Audiovox AA-RS30CS - Manuals

WIRING CONNECTIONS: 12 Pin Input / Output Harness Black Wire: Chassis Ground SourceConnect the Black wire to a known vehicle ground source or to a solid clean metal part of the chassis. Be certain toremove any paint or grease and secure this wire with a self tapping screw and ring terminal. 5 BLACK ...

connect the Brown w/Black trace wire to the output of the brake light switch. If the brake light switch in the vehicleswitches ground, do not use the Brown w/Black wire; see Grey w/Black tracer wire. 6 YELLOW w/BLACK Tracer Wire: + 12 Volt Alarm By - Pass OutputNOTE: YOU MUST DISCONNECT THE IGNITION...

LIGHT BLUE Wire: Ignition 3 / Shock Disable OutputThis wire provides a 300mA ground output that becomes active 3 seconds before the Remote Start Unit initializes,and remains grounded while running plus an additional 4 seconds after the Remote Start Unit turns off. In all of theapplications described...

10 disarm a factory theft deterrent system to prevent false triggering of the factory alarm when the remote start unitengages or when the AA-RS30CS is used to unlock the doors. Black w/Light Green Trace Wire: Pulsed Ground Output After StartThe Black w/Light Green Trace wire will provide a 1 second ...

11 Entry Illumination Detail Green w/Black Trace Wire: 300mA Latched Channel 3 OutputThe Green w/Black Trace wire supplies a 300mA switched output whenever channel three of the receiver is ac-cessed. Pressing the pre-programmed transmitter button(s) will access channel three and will remain active, ...

12 NOTE:1. When selecting Diesel operation, (Feature Nine), over gasoline, the only change is to the ignition circuits. WhenDiesel is selected, the ignition circuits will power up 10 seconds before the start circuit. The intent of this feature is toallow the glow plug warming required by some diesel...

13 1 Flash 10 or 15 Minute Run Timer Expired 2 Flashes Low or No Tach Signal (RPM) 3 Flashes Positive Or Negative Shutdown Wire Activated 4 Flashes Control Switch Moved to Off Position 5 Flashes RF shutdown, Remote signal received, or manual start trigger wire reactivated. 6 Flashes High RPM Signal ...

14 TESTING YOUR INSTALLATION: WARNING!! The following procedure must be performed after the installation of an Audiovox Remote Start Device. It is the responsibility of the installing technician to complete these tests. Failure to test the unit in thefollowing manner may result in personal injury, p...

16 KEY IN SENSOR CIRCUITS:If the vehicle you are working on does not have or you cannot locate the ECM reference wire, there are two alternativesavailable. Although not preferred, the vehicle Key In Sensor may be reconfigured to allow a margin of safety and willprevent the vehicle with a Mechanical ...

17 METHOD 2 G. Connect terminal 87 of the relay to the Chime Module side of the previously cut wire in step D.H. Connect terminal 85 of the relay to the Drivers Door side of the pin switch wire previously cut in step B.NOTE: A second 4002 series diode may be required to maintain the integrity of the...

18 COMPLETING THE INSTALLATION: After you have confirmed the operation of the Audiovox Remote Start unit and tested all the safety features of thesystem:1. If not done so already, place the red rubber handle cover over the handle of the control switch for ease of identification. This will allow your...