CDA SV470 - Manuals - manualsarea.com

Page 2 - Important

Important This appliance must only be used for the purpose for which it is intended, i.e. domestic cooking. Any other use could be dangerous and may lead to premature failure of the appliance. This appliance is not designed to be used by people (including children) with reduced physical, sensorial o...

Page 5 - The Control Panel and Display

4 The Control Panel and Display Fig.4 A Childlock on B Pyrolytic cleaning programmes C Automatic programme D Booster E Clock display F Temperature//weight of food G Temperature indicator H Oven function display I Shelf support indicator J Timer display K Delayed programme set L Cooking time set A B ...

Page 6 - General Settings and Use

General Settings and Use ClockTo set the clock when the time is flashing (for example, when the oven is first switched on) touch or until the correct time shows on the display, then touch to confirm the selection. The oven will beep twice to confirm the selection and the clock will stop flashing.To ...

Page 9 - Always grill with the oven door closed.

8 General Settings and Use 8. Fan Assisted Oven – preset 175˚ (range available 75-220˚) Recommended shelf level 1 or 2 Using the fan to circulate the heat produced by the top and bottom heating elements, this function circulates the heat around the oven to give an even temperature throughout.This fu...

Page 10 - Auto Cook Programmes

9 Auto Cook Programmes This oven has 15 preset automatic cooking programmes which specify cooking time and mode based on the food type and weight. The programmes are listed below along with detailed programme information and recommendations. Touch Touch to activate the auto cook selection. P01 will ...

Page 12 - Pyrolysis Programmes; Amount of residue

11 Pyrolysis Programmes This oven can clean itself by a process known as pyrolysis, heating the cavity to a temperature of 420˚C. This will burn off the residue from spattering and spillages caused by cooking. Pyrolytic programmes should be used when the oven smokes during preheating or cooking or i...

Page 13 - Cleaning and Maintenance

Cleaning and Maintenance IMPORTANT:Always disconnect the appliance from the power supply before undertaking any cleaning or maintenance.You should always allow the oven to cool fully after use before undertaking any cleaning or maintenance. You should only use non-abrasive cleaners. Any abrasive cle...

Page 14 - Care and Maintenance

Care and Maintenance Cleaning the interior of the doorOpen the door completely and insert two of the red stoppers supplied with the oven, as shown in figure 7. Then insert the other two red stoppers in the A slots, as shown in figure 8. Lever the stoppers to lift the frame and the glass from the doo...

Page 15 - CLAC

Care and Maintenance Clean the panes of glass using a soft sponge and washing up liquid.Do not soak the glass in water.Do note use abrasive cleaning products, metallic scrapers or scouring sponges. These could scuff the surface and cause the glass to shatter. Rinse with clean water and dry off with ...

Page 16 - Troubleshooting; Problem

Troubleshooting If the oven is not functioning correctly, check the advice below prior to calling CDA Customer Care. The oven display will show error codes if there is a fault with the appliance. These are detailed below. Before calling CDA Customer Care, take note of the error code as this will hel...

Page 17 - Installation; How to install your oven; Dimensions

Installation Important If the oven is being installed into a built under oven housing unit ensure that the front rail at the top of the unit is not installed as it could restrict ventilation. Ensure that air can flow freely around the housing area. If the oven is being installed into a fully enclose...

Page 18 - Mains Electricity Connection; Warning! This appliance must be earthed; N L

Mains Electricity Connection Warning! This appliance must be earthed We recommend that the appliance is connected by a qualified electrician, who is a member of the N.I.C.E.I.C. and who will comply with the I.E.E. and local regulations. This appliance is intended to be connected to fixed wiring and ...

Page 20 - Passionate about style; To contact our Customer Care Department, or for Service,

Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : [email protected] W : www.cda.eu Passionate about style To contact our Customer Care Department, or for Service, please contact us on the details below.