Audiovox AS 9075 - Manual
Audiovox AS 9075 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 3 – + 12 Volts Battery 2 Source
- Page 4 – WIRING CONNECTIONS: 12 Pin Input / Output Harness; Chassis Ground Source
- Page 5 – Brake Switch Positive Shutdown Detail; PRESENTLY CONNECTED TO IN THE VEHICLE.
- Page 6 – LIGHT BLUE Wire: Ignition 3 / Shock Disable Output; ignition wire in the vehicle.
- Page 7 – General Motors VATS By-Pass Diagram; Trigger Input; DARK GREEN/ORANGE Wire: Tach Sensor Input; Tachometer Input Wiring Detail
- Page 10 – light flash indications are as follows:; TIMED START OPERATION:
- Page 13 – METHOD 1; To connect to the key in sensor as shown in method 1:
- Page 14 – METHOD 2; To connect to the key in sensor circuit as shown for method 2:; COMPLETING THE INSTALLATION:; with under the dash board or in the engine compartment areas.
- Page 15 – WIRING THE CONTROL MODULE
Model AS 9075
Installation Manual
Remote Start Upgrade Module
Installation Instructions
This Unit Is Intended For Installation In Vehicles With
12 Volt Negative Ground Electrical Systems,
Gasoline or Diesel With True Tach Reference
And Automatic Transmissions Only.
Kit Contents
AS-9075 Control Module
(1) - Multi Pin Input/Output Harness
(1) - Six Pin Power Harness
(1) - Four Pin Auxiliary Harness
(1) - Three Pin I/O Harness
(2) - 30 Amp In-line Fuse Holders With Fuses
(1) - Control Switch / Programming Switch
(1) - Ring Terminal
(4) - 1/2" Long Screws
(1) - Pin Switch
(1) - Remote Start Warning Label
(1) - Literature Package
1
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Remote Start Connection WIRING THE 6 PIN MAIN POWER HARNESS:RED w/ WHITE Trace Wire: + 12 volts Battery 1 Source Connect this wire to a + 12 VDC constant source found at the vehicle's ignition switch using the 30 Amp fuseand holder provided. This wire provides power for the control circuit as well a...
BLUE Wire: Ignition 1 Output Connect this wire to the ignition 1 wire from the ignition switch. This wire will show +12 volts when the ignitionkey is turned to the to the "ON" or "RUN" and the "START" or CRANK" positions, and will have 0 volts whenthe key is turned to the...
the Black w/ White wire is at open circuit through the control switch, the remote starter is disabled.Connect the Black w/ White tracer wire to one of the wires from the back of the previously mounted control switch.Connect the remaining wire of the control switch to chassis ground. Always try to mo...
