CDA RV 701 SS - Manuals

5 Clock and Timer with “Touch-Control” Keys (Bottom Main Oven only) Keys:+ and – Touched simultaneously (for more than 2 seconds): • setting the clock; • setting the timer volume (by touching once, along with the “ MODE ” key); • to cancel automatic cooking at any time. MODE Function selection (touc...

7 Automatic Cooking Use automatic cooking to automatically turn the oven on, cook, and then turn the oven off.1. Check the clock shows the correct time.2. Select the function and temperature (function and temperature knobs). The oven will come on.3. Decide how long the food will take to cook, allowi...

8 How to Use the Hob Burners Hob Burners Each hob burner is controlled by a separate gas valve operated by a control knob (fig. 4) which has 3 positions marked on the control panel, these are: – Symbol : Tap closed (burner off) – Symbol : High (maximum) – Symbol : Low (minimum) Push in and turn the ...

9 Choice of Burner The burner must be choosen according to the diameter of the pans and energy required. Saucepans with handles which are excessively heavy, in relationship to the weight of the pan, are safer as they are less likely to tip. Pans which are positioned centrally on burners are more sta...

10 How to Use the Fan Oven (Bottom Main Oven) General Features Fan cooking is more economical and quicker than cooking in a conventional oven.The moving hot air surrounds the food and penetrates it more quickly than in a conventional oven.The oven is equipped with a circular element (2200 W) and a f...

11 Switch and the Temperature Selector Rotate the knob clockwise to set the oven for one of the following functions: Off as per fig. 9 Only the oven fan is on. The fan operates without the heating element, this function can be used for defrosting. 50 to 250 The oven light is switched on. The oven te...

12 Cooking Advice Sterilization Sterilization of foods to be conserved, in full and hermetically sealed jars, is done in the following way:a - Set the selector knob to position 185 °C and preheat the oven.b - Fill the dripping pan with hot water.c - Set the jars onto the dripping pan making sure the...

13 How to Use the Convection Oven (Top Oven) General Features The convection oven is equipped with 3 electrical heating elements:– 2 elements (upper and lower) for normal oven cooking– 1 grill element, on the top of the oven, for grilling which must be done with the oven door closed. The input of th...

15 Lower Heating element In this position only the lower element is switched on. Heat is distributed by natural convection. The thermostat can be set between 50 and 150°C; higher temperatures are not available. Recommended for: This mode is particularly suitable to complete cooking of dishes that re...

16 Do’s and do not’s – Do always grill with the oven door closed.– Do read the user instructions carefully before using the cooker for first time.– Do allow the oven to heat for one and a half hours, before using for the first time, in order to expel any smell from the new oven insulation, without t...

17 For Your Safety – The product should only be used for its intended purpose which is for the cooking of domestic foodstuffs. – Under no circumstances should any external covers be removed for servicing or maintenance except by suitably qualified personnel. – Attention: The appliance gets very hot,...

18 Care and Maintenance Important: As a safety measure, before you start cleaning the cooker be sure to disconnect it from the mains supply. - Do not use cleaning products with a chlorine or acidic base.- Do not use a steam cleaner because the moisture can get into the appliance thus make it unsafe....

19 Stainless Steel, Aluminium, Painted Parts and Silk-screen Printed Surfaces Clean using an appropriate product. Always dry thoroughly.Stainless steel surfaces: can be cleaned with an appropriate stainless steel cleaner. IMPORTANT : these parts must be cleaned very carefully to avoid scratching and...

20 F C Fig. 13 Fig. 12 Burners and Grids – These parts can be removed and cleaned with appropriate products.– After cleaning, the burners and their flame spreaders must be well dried and correctly replaced. – It is very important to check that the burner flame spreader and the cap have been correctl...

21 Correct Position of Triple Ring Burner The triple ring burner must be correctly positioned (see fig. 14); the burner ribs must be fitted in their housing as shown by the arrow.The burner correctly positioned must not rotate (fig. 15).Then position the cap “ A “ and the ring “ B “ (figs. 15 - 16) ...

22 Assembling and Dismantling of the Side Runner Frames – Assemble the wire racks to the oven walls using the 2 screws (Figs. 17a - 17b).– Slide the tray and rack into the runners (Figs. 18a - 18b). The rack must be fitted so that the safety catch, which stops it sliding out, faces the inside of the...

23 Inside of Oven The oven should always be cleaned after use when it has cooled down. The cavity should be cleaned using a mild detergent solution and warm water. Suitable proprietary chemical cleaners may be used after first consulting with the manufacturers recommendations and testing a small sam...

