Axis Q87-E - Manuals

AXIS Q87-E 230/120 V AC Installation Guide Page 7 ENGL IS H Install the Power Supply The mains supply shall be disconnected during installation. The supplied power supply shall be used. Using any other power supply will void the warranty and could leave the unit at a risk. The day/night sensor is at...

Page 8 AXIS Q87-E 230/120 V AC Installation Guide 4. Connect the pan/tilt power supply to the pan/tilt connector (6) in the power supply.5. If using the day/night sensor, connect the illuminator cable to the illuminator connector (J5) in the power supply. 6. If using the day/night sensor, adjust the...

AXIS Q87-E 230/120 V AC Installation Guide Page 9 ENGL IS H Connection Diagram Cable Specification Notes: • To maintain the products IP rating, the external diameter of the cables must be 5 - 10 mm.• The Pan/tilt power supply cable can not be longer than 3 m (9 ft). Cable Number of wires Cable area ...

Day/Night Sensor The day/night sensor is configured in the factory for optimal performance in a range of conditions. However, settings can be adjusted to suit specific conditions on site. To adjust the sensitivity of the day/night sensor, turn the potentiometer until it reaches the desired threshold...