CDA CVC10SS - Manuals - manualsarea.com

Page 2 - Important; Appliance information:; CE Declarations of Conformity:

Important The CDA Group Ltd cannot be held responsible for injuries or losses caused by incorrect use or installation of this product. Please note that CDA reserve the right to invalidate the guarantee supplied with this product following incorrect installation or misuse of the appliance. Under no c...

Page 3 - Coffee machine; Control panel

Coffee machine 1 - Display 2 - Control panel 3 - Dispenser spout 4 - Steam nozzle 5 - Drip tray drawer Control panel 1. Power Button – Press to turn the machine on and off. (Standby) 2. Number Cups – Press to select between 1 and 2 cups. 3. Coffee Size Button – Press to select between short, medium ...

Page 4 - First use; The water tank; The coffee container

First use This coffee machine has two water heaters, one for the water and one for the coffee, which allows for ideal temperatures for coffee and steam for cappuccino. The steam can also be used to preheat the cups. This coffee machine can grind coffee beans when they are needed, ensuring they are f...

Page 5 - To fill the coffee container:; Setting/Adjusting the grind

To fill the coffee container: 1. Pull the machine out of its housing by lifting the handle of the machine and pulling it towards you. 2. Remove the lid of the coffee container and fill it until the coffee beans are 2cm from the top level. Then replace the lid. 3. Push the machine back into the housi...

Page 6 - The Coffee Machine; Making espresso coffee; Select the number of coffee cups; Dispensing steam

The Coffee Machine Press to switch on the coffee machineAfter a few seconds, GOOD MORNING will show on the display.The machine will heat up, and COFFEE and STEAM will flash on the display. Once the machine is ready for use, COFFEE and STEAM will illuminate constantly, as will the size and number of ...

Page 7 - Make a cappuccino

5. Make a cappuccino We recommend preparing cappuccinos individually so as to ensure best flavour. 1. Make a medium espresso as described above in a large cup.2. Press to select steam and wait until STEAM stops flashing.3. Before putting the container under the steam nozzle, press and hold for appro...

Page 8 - Programming; Programming options are:

Programming The coffee machine is equipped with a programming mode to enable you to set the following as required: To enter programming mode follow the steps below: 1 Whilst the machine is off, press and hold until PROGRAMMING shows on the display 2. Press or until the required programme shows on th...

Page 10 - Care and Maintenance

9 Care and Maintenance DescalingIf the display shows DESCALING then the coffee machine needs to be descaled to ensure best performance. Please note:You should use cleaning products that are appropriate for use with coffee machines.Do not use lemon-based products to descale the coffee machine as thes...

Page 11 - Troubleshooting

10 Troubleshooting The coffee machine is equipped with an auto-diagnostic system to recognise and advise on how to deal with faults. These alerts will show on the display. The coffee machine does not switch on. The machine is not fully back in its housing. Push the coffee machine back fully. There i...

Page 12 - Installation

11     fig. 1 fig. 2 fig. 3 Installation IMPORTANT: THIS APPLIANCE SHOULD BE FITTED BY SUITABLY QUALIFIED PERSON. 1. Slide the base unit into the housing ensuring the dimensions are correct as per figure 1. 2. Fix the base unit in place by attaching the 10 screws in to the holes as shown in figure 2...

Page 14 - Electrical information; How to connect an alternative plug

13 Electrical information Warning! This appliance must be earthed. The mains lead of this appliance has been fitted with a BS 1363A 13 amp fused plug. To change a fuse in this type of plug, follow the steps below: 1. Remove the fuse cover and fuse. 2. Fit replacement 13A fuse, ASTA approved to BS 13...

Page 16 - Passionate about style; To contact our Customer Care Department, or for Service,

Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : [email protected] W : www.cda.eu Passionate about style To contact our Customer Care Department, or for Service, please contact us on the details below.