Audiovox AA-RS10CS - Manuals

Page 2 - INSTALLATION OF THE MAJOR COMPONENTS:

The AA-RS10CS Remote Start/Keyless Entry System is designed to be used with Automatic Transmission Vehicles Only!The unit provides a selectable ignition control that allows a 10 second output for glow plug pre-heat which may be requiredfor certain diesel vehicles, (see selectable feature #9). If the...

Page 7 - you will require the Audiovox AS-PASS II Module.; General Motors VATS By-Pass Diagram

Page 7 4. Cut (#1) wire (as shown), and connect the ignition switch side of the cut wire to terminal #87a of the relay. Connect the other side of the (#1) wire to terminal #30. 5. Connect the previously selected resistor from terminal #87 to the second (#2) wire (as shown). NOTE: The above informati...

Page 9 - remote start trigger inputs, will damage the control module.; Channel 2 Relay Wiring Detail

Page 9 Audiovox AS-9159 Door Lock Interface, (or equivalent 30 A automotive relays) must be used. Refer to the AudiovoxDoor Lock Wiring Supplement for proper wiring of these circuits.4 Wire Polarity Reversal and5 Wire Alternating 12 VoltDoor Lock Control CircuitsIn these applications, the AS 9159 Do...

Page 10 - To program these selectable features:

Page 10 Feature Selection 1 Flash 2 Flashes Default First 1 Second Door Locks 3.5 Second Door Locks 1 Second Second 10 Minute Run Time 15 Minute Run Time 10 Minute Third Park Lights Steady On Park Lights Flash Steady Fourth (No Function) Tach Operation Tach Fifth (No Function) (No Function) --------...

Page 12 - cylinder, four coil systems, connect to any of the three coils.; DO NOT RELEASE THIS VEHICLE TO THE CONSUMER UNTIL YOU CONFIRM THE

Page 12 2. For vehicles utilizing 2 cylinder firing per coil pack, connect Green/Black to the tach side of each coil pack. For 8 cylinder, four coil systems, connect to any of the three coils. 3. Connect the Yellow wire to a +12 volt ignition 1 source. This wire will have +12 volts with the ignition...

Page 13 - switch off. DO NOT attempt to remove the key.; REMEMBER TO RECONNECT THE BROWN/BLACK WIRE TEMPORARILY

Page 13 4. Sitting in the vehicle, start the engine using the vehicle's ignition key.5. Step on the brake pedal and shift the gear selector into reverse.6. Allow the transmission to shift. When you feel the engine pull, do not move the gear selector just turn the ignition switch off. DO NOT attempt ...

Page 14 - METHOD 1

Page 14 KEY IN SENSOR CIRCUITS:If the vehicle you are working on does not have or you cannot locate the ECM reference wire, there are two alternativesavailable. Although not preferred, the vehicle Key In Sensor may be re-configured to allow a margin of safety and willprevent the vehicle with a Mecha...

Page 15 - Remote Start Unit as shown below.; METHOD 2; using a 4002 series diode as shown above.

Page 15 Remote Start Unit as shown below. METHOD 2 To connect to the key in sensor circuit as shown for method 2:A. Locate the control wire that connects the drivers door pin switch to the key in sensor switch.B. Cut this wire and connect the ignition cylinder side to chassis ground.C. Locate the ke...

Page 16 - WIRING DIAGRAM