AT&T 7625 - Manual - manualsarea.com

Page 2 - TABLE OF CONTENTS; Installation

1 TABLE OF CONTENTS Installation 3 Telephone Operation (From the Handset) 9 Making a Call . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Answering a Call . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Ending a Call Using...

Page 3 - Answering System Operation: At the Base

INSTALLATION TABLE OF CONTENTS Ring Select, Toll Saver and the Remote Access Code . . . . . . . . . . . . . . 16 Reviewing the Setting in the Feature Set-Up Menu . . . . . . . . . . . . . . . 18 Volume Control . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18 Inc...

Page 5 - Choose a spot near an electrical outlet and a telephone jack.; INSTALLATION; To wall mount the phone:

INSTALLATION 6 7 The instructions below are for both table and wall installation. 1 Choose a spot near an electrical outlet and a telephone jack. • This phone requires a modular telephone jack and a standard electricaloutlet (110v AC). • The outlet should not be controlled by a wall switch; if the s...

Page 6 - Position the base antenna so that it points upwards.; If the handset is in the base:

• Mount the base on the wall by holding the base so that the mountingknobs on the standard wall jack will fit into the keyhole slots on thebase. Slide the base bracket down onto the knobs until it locks intoplace. The cradle will support the handset when the base is on the wall. • Plug the AC adapte...

Page 7 - To locate the handset using this feature:; Mute; To activate the Mute feature:; Temporary Tone

TELEPHONE OPERATION (From the Base) TELEPHONE OPERATION (From the Handset) Page The Page feature allows you to signal someone at the handset from the base. • Make sure the Handset In Use light is not lit on the base. • Press on the base. A three-part paging tone will sound at the handset. * NOTE: Th...

Page 8 - Storing Memory Numbers; To insert a pause in a stored number:; Changing Channels; —OR—

MEMORY OPERATING RANGE This cordless answering system can store 10 different phone numbers that youcan dial just by pressing and one of the number buttons. Storing Memory Numbers 1 Make sure the handset is OFF. 2 Press . 3 Enter the phone number (up to 16 digits). 4 Press . 5 Press any number button...

Page 10 - Announcement Play/Silent

ANSWERING SYSTEM SET-UP ANSWERING SYSTEM SET-UP Announcement Play/Silent Your system is factory preset to audibly play your announcement through thespeaker when the system answers a call. If you do not want your announce-ment to be audible during answering, you can change your system as followsso th...

Page 11 - To play all your messages:

ANSWERING SYSTEM OPERATION: At the Base ANSWERING SYSTEM SET-UP Answering Calls and Recording Messages When the system is ON and the phone begins ringing, the system will answerthe call at the number of rings specified in Ring Select. The caller hears theannouncement you recorded followed by a singl...

Page 12 - Recording a Memo; ANSWERING SYSTEM OPERATION: At the Base; To play only your new messages:; Saving Messages; To delete a selected message:

To make sure you are deleting the right message, you can press to replay the message after listening to it, then press while the message is playing. After the system reaches the end of the last message, any messages that werenot deleted are renumbered, and the Message Counter shows the total numbero...

Page 13 - Voice Help Menu; Using the Voice Help Menu:; ANSWERING SYSTEM OPERATION:

Accessing the Answering System from aTouch Tone Phone 1 Dial your phone number. * NOTE: Remember that if you set the RING SELECT feature to TOLLSAVER, the system will answer after two rings if there are new messagesand after four rings if there are no new messages. If you hear the third ringyou can ...

Page 14 - Remote Access Commands

Remote Access Commands Playing all of your messages: Press . The system will play all of your messages and then beep twice to indicate that it is ready to accept a new command. Playing new messages only: Press . The system will play only those messages recorded since the last time messages were chec...

Page 15 - The Outgoing Announcement; Reviewing your outgoing announcement:

Recording a Memo From another touch tone phone (or the handset), you can also record a memofor yourself or anyone else who has access to the system. When the systemplays messages, it plays the memo along with the other messages on the system. You can record a memo any time after the system has given...

Page 16 - To change the status from off to on:; Recording a Message When the System is Off; Sound

Call Monitoring As calls come in, the answering system will answer and record messages aslong as it is set for automatic answering operation. You can use the cordlesshandset to listen to the callers as they leave messages. You can begin to speakto a caller directly if you wish by pressing . Monitori...

Page 17 - BATTERIES; Charging the Handset Battery Pack; IN CASE OF DIFFICULTY

BATTERIES Charging the Handset Battery Pack The batteries need charging when: • The phone beeps four times when you press . • The MUTE/LOW BATT light on the handset is on when the phone is off.The MUTE/LOW BATT light on the handset flashes on and off when thephone is on. • The phone does not respond...

AT&T 7625 - Manual

Table of Contents:

Summary

Other AT&T Models