24 Top Oven Door Removing the Oven Door The oven door can easily be removed as follows:– Open the door to the full extent (fig. 20a).– Open the lever A completely on the left and right hinges (fig. 20b). – Hold the door as shown in fig. 20.– Gently close the door (fig. 20c) until left and right hing...

26 Replacing the Inner Pane of Glass 1. Make sure the door is locked open (see figs. 21, 22, 23). 2. Replace the inner pane: – Check that the four rubber pads are in place ( D in Fig. 25). – Check that you are holding the pane the correct way. You should be able to read the wording on it as it faces...

27 Bottom Oven Door Note: The oven door should only be removed by an authorised service agent.Removal of the oven door by a non-authorised person will invalidate the guarantee. Removing the Inner Pane of Glass When removing and replacing the inner glass, the door should be held still by one person (...

30 If the cooker is installed adjacent to furniture which is higher than the gas hob cooktop, a gap of at least 200 mm must be left between the side of the cooker and the furniture.Curtains must not be fitted immediatly behind appliance or within 500 mm of the sides.It is essential that the cooker i...

31 Before installing the cooker level the appliance by screwing or unscrewing the four adjustable feet fitted below. WARNING! For safety reasons unscrew the feet (from screwed position) to the maximum extent of 5 mm (fig. 35). Backguard – Remove the two spacers “ A ” and the screw “ B ” from the rea...

32 Warning To move the cooker always ensure two people carry out this manoeuvre to prevent damage to the appliance (fig. 37). Warning Be carefull: do not lift the cooker by the door handle (fig. 38). Warning When moving cooker to its final position DO NOT DRAG (fig. 39). Lift feet clear of floor (fi...

33 Provision for Ventilation – The appliance should be installed into a room or space with an air supply in accordance with BS 5440-2: 2000. – For rooms with a volume of less than 5m 3 - permanent ventilation of 100cm 2 free area will be required. – For rooms with a volume of between 5m 3 and 10m 3 ...

34 Gas Installation Important Note This appliance is supplied for use on NATURAL GAS or LPG (check the gas regulation label attached on the appliance).– Appliances supplied for use on NATURAL GAS: they are adjusted for this gas only and cannot be used on any other gas (LPG) without modification. The...

35 Gas Connection The installation of the gas appliance to Natural Gas or LP Gas must be carried out by a suitably qualified and registered installer. Installers shall take due account of the provisions of the relevant British Standards Code of Practice, the Gas Safety Regulations and the Building S...

37 Conversion to Natural Gas or to LPG Injectors Replacement of Top Burners Every cooker is provided with a set of injectors for the various types of gas.Injectors not supplied can be obtained from the After-Sales Service.Select the injectors to be replaced according to the table at page 38.The nozz...

38 Table for the Choice of the Injectors Cat: II 2H3+ Burners Nominal Power kW Reduced Power kW G30 - 28-30 mbar G31 - 37 mbar G20 - 20 mbar Ø Injector 1/100 mm Ø Injector 1/100 mm Auxiliary (A) 1,00 0,30 50 72 (X) Semi-Rapid (SR) 1,75 0,45 65 97 (Z) Rapid (R) 3,00 0,75 85 115 (Y) Triple Ring (TR) 3...

39 Electrical Installation WARNING! Electricity can be extremely dangerous.This appliance must be earthed. The appliance must be connected to the electrical network verifying above all that the voltage corresponds to the value indicated on the specifications plate and that the cables section of the ...

40 Connection to Fixed Wiring A double pole switch must be provided no further than 2 metres from the appliance to the electrical supply.The appliance should be connected to a DOUBLE POLE SWITCHED FUSED SPUR OUTLET, similar to that shown in Fig. 47. We recommend that the appliance is connected by a ...

41 Appliance Servicing CDA provide a quality and effective after-sales service to cover all your servicing needs. Please attach your receipt to this page for safekeeping.Please help us to help you by having the following information available when booking a service-call:1. Model type, make and model...

42 Guarantee CDA appliances carry a five-year parts and a one-year labour guarantee. CDA will repair or replace any defect or part attributable to faulty material or workmanship. Within the first year this will be free of both labour and parts charges. After the first year and within five years, the...

Customer Car e Department • The G r oup Ltd. • Harby Road • Langar • Nottinghamshi r e • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : [email protected] W : www.cda.eu To contact our Customer Care Department, or for Service, please contact us on the details below. Cod. 1103507 - ß2