CDA SC309 - Manuals

✓ The power supply cord must not touch against any hot surfaces and must be placedso that its temperature does not exceed 75°C at any point along its length. ✓ After having installed the appliance, the power switch or power plug must always bein a accessible position. ✓ The appliance must have its o...

Gas supply requirements IMPORTANT NOTE This appliance is supplied for use on NATURAL GAS or LPG (check the gas regulation label attached on the appliance). 4 Appliances supplied for use on NATURAL GAS: they are adjusted for this gas only and cannot be used on any other gas (LPG) without modification...

CDA are not legally able to provide any assistance in the installation of gas appliancesexcept to Corgi registered installers. Any Corgi registered fitter requiring help must pro-vide name, address and registration number.Information supplied will be validated before help is provided. If installatio...

How to install your oven Ensure that air can flow freely around the housing area. If the oven is being installed into a fully enclosed built under oven housing unit it maybe necessary to cut a small slot in the top of the plinth fitted under the unit.Cut a section 400 mm wide and a minimum of 15 mm ...

Gas conversion (to L.P.G. or Natural gas) This appliance is regulated to work withthe gas indicated in the gas regulationlabel. If it has to work with another type ofgas (L.P.G. or Natural gas), before thea p p l i a n c e i s c o n n e c t e d y o u m u s ts u b s t i t u t e t h e o v e n a n d g ...

TABLE FOR THE INJECTORS BURNERS G 30 - 28-30 mbar G 20 G 31 - 37 mbar 20 mbar OVEN 3,000 0,650 42 83 15 * 125 4 * GRILL 2,300 - - 76 fully open * - 115 4 * Nominal Power [kW] Reduced Power [kW] Ring opening [mm] Ø injector [1/100 mm] By-pass [1/100 mm] Ring opening [mm] Ø injector [1/100 mm] By-pass...

Using a cross-head screwdriver, slacken the screw securing the air flow regulation col-lar (figs. 10 and 11) and move the collar forward or backward to increase or reducethe air aperture in accordance with gas type and the indications in the “ TABLE FOR THE INJECTORS ”. Light the burner and check th...

REGULATION OF THE MINIMUM FLAME This needs to be done only for the oven burner (the grill is a fixed capacity) by actingon the thermostat. Considering that in the minimum position the flame must have a length of about 4mm and must remain lit even with a brusque passage from the maximum position toth...

Locate the wire side frames as indicated in Fig. 13.Slide in, on the guides, the shelf and the tray etc. (Fig. 14). The rack must be fitted so that the safety catch, which stops it sliding out, faces theinside of the oven (Fig. 14). Before using the oven for the first time, we recommend that you cle...

1 2 3 How to use your gas oven/gas grill Figure 15 CONTROL PANEL - Controls description 1. Oven/grill gas control knob2. Oven light selector3. 60’ timer. GENERAL FEATURES The oven is furnished completely clean. It is advisable, however, upon first use, to turnthe oven on to the maximum temperature t...

Figure 16 THERMOSTAT KNOB The values from to print- ed on the facia panel around the ther-mostat knob (fig. 16) show in a growingsequence the oven temperature in °C. CAUTION: If the burner is accidentally extinguished, turn the gas off at the control knob andwait at least 1 minute before attempting ...

LIGHTING OF OVEN BURNER The thermostatic tap controlling the gas supply to the burner is equipped with a safetydevice which automatically stops the gas flow in case of flame extinction. The tempera-ture is constantly maintained on the set value. The electric ignition starts up by pressing the thermo...

LIGHTING OF GAS GRILL BURNER The thermostatic tap controlling the gas supply to the burner is equipped with a safetydevice which automatically stops the gas flow in case of flame extinction. The electric ignition starts up by pressing the thermostat knob. A safety device prevents the electric igniti...

TRADITIONAL GRILLING Very important: always use with the door ajar ( Fig. 22 ) . Switch the grill on, setting the knob to position . Leave to warm up for approximately 5 minutes with the door ajar. Place the food inside positioning the rack as near as possible to the grill. Insert the drip pan under...

Cooking guide Your gas oven is a newly designed oven which incorporates an indirect burner locatedunder the oven base plate. If you have previously been used to cooking with gas you may need to slightly alteryour cooking methods. The bottom of the oven is hot and is ideal for browning theunderside o...

Temperature recipe guide MARK APPROX. HEAT OF TYPE OF DISH TO COOK TEMP. OVEN 1/2 125°C Very cool Meringue cakes, 257°F oven slow cooking items 1 140°C Cool Milk puddings, very rich fruit 275°F oven cakes, i.e., Christmas 2 150°C Cool or Stews, casseroles, braising, 300°F slow oven rich fruit cakes,...

Cleaning and Maintenance OVEN DOOR T h e i n s i d e w i n d o w c a n b e e a s i l yremoved fol cleaning by unscrewingthe two fixing screws (Fig. 24). Attention : When cleaning the oven do not take off the rubber door pack-ing and do not over tighten the fixingscrews when refitting. GENERAL CLEANI...

ENAMELLED PARTS All the enamelled parts must be cleaned with a sponge and soapy water only or othernon-abrasive products. STAINLESS STEEL, PAINTED AND ALUMINIUM PARTSSILK-SCREEN PRINTED SURFACES Clean using an appropriate neutral product.Always dry thoroughly. IMPORTANT: these parts must be cleaned ...

If you have a problem with your oven Check the following points: 1. The power is switched on (is there a power cut?). 2. That the controls are switched on. 3. The fuse in the plug and main fuse. 4. If all the above are correct - please call CDA. IF YOU HAVE A PROBLEM WITH YOUR OVEN Oven light not wo...

Appliance servicing CDA provide a quality and effective after-sales service to cover all yourservicing needs. Please attach your receipt to this page for safekeeping. Please help us to help you by having the following information availablewhen booking a service-call: 1. Model type, make and model – ...

Guarantee CDA appliances carry a five-year parts and a one-year labour guarantee. CDA will repair or replace any defect or part attributable to faulty material or workman-ship. Within the first year this will be free of both labour and parts charges. After thefirst year and within five years, the pa...

1103084 ß3 Gas ovens Descriptions and illustrations in this booklet are given as simply indicative. The manufacturer reserves the right, considering the characteristics of the models described here, atany time and without notice, to make eventual necessary modifications for their construction or for...