AT&T 7625 - Manuals

• Mount the base on the wall by holding the base so that the mountingknobs on the standard wall jack will fit into the keyhole slots on thebase. Slide the base bracket down onto the knobs until it locks intoplace. The cradle will support the handset when the base is on the wall. • Plug the AC adapte...

TELEPHONE OPERATION (From the Base) TELEPHONE OPERATION (From the Handset) Page The Page feature allows you to signal someone at the handset from the base. • Make sure the Handset In Use light is not lit on the base. • Press on the base. A three-part paging tone will sound at the handset. * NOTE: Th...

MEMORY OPERATING RANGE This cordless answering system can store 10 different phone numbers that youcan dial just by pressing and one of the number buttons. Storing Memory Numbers 1 Make sure the handset is OFF. 2 Press . 3 Enter the phone number (up to 16 digits). 4 Press . 5 Press any number button...

ANSWERING SYSTEM SET-UP ANSWERING SYSTEM SET-UP Announcement Play/Silent Your system is factory preset to audibly play your announcement through thespeaker when the system answers a call. If you do not want your announce-ment to be audible during answering, you can change your system as followsso th...

ANSWERING SYSTEM OPERATION: At the Base ANSWERING SYSTEM SET-UP Answering Calls and Recording Messages When the system is ON and the phone begins ringing, the system will answerthe call at the number of rings specified in Ring Select. The caller hears theannouncement you recorded followed by a singl...

To make sure you are deleting the right message, you can press to replay the message after listening to it, then press while the message is playing. After the system reaches the end of the last message, any messages that werenot deleted are renumbered, and the Message Counter shows the total numbero...

Accessing the Answering System from aTouch Tone Phone 1 Dial your phone number. * NOTE: Remember that if you set the RING SELECT feature to TOLLSAVER, the system will answer after two rings if there are new messagesand after four rings if there are no new messages. If you hear the third ringyou can ...

Remote Access Commands Playing all of your messages: Press . The system will play all of your messages and then beep twice to indicate that it is ready to accept a new command. Playing new messages only: Press . The system will play only those messages recorded since the last time messages were chec...

Recording a Memo From another touch tone phone (or the handset), you can also record a memofor yourself or anyone else who has access to the system. When the systemplays messages, it plays the memo along with the other messages on the system. You can record a memo any time after the system has given...

Call Monitoring As calls come in, the answering system will answer and record messages aslong as it is set for automatic answering operation. You can use the cordlesshandset to listen to the callers as they leave messages. You can begin to speakto a caller directly if you wish by pressing . Monitori...

BATTERIES Charging the Handset Battery Pack The batteries need charging when: • The phone beeps four times when you press . • The MUTE/LOW BATT light on the handset is on when the phone is off.The MUTE/LOW BATT light on the handset flashes on and off when thephone is on. • The phone does not respond...