Page 5 - Hazard Levels; Other Message Levels
AXIS Q60 Series Safety Information Read through this Installation Guide carefully before installing the product. Keep the InstallationGuide for future reference. Hazard Levels DANGER Indicates a hazardous situation which, if not avoided, will result indeath or serious injury. WARNING Indicates a haz...
Page 6 - Transportation
AXIS Q60 Series Safety Instructions WARNING • The Axis product shall be installed by a trained professional. NO NO NOTICE TICE TICE • The Axis product shall be used in compliance with local laws and regulations. • Store the Axis product in a dry and ventilated environment. • Avoid exposing the Axis ...
Page 7 - AXIS Q60 Series; Dome Cover
AXIS Q60 Series WARNING • Risk of explosion if the battery is incorrectly replaced. • Replace only with an identical battery or a battery which is recommended by Axis. • Dispose of used batteries according to local regulations or the battery manufacturer's instructions. Dome Cover NO NO NOTICE TICE ...
Page 9 - Installation Steps
AXIS Q60 Series Installation Guide This Installation Guide provides instructions for installing AXIS Q6042-E/Q6044-E/Q6045-E PTZDome Network Camera on your network. For other aspects of using the product, see the UserManual available at www.axis.com Installation Steps 1. Make sure the package conten...
Page 10 - Optional Accessories
AXIS Q60 Series Optional Accessories • AXIS T91A Mounting Accessories • Smoked dome cover • RJ45 IP66-rated Cable with Premounted Connector (CAT6) 5 m • AXIS T8310 Video Surveillance Control Board • AXIS T90A Illuminators • Installation Display • Midspan For information about available accessories, ...
Page 12 - Sunshield; LED Indicators
AXIS Q60 Series Sunshield 2 1 1 Screw holes 2 Holes for unit holders LED Indicators LED Color Indication Unlit Connection and normal operation Amber Steady during startup. Flashes during firmware upgrade. Amber/red Flashes amber/red if network connection is unavailableor lost. Red Flashes red for fi...
Page 13 - Connectors and Buttons; Specifications; Operating Conditions
AXIS Q60 Series Green, flashing Fast flash when input voltage is out of range or otherinternal error. AC Green Steady when AC power input connected. Connectors and Buttons For specifications and operating conditions, see page 13 . Specifications Operating Conditions The Axis product is intended for ...
Page 14 - Install the Hardware; Attach the Sunshield
AXIS Q60 Series Install the Hardware NO NO NOTICE TICE TICE • The AXIS product shall be connected using a shielded network cable (STP). All cables connecting the product to the midspan shall be shielded (STP) and intended for theirspecific use. Make sure that the midspan is properly grounded. For in...
Page 15 - Install an SD Card
AXIS Q60 Series 3. Make sure the rubber gasket is fitted correctly on the dome cover.4. Align the bulge on the dome cover with one of the logotypes on the dome ring.5. Attach the dome bracket and the dome cover to the dome ring and tighten the screws (torque 1.2 Nm). 6. To install an SD card (not in...
Page 17 - Install the Midspan
AXIS Q60 Series 1 2 3 4 1 Screw T30 (3x) 2 Slot for unit holder (3x) 3 Safety wire 4 Wall bracket (mounting example) 11. Install the supplied midspan. See page 17 . Install the Midspan The supplied midspan enables Axis network video products with high power consumption to receivedata and power over ...
Page 18 - Access the Product
AXIS Q60 Series 1 2 3 4 1 Data and power out (connect to Axis product) 2 Data in (connect to network) 3 AC input LED indicator 4 Port LED indicator 4. Make sure that the LEDs on the midspan indicate the correct conditions. See Midspan LED Indicators on page 12 . Access the Product Use the tools prov...
Page 19 - Further Information
AXIS Q60 Series 4. The process is now complete. The product has been reset to the factory default settings. If no DHCP server is available on the network, the default IP address is 192.168.0.90 5. Using the installation and management software tools, assign an IP address, set the password and access...
Page 21 - USA; Errata; Network Connector; About this document
Regulatory Information USA This equipment has been tested using an unshielded network cable (UTP) and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC rules. This equipment has also been tested using a shielded network cable (STP) and found to comply with ...