Blomberg DWS 54100 SS - Manuals

Blomberg DWS 54100 SS – Manual in PDF format online.

Manuals:

Manual

Manual Blomberg DWS 54100 SS

Summary

Page 4 - INTRODUCTION; WARNING; When installing the dishwasher, follow; performed by a qualified installer.; INSTRUCTIONS

1 USA INTRODUCTION Please read this installation manual and particularly the safety instructions completely and carefully. They will save you time and effort and help to ensure optimum dishwasher performance. Be sure to observe all listed warnings and cautions. Look particularly for the icons with e...

Page 5 - damage. Consult a qualified electrician if; INSPECT THE DISHWASHER

2 USA • Dishwasher must be secured to adjacent cabinetry using the brackets provided. Failure to do this may cause damage to property or bodily injury. • Connect to a properly rated, protected and sized power supply circuit to avoid electrical overload. The dishwasher is designed for an electrical s...

Page 6 - TOOLS WHICH MAY BE NEEDED; (Additional materials may be required to comply with local codes)

3 USA 2. TOOLS WHICH MAY BE NEEDED 3. MATERIALS WHICH MAY BE NEEDED (Additional materials may be required to comply with local codes) Hot Water Supply Line - Minimum 3/8” O.D. copper tubing or metal braided dishwasher supply line. UL listed conduit connector or strain relief. Teflon tape or other pi...

Page 7 - MATERIALS SUPPLIED; DISHWASHER PARTS BAG 1

4 USA 4. MATERIALS SUPPLIED 4.1 PARTS SUPPLIED Parts for your dishwasher will come in several plastic bags. Check your parts bags shown to make sure you have all the parts as listed to the left. 4.2 MANUAL BAG The dishwasher comes with a manual bag containing: • User manual, • Installation manual an...

Page 8 - DISHWASHER SPECIFICATIONS; place settings

5 USA 5. DISHWASHER SPECIFICATIONS 5.1 TECHNICAL FEATURES Load capacity 8 place settings Permissible water pressure 4.35 - 145 psi (0.3 - 10 bars) Electrical connection 120 V (volts), 12 A (amps), 60 Hz (hertz) Total power 1400 W (watts) Heater power 1240 W (watts) Notice : Because we continually st...

Page 9 - ENCLOSURE PREPARATION; PREPARATION FOR INSTALLING MOUNTING BRACKETS; Dishwasher must be secured to adjacent

6 USA 6. ENCLOSURE PREPARATION 6.1 ELECTRICAL PREPARATION WARNING The dishwasher is designed for an electrical supply of 120 V, 60 Hz, AC, connected to a dishwasher-dedicated, properly grounded electrical circuit with a fuse or breaker rated for 15 amperes. 6.2 PREPARATION FOR INSTALLING MOUNTING BR...

Page 10 - If the height of the enclosure is 337/16” to

7 USA 6.3.1 INSTALLING THE FOOT SUPPORTS Supplied ( 4 ) If the height of the enclosure is 337/16” to 341/4” (850mm - 870mm) use short supports as shown in the figure. Supplied ( 4 ) If the height of the enclosure is above 341/4” (870mm) use long supports as shown in the figure.

Page 12 - persons could be dangerous and may void the warranty.; CAUTION; Do not over tighten the 90° elbow. Doing so; fitting. Apply Teflon tape or other pipe sealant

9 USA 6.4 PREPARING THE WATER CONNECTION (A) Install an easily accessible shut-off valve (not supplied) in the water supply line. All solder connections must be made before the water line is connected to the dishwasher’s water inlet valve. Water can also be supplied to the dishwasher by using a flex...

Page 13 - DRAIN PREPARATION; process is negatively influenced.

10 USA 6.5 DRAIN PREPARATION The dishwasher drain hose may be connected to the drain plumbing in one of three ways (Figure A , B , C ). Notice : • Either one of the above methods must be used or the dishwasher will not operate properly. • A hose that attaches to a sink spray can burst if it is insta...

Page 14 - STEAM PROTECTION FOIL; Failure to install the steam

11 USA 6.7 STEAM PROTECTION FOIL Steam will form inside the dishwasher during operation. At the end of the cycle, when the dishwasher door is opened, it is required to use a steam protection foil to prevent any steam from collecting on the underside of the counter top. 6.6.2 FITTING THE PROTECTION F...

Page 15 - PLACEMENT OF DISHWASHER INTO THE OPENING; CONNECTIONS

12 USA 7. PLACEMENT OF DISHWASHER INTO THE OPENING Now place the dishwasher into the opening and get ready to connect all hoses and electrical connections. CAUTION Make sure all hoses are pulled through the side opening of the cabinet, no hoses are kinked and all slack is taken out as shown in the a...

Page 16 - With metal braided hose.; ELECTRICAL CONNECTION; damage. Consult a qualified electrician if in doubt.; qualified electrician.

13 USA 7.1.2 WATER SUPPLY CONNECTION Water supply may be connected to the dishwasher in one of two ways: • With metal braided hose. • With copper tubing. 7.1.3 BRAIDED HOSE/COPPER TUBING After connections are made turn on the water supply to check for leaks. CAUTION • Hot water supply line: Use mini...

Page 17 - READJUSTING FOOT LEVELS; ADJUSTING THE MOVABLE TOE KICK; note; you should keep the total

14 USA 7.3 READJUSTING FOOT LEVELS Now that the dishwasher is in the cabinet you must readjust the feet to bring the dishwasher up to the required height and attach it underneath the countertop. 1. Readjust the front foot levels with adjusting wrench to balance the dishwasher and raise it up under t...

Page 19 - INSTALLING THE OUTER DOOR

16 USA 7.5 INSTALLING THE OUTER DOOR (DWS 54100 FBI) Measure the height and width of the enclosure (Figure A ) and the toe kick. Determine how big the wooden door can be. For example if the height is 337/8” (860mm) and if the toe kick is 315/16” (100mm) the door can not be taller than 2915/16” (760m...

Page 22 - ADJUSTING DOOR TENSION WITH CUSTOM WOODEN DOOR

19 USA 11. Check whether the bottom of the door hits the toe kick of the kitchen cabinet ( A ). 11.1. If the door hits the toe kick cut the necessary section out of the toe kick ( B ). 11.2. Apply silicon or sealant to the cut edge of the kitchen cabinet toe kick or paint so it does not absorb moist...

Page 24 - INSTALLER CHECKLIST; filter screen after the end of the; FINAL INSTRUCTIONS

21 USA 8. INSTALLER CHECKLIST Your installer must have completed and checked the following: • The dishwasher is square and level. • The dishwasher is fastened securely to the cabinetry. • The dishwasher door opens and closes freely. The dishwasher door must close without hitting any cabinetry or cou...