Page 2 - User Guide; Table of Contents; Advanced Features: Installation-programmable; Introduction
P. 2 User Guide Table of Contents Introduction ............................................................ 2 Using the Remote Control..................................... 3 Multi-Level Features ( default state) ..................... 3 Vehicle Presets....................................................
Page 3 - Customized Features; press the
User guide P. 3 Using the Remote Control Your Remote Car Starter is equipped with a 7-button multi-channel remote control. It can operate two independent vehicles equipped with a Remote Car Starter (see Multi-Car Operation section, later in this Guide, for second-car transmitter functions). The func...
Page 4 - Vehicle Presets; Heater & Heated Seat; Arming the Starter Kill
P. 4 User Guide x To access a feature that is programmed as level 2, press the PANIC/AUX button twice followed by the desired function. x To access a feature that is programmed as level 3, press the PANIC/AUX button three times followed by the desired function. Your installer can customize the syste...
Page 5 - Remote-Starting Your Vehicle; Setting Your Vehicle Into Ready Mode
User guide P. 5 ¾ Passive mode: • To arm the Starter Kill, press the LOCK button on the transmitter, OR • In Passive Mode, the Starter Kill will also automatically arm 1 minute (by default) or 3 minutes (if configured this way) after the ignition is turned OFF or once the last door is closed (if the...
Page 6 - To set the system to Ready Mode:; If Ready Mode is enabled by remote; Driving Off; Do not turn the key; Remote Starter Features; Idle Mode
P. 6 User Guide To set the system to Ready Mode: If Ready Mode is enabled by remote If Ready Mode is enabled by handbrake 1. Ensure that all the doors, hood and trunk are closed. Make sure that the gear selector is in the neutral position. 2. With the engine already running, apply the parking brake ...
Page 7 - Valet Mode; To put the system i n t o Valet Mode
User guide P. 7 To leave the vehicle in Idle Mode if your vehicle has an automatic transmission: 1. With the engine running, press the LOCK or UNLOCK button (to unlock the doors) or the START/STOP button on the remote control until the parking lights come on. 2. Remove the key and exit the vehicle. ...
Page 8 - To put the system o u t o f Valet Mode; Panic Mode; Note; Cold Weather Mode
P. 8 User Guide The LED on the antenna will come ON solid to indicate that the vehicle has successfully entered Valet mode. To put the system o u t o f Valet Mode • To put the system o u t o f Valet mode using the KEY (Ignition Valet Mode): a. Insert the ignition key into the ignition switch. Within...
Page 9 - Advanced Features: Installation-programmable Options; Passive or Active Arming of the Starter Kill
User guide P. 9 • Press and release the PANIC button. While the LED on the transmitter is flashing, press the START/STOP button until the parking lights flash once . To verify whether the system is in Cold Weather Mode: • Press the brake pedal: • If the vehicle is in cold weather mode, the parking l...
Page 11 - Engine Run Time
User guide P. 11 If your vehicle has a manual transmission, follow all steps of the Ready Mode routine (see earlier in this Guide) to activate Turbo Mode. At the last step, press either: a. LOCK to lock the doors and have the engine shut down after 60 seconds; b. UNLOCK to unlock the doors and have ...
Page 12 - Troubleshooting Poor Transmitting Range; The condition of the battery in the transmitter.
P. 12 User Guide Troubleshooting Poor Transmitting Range Many factors may affect the operating range of the transmitter. Some of these are: • The condition of the battery in the transmitter. • The operating environment (for example: downtown radio-frequency noise, airports, cellular phone towers…). ...
Page 13 - User guide; LIMITED LIFETIME WARRANTY
User guide P. 13 LIMITED LIFETIME WARRANTY REMOTE STARTERS AND ALARM SYSTEMS: As the manufacturer, 4366859 Canada Inc. (“Autostart”) warrants to the original consumer purchaser only ( nontransferable ) that the remote starter module (control box) shall be free from defects in materials and workmansh...