CDA HCG500 - Manuals - manualsarea.com

Page 2 - Important

Important The CDA Group Ltd cannot be held responsible for injuries or losses caused by incorrect use or installation of this product. Please note that CDA reserve the right to invalidate the guarantee supplied with this product following incorrect installation or misuse of the appliance or use in a...

Page 3 - Using your hob

Using your hob Fig.1 2 3 1 4 5 6 7 8 Gas burners:1. Rapid burner 3.0kW 2. Left Semi-Rapid burner 1.75kW3. Right Semi-Rapid burner 1.75kW4. Auxiliary burner 1.0kW Control panel:5. Right Semi-Rapid burner control knob6. Left Semi-Rapid burner control knob7. Rapid burner control knob8. Auxiliary burner...

Page 4 - Igniting the Burners; Efficient use of your Hob

Igniting the Burners To ignite the burners, follow these instructions: 1. Lightly press the control knob (shown on the right) and turn the knob anti- clockwise to the maximum position. Press and hold the control down to begin the ignition process (a clicking sound will be heard). 2. Once the burner ...

Page 5 - If your Hob is not working; Contact CDA Customer Care; Care and Maintenance

Total rated gas input : 7.5kWMains electrical voltage: 230 – 240VacTotal rated electrical consumption: <1W If your Hob is not working 1. Check that the mains supply has not been switched off. 2. Check that the fuse in the spur has not blown.3. Ensure that the burner components are not excessively...

Page 6 - Mains Electricity Connection

DOUBLE POLE SWITCHED FUSE SPUR OUTLET USE A 3 AMP FUSE Mains Electricity Connection THIS APPLIANCE MUST BE CONNECTED TO THE MAINS SUPPLY BY A COMPETENT PERSON, USING FIXED WIRING VIA A DOUBLE POLE SWITCHED FUSE SPUR OUTLET AND PROTECTED BY A 3A FUSE. We recommend that the appliance is connected by a...

Page 7 - Gas Supply Requirements

Room Volume (m 3 ) 5 6 to 10 6 to 11 11 or more Air Vent Required (cm 3 ) 100 50 No permanent vent required if a door opens to the outside None required Gas Supply Requirements IMPORTANT: THIS APPLIANCE SHOULD BE FITTED BY A GAS SAFE REGISTERED FITTER OR OTHER SUITABLY QUALIFIED PERSON. • This insta...

Page 8 - Natural Gas to LPG Conversion; LPG to Natural Gas Conversion

Natural Gas to LPG Conversion This hob can be converted from natural gas to propane operation at a nominal inlet pressure of 37mbar, or butane operation at a nominal inlet pressure of 28/30mbar. This conversion must only be carried out by a competent person (i.e. a Gas Safe registered fitter). Instr...

Page 9 - Fitting the Hob

Fitting the Hob Unpacking the hob:Take care not to lose or mishandle any parts. Fitting position of the hob:This appliance must be installed a minimum of 50mm from any back wall and a minimum of 185mm away from any adjacent vertical surfaces, e.g. a tall cupboard end panel. This may be reduced to 10...

Page 12 - Passionate about style; To contact our Customer Care Department, or for Service,

Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : [email protected] W : www.cda.eu Passionate about style To contact our Customer Care Department, or for Service, please contact us on the details below.