Audiovox AS 9075 - Manuals - manualsarea.com

Page 3 - + 12 Volts Battery 2 Source

Remote Start Connection WIRING THE 6 PIN MAIN POWER HARNESS:RED w/ WHITE Trace Wire: + 12 volts Battery 1 Source Connect this wire to a + 12 VDC constant source found at the vehicle's ignition switch using the 30 Amp fuseand holder provided. This wire provides power for the control circuit as well a...

Page 4 - WIRING CONNECTIONS: 12 Pin Input / Output Harness; Chassis Ground Source

BLUE Wire: Ignition 1 Output Connect this wire to the ignition 1 wire from the ignition switch. This wire will show +12 volts when the ignitionkey is turned to the to the "ON" or "RUN" and the "START" or CRANK" positions, and will have 0 volts whenthe key is turned to the...

Page 5 - Brake Switch Positive Shutdown Detail; PRESENTLY CONNECTED TO IN THE VEHICLE.

the Black w/ White wire is at open circuit through the control switch, the remote starter is disabled.Connect the Black w/ White tracer wire to one of the wires from the back of the previously mounted control switch.Connect the remaining wire of the control switch to chassis ground. Always try to mo...

Page 6 - LIGHT BLUE Wire: Ignition 3 / Shock Disable Output; ignition wire in the vehicle.

This wire should be connected to the ignition input of the alarm system.The Yellow w/ Black wire output will allow you to remote start the vehicle while leaving the alarm armed, and to lock/unlock the doors while running under control of the remote start unit. (2) WHITE Wires: Parking Light Flasher ...

Page 7 - General Motors VATS By-Pass Diagram; Trigger Input; DARK GREEN/ORANGE Wire: Tach Sensor Input; Tachometer Input Wiring Detail

NOTE: These wires are typically White w/ Black trace and Violet w/ Yellow trace, however in later model Cadillacs, they are run through an orange sleeve, and are either both Black, both Yellow, or both White wires. Consult the factory service manual for additional information. 3. Connect the Light B...

Page 10 - light flash indications are as follows:; TIMED START OPERATION:

10 The parking lights will flash a number of times indicating the reason for the last remote start shutdown. The light flash indications are as follows: 1 Flash 10 or 15 Minute Run Timer Expired 2 Flashes Low or No Tach Signal (RPM) 3 Flashes Positive Or Negative Shutdown Wire Activated 4 Flashes Co...

Page 13 - METHOD 1; To connect to the key in sensor as shown in method 1:

margin of safety and will prevent the vehicle with a Mechanical Neutral Start Switch from starting in gear.AUDIOVOX ADVISES THAT YOU MAINTAIN THE FACTORY CIRCUIT WHENEVER POSSIBLE. The following two circuits may be used only if the above circuit is not available. NOTE: When completing an installatio...

Page 14 - METHOD 2; To connect to the key in sensor circuit as shown for method 2:; COMPLETING THE INSTALLATION:; with under the dash board or in the engine compartment areas.

METHOD 2 To connect to the key in sensor circuit as shown for method 2: A. Locate the control wire that connects the drivers door pin switch to the key in sensor switch.B. Cut this wire and connect the ignition cylinder side to chassis ground.C. Locate the key in sensor switch wire that connects the...

Page 15 - WIRING THE CONTROL MODULE