Audiovox PRO 9171FT - Manuals

Page 2 - IGNITION SWITCH KEY POSITION; OFF; WIRING THE 6 PIN MAIN POWER HARNESS

The PRO-9171FT is for Automatic Transmission vehicles only! Although it is a sophisticated system, withmultiple built-in safety features, it must not be installed into vehicles with manual transmissions. Doing this can cause serious personal injury and property damage. IMPORTANT ! DO NOT PLUG THE SI...

Page 3 - Connect this wire to a solid, clean chassis ground source.; GREY w/ BLACK Tracer Wire: Negative Inhibit Input 2

LIGHT GREEN Wire : Ignition 2 Output Connect this wire to the ignition 2 wire from the ignition switch. This wire will show +12 Volts when the ignitionkey is turned to the “ RUN or ON “ position, and in some cases, the “ START or CRANK “ position. This wirewill show 0 Volts when the key is turned to...

Page 6 - To program these selectable features:; and the unit is now out of the program mode.

To program these selectable features: 1. Start with the programming switch in the OFF position.2. Turn the ignition key to the ON position.3. Flip the program switch ON - OFF - ON - OFF - ON - then OFF.4. Immediately turn the ignition key OFF, then back to ON.5. Flip the program switch ON - OFF - ON...

Page 7 - NEUTRAL START SAFETY TEST:; ignition switch off. DO NOT attempt to remove the key.; REMEMBER TO RECONNECT THE BROWN/BLACK WIRE TEMPORARILY

NEUTRAL START SAFETY TEST: The intent of the neutral start switch is to prevent the vehicle from starting while the gear selector is in anyposition other than Park, or Neutral. When installing a Remote Start Device, it is imperative that the YellowStarter wire be connected to the ignition switch sid...

Page 8 - METHOD 1

KEY IN SENSOR CIRCUITS: If the vehicle you are working on does not have or you cannot locate the ECM reference wire, there are two alternatives available. Although not preferred, the vehicle Key In Sensor may be reconfigured to allow a margin of safety and will prevent the vehicle with a Mechanical ...

Page 9 - To connect to the key in sensor as shown in method 1:; METHOD 2; To connect to the key in sensor circuit as shown for method 2:

To connect to the key in sensor as shown in method 1: A . Locate the control wire that connects the drivers door pin switch to the key in sensor switch.B . Cut this wire and connect the ignition cylinder side to chassis ground.C. Locate the key in sensor switch wire that connects the chime module to...

Page 10 - COMPLETING THE INSTALLATION:

10 NOTE: A second 4002 series diode may be required to maintain the integrity of the hood open, shut downcircuit. If this is the case, it must be installed as shown in the diagram above. The anode (Non Striped)side must be connected to the Gray/Black wire of the Remote Start Unit. The cathode (Strip...

Page 11 - WIRING THE 12 PIN INPUT / OUTPUT HARNESS

12 PIN CONNECTOR WIRING THE 12 PIN INPUT / OUTPUT HARNESS CONTROL SWITCH TO ALARM'S IGNITION INPUT- (YELLOW WIRE OF AUDIOVOX ALARMS) LIGHT BLUE WHITE WHITE POSITIVE INHIBIT 1 NEGATIVE INHIBIT 2 TACH SPLICE EXISTING BRAKE SWITCH IGNITION3 OR SHOCKBY-PASS TO CHASSIS GROUND EXISTING PARKING LAMP WIRE S...