attempt should be made to completely install this unit without the aid of an electrician or someone familiar with testing amperage draw. Failure to comply with these instructions may void your warranty. This unit is equipped with an adjustable mo...
Page 6 - OPERATION; THERMOSTAT OPERATION (CONTRACTOR MODEL 4000CRLD4); from Off to Auto to Manual and back to Off.; Manual Operation; The fan speed and pump are set by the user.
110524-1 6 OPERATION NOTES: These coolers may be used without water for ventilation purposes. When outside air is cool (for example, at night) or when humidity is high the water pump can be turned off.To eliminate the delivery of hot air when starting the cooler, start the pump only for the first fe...
Page 7 - Delayed start or finish in ‘Auto’ or ‘Manual’ mode.; In The Event Of A Power Outage; AIR EXHAUST; WINDOW AREA/CFM METHOD; For; TISSUE SUCTION METHOD; Turn your cooler on high cool.
110524-1 7 Time Delay Operation (Timer Mode) Delayed start or finish in ‘Auto’ or ‘Manual’ mode. The ‘Timer’ button is used to set a delay period between 1 and 12 hours in 1 hour increments. If the cooler is operating (in ‘Auto’ or ‘Manual’ modes) when the ‘Timer’ button is pressed, the delay period...
Page 8 - MAINTENANCE
110524-1 8 MAINTENANCE Regular maintenance on your cooler will increase performance and extend the life of your cooler. WARNING: Before accomplishing any maintenance ensure power is turned off and the motor and pump are unplugged. START OF SEASON MAINTENANCE Accomplish these basic steps before the t...
Page 9 - GENERAL SPECIFICATIONS; MODELS; MOTOR SPECIFICATIONS
110524-1 9 GENERAL SPECIFICATIONS MODELS WEIGHT ( lbs) CABINET DIMENSIONS (in.) DUCT OPENING (in.) SHIPPING OPERATING HEIGHT WIDTH DEPTH WIDTH HEIGHT 4000RLD4 4000CRLD4 218 305 30 1/2 41 1/4 41 1/4 17-3/4 17-3/4 MOTOR SPECIFICATIONS MODELS H.P MOTOR PN SPEED VOLTS AMPS WEIGHT (LBS) PUMP MODEL # PUMP...
Page 10 - REPLACEMENT PARTS LIST; Cooler model number
110524-1 10 No. Description 4000 RLD4 4000 CRLD4 1. Top Pan ................................................................................................................................. 220905-005 220905-005 2. Bottom Pan .............................................................................
Page 11 - PARTS DRAWING
Page 12 - LIMITED WARRANTY POLICY; This; Exclusions from this warranty; exclusions may not apply to you.; How to obtain service under this warranty; Withi; Champion Cooler / Essick Air Products
110524-1 12 LIMITED WARRANTY POLICY SALES RECEIPT REQUIRED AS PROOF OF PURCHASE FOR ALL WARRANTY CLAIMS. This warranty is extended only to the original purchaser of this evaporative cooler when the unit is installed and used under normal conditions against defects in workmanship and materials as fol...
