Audiovox PRO 9171FT - Manual
Audiovox PRO 9171FT – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – IGNITION SWITCH KEY POSITION; OFF; WIRING THE 6 PIN MAIN POWER HARNESS
- Page 3 – Connect this wire to a solid, clean chassis ground source.; GREY w/ BLACK Tracer Wire: Negative Inhibit Input 2
- Page 6 – To program these selectable features:; and the unit is now out of the program mode.
- Page 7 – NEUTRAL START SAFETY TEST:; ignition switch off. DO NOT attempt to remove the key.; REMEMBER TO RECONNECT THE BROWN/BLACK WIRE TEMPORARILY
- Page 8 – METHOD 1
- Page 9 – To connect to the key in sensor as shown in method 1:; METHOD 2; To connect to the key in sensor circuit as shown for method 2:
- Page 10 – COMPLETING THE INSTALLATION:
- Page 11 – WIRING THE 12 PIN INPUT / OUTPUT HARNESS
3 Channel Remote Car Starter
Installation Instructions
For installation in vehicles with 12 volt negative ground circuits,
gasoline engines, with automatic transmission only!
Model PRO 9171FT
Installation Manual
KIT CONTENTS
(1) Remote Start Control Module
(2) 3 Button RF Keychain Transmitters
(2) Wiring Harnesses
(1) Parts Bag Containing
(2) Fuses
(2) Fuse Holders
(1) Control Switch
(1) Programming Switch
(1) Ring Terminal
(4) 1/2" Long Screws
(1) Pin Switch
(1) Accessory 2 Pin Connector
(1) 2 Pin Door Lock Harness
(1) Remote Start Warning Label
(1) Literature Package
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
The PRO-9171FT is for Automatic Transmission vehicles only! Although it is a sophisticated system, withmultiple built-in safety features, it must not be installed into vehicles with manual transmissions. Doing this can cause serious personal injury and property damage. IMPORTANT ! DO NOT PLUG THE SI...
LIGHT GREEN Wire : Ignition 2 Output Connect this wire to the ignition 2 wire from the ignition switch. This wire will show +12 Volts when the ignitionkey is turned to the “ RUN or ON “ position, and in some cases, the “ START or CRANK “ position. This wirewill show 0 Volts when the key is turned to...
To program these selectable features: 1. Start with the programming switch in the OFF position.2. Turn the ignition key to the ON position.3. Flip the program switch ON - OFF - ON - OFF - ON - then OFF.4. Immediately turn the ignition key OFF, then back to ON.5. Flip the program switch ON - OFF - ON...
