Audiovox AA-RS10CS - Manual
Audiovox AA-RS10CS – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – INSTALLATION OF THE MAJOR COMPONENTS:
- Page 7 – you will require the Audiovox AS-PASS II Module.; General Motors VATS By-Pass Diagram
- Page 9 – remote start trigger inputs, will damage the control module.; Channel 2 Relay Wiring Detail
- Page 10 – To program these selectable features:
- Page 12 – cylinder, four coil systems, connect to any of the three coils.; DO NOT RELEASE THIS VEHICLE TO THE CONSUMER UNTIL YOU CONFIRM THE
- Page 13 – switch off. DO NOT attempt to remove the key.; REMEMBER TO RECONNECT THE BROWN/BLACK WIRE TEMPORARILY
- Page 14 – METHOD 1
- Page 15 – Remote Start Unit as shown below.; METHOD 2; using a 4002 series diode as shown above.
- Page 16 – WIRING DIAGRAM
Kit Contents
AA-RS10CS Control Module
(2) - 3 Button Anti Code Grabbing Transmitters
3 Channel Code Learning Receiver
External Superheterodyne Antenna/Receiver
(1) - Multi Pin Input/Output Harness
(1) - Six Pin Power Harness
(1) - Four Pin Auxiliary Harness
(1) - Two Pin I/O Harness
(1) - Accessory 2 Pin Connector
(1) - 2 Pin Door Lock Harness
(2) - 30 Amp In-line Fuse Holders With Fuses
(1) - Control Switch
(1) - Programming Switch
(1) - Ring Terminal
(4) - 1/2" Long Screws
(1) - Pin Switch
(1) - Remote Start Warning Label
(1) - Literature Package
Model AA-RS10CS
Installation Manual
3 Channel Remote Start / Keyless Entry System
Installation Instructions
This Unit is Intended for Installation in Vehicles with 12 Volt Negative Ground
Electrical Systems, Gasoline or Diesel with True Tach Reference and Automatic
Transmissions Only.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
The AA-RS10CS Remote Start/Keyless Entry System is designed to be used with Automatic Transmission Vehicles Only!The unit provides a selectable ignition control that allows a 10 second output for glow plug pre-heat which may be requiredfor certain diesel vehicles, (see selectable feature #9). If the...
Page 7 4. Cut (#1) wire (as shown), and connect the ignition switch side of the cut wire to terminal #87a of the relay. Connect the other side of the (#1) wire to terminal #30. 5. Connect the previously selected resistor from terminal #87 to the second (#2) wire (as shown). NOTE: The above informati...
Page 9 Audiovox AS-9159 Door Lock Interface, (or equivalent 30 A automotive relays) must be used. Refer to the AudiovoxDoor Lock Wiring Supplement for proper wiring of these circuits.4 Wire Polarity Reversal and5 Wire Alternating 12 VoltDoor Lock Control CircuitsIn these applications, the AS 9159 Do...
