Audiovox APS 996 - Manuals

White w/ Black Trace Wire: (+) Siren OutputThis is the positive siren feed wire. Route this wire through a grommet in the firewall to the sirenlocation. Connect the White w/ Black Trace wire to the Red wire of the Siren. Secure the Black wireof the Siren to a known chassis ground or solid clean meta...

Light Blue Wire: Ignition 3 OutputThis wire provides a 300mA ground output that becomes active 3 seconds before the Remote Start Unitinitializes and remains grounded while running plus an additional 4 seconds after the Remote Start Unitturns off. In all of the applications described below, a relay w...

Dark Blue Wire: Delayed 300mA Pulsed Channel 3 OutputThe Dark Blue wire supplies a 300mA ground pulsed output whenever channel three of the receiver isaccessed. Pressing the pre-programmed transmitter button for three seconds will access channel two.This is a low current output and must be connected...

1 3 NOTE : This is a normally opened starter cut arrangement, and when power is removed from thesecurity system, the starter disable feature will remain operational, and the vehicle will not start.Audiovox does not recommend using the Orange w/ White trace wire to interrupt anything but thestarting ...

1 7 NOTE: Resistive Circuits, As Well As 4 Wire Polarity Reversal and 5 Wire Alternating 12 Volt Door Lock Control CircuitsThese applications require the use of additional components which may include relays, fixed resistors, orfor convenience, the AS 9159 Door Lock Interface. Refer to the AUDIOVOX ...

1 8 START PROGRAM:The Remote Start unit has the ability to start the vehicle automatically at timed intervals. This feature isuseful in extremely cold climates where starting the engine is the only means to keep the battery chargedand fluids warm. The operator has the option to have the unit start e...

CAUTION! REMEMBER TO RECONNECT THE BROWN/BLACK WIRE TEMPORARILY DISCONNECTED IN STEP 3 DO NOT RELEASE THIS VEHICLE TO THE CONSUMER UNTIL YOU CONFIRM THE OPERATION OF THE NEUTRAL SAFETY START FEATURE. KEY IN SENSOR CIRCUITS:If the vehicle you are working on does not have or you cannot locate the ECM ...

2 3 METHOD 2 To connect to the key in sensor circuit as shown for method 2:A. Locate the control wire that connects the drivers door pin switch to the key in sensor switch.B. Cut this wire and connect the ignition cylinder side to chassis ground.C. Locate the key in sensor switch wire that connects ...

COMPLETING THE INSTALLATION: After you have confirmed the operation of the Audiovox Remote Start unit and tested all the safety featuresof the system:1. If you have not done so already, place the red rubber handle cover over the handle of the control switch for ease of identification. This will allo...