Autostart AS-1755V - Manuals

Page 2 - User Guide; Table of Contents; Introduction

P. 2 User Guide Table of Contents Introduction ............................................................ 2 Using the Remote Control..................................... 3 Vehicle Presets....................................................... 3 Heater & Heated Seat ...............................

Page 3 - Using the Remote Control; generation transmitters; Vehicle Presets; Heater & Heated Seat

User guide P. 3 Using the Remote Control Your Remote Car Starter is equipped with a 5-button multi-channel remote control. It can operate two independent vehicles equipped with a Remote Car Starter (see Multi-Car Operation section, later in this Guide, for second-car transmitter functions). The func...

Page 4 - Arming the Starter Kill; twice; and arm the OEM alarm; Remote-Starting Your Vehicle; Setting Your Vehicle Into Ready Mode

P. 4 User Guide Windshield Wipers, Radio & Headlights Certain vehicles require the radio and / or windshield wiper and / or headlight circuits to become energized while running under remote start. When leaving the vehicle you must ensure that the windshield wiper and headlight switches are OFF ....

Page 5 - Driving Off; Do not turn the key; Remote Starter Features; Idle Mode

User guide P. 5 3. Within 20 sec. of engaging the parking brake, press and hold LOCK , UNLOCK or START/STOP on the transmitter. The parking lights will flash 3 times quickly and remain lit. - 4. Remove the key: the engine will continue running. 5. Exit the vehicle and close all doors, hood and trunk...

Page 6 - NEUTRAL; Make sure to release the brake pedal.; The parking lights will flash 3 times quickly and remain lit.; Valet Mode; To put the system i n t o Valet Mode:; Remote Valet Mode; Getting into Valet Mode; The Parking Lights will flash 3 times.; Getting out of Valet Mode; The Parking Lights will flash 2 times.; Panic Mode

P. 6 User Guide 1. Ensure that the doors are all closed and that the gearshift lever is in the NEUTRAL position. 2. With the engine already running, apply the parking brake and release the brake pedal. Make sure to release the brake pedal. 3. Within 20 sec. push LOCK , UNLOCK or START on the transmi...

Page 7 - If your system is equipped with the 2; Press and hold the; parking lights flash.; Note; Cold Weather Mode; Extended Run Time; Advanced Features: Installation-programmable Options

User guide P. 7 If your system is equipped with the 2 nd generation remote: Press and hold the STOP button for more than 3 seconds until the sound signal starts and the parking lights flash. If your system is equipped with the 1 st generation remote: In an emergency situation, you can activate Panic...

Page 8 - Caution; of the Starter Kill; Passive Mode; OEM alarm; is open or if the key is turned in the ignition, the horn will honk.; The OEM alarm will be; button is pressed.

P. 8 User Guide Caution : The programming of your system should be left to a professional. Changing any one of the settings may affect the operation of your Remote Car Starter. Active or Passive Arming of the Starter Kill The Starter Kill can be configured either to Passive Mode (so as to arm automa...

Page 9 - ” Mode; Turbo Mode; If your vehicle has an automatic transmission

User guide P. 9 Note: If the Starter Kill is installed, your vehicle will benefit from a protection against starter motor damage that could occur after remote-starting the engine should the user, by force of habit, turn the ignition key to the CRANK position. Safe Start If this feature is enabled, t...

Page 10 - button to lock the doors the engine will shut down after; Engine Run Time; Flashing LED

P. 10 User Guide 2. Remove the ignition key from the ignition switch. The engine will go on running. 3. Exit the vehicle and close the door. Press the TRUNK button to lock the doors; the engine will shut down after 60 seconds of Turbo Mode. If your vehicle has a manual transmission, follow all steps...

Page 11 - Horn Chirp Timing; Troubleshooting Poor Transmitting Range

User guide P. 11 slower rate. Starter kill ON / Alarm OFF: the LED will flash twice quickly until the OEM alarm is armed. Once the OEM alarm is armed, it will flash at a slower rate. In Valet Mode: the LED will remain lit without flashing. Flashing LED OFF : the LED will not flash even when the Remo...

Page 12 - Intrusion Codes through Chirps; to identify the intrusion.; Chirps

P. 12 User Guide Intrusion Codes through Chirps If there has been an intrusion in the vehicle while it was locked and armed, the OEM alarm will provide in intrusion code matching the type of intrusion that took place. Disarm the alarm ( UNLOCK ) to identify the intrusion. Diagnostics – Chirps Table ...