Bosch KSV33VI3A - User Manual

en 7 Installation location A dry, well ventilated room is suitable as an installation location. The installation location should not be exposed to direct sunlight and not placed near a heat source, e.g. a cooker, radiator, etc. If installation next to a heat source is unavoidable, use a suitable ins...

en 8 Connecting the appliance After installing the appliance, wait at least 1 hour until the appliance is switched on. During transportation the oil in the compressor may have flowed into the refrigeration system.Before switching on the appliance for the first time, clean the interior of the applian...

en 9 Getting to know your appliance Please fold out the illustrated last page. These operating instructions refer to several models.The features of the models may vary.The diagrams may differ.Fig. ! * Not all models. Controls Fig. " Switching the appliance on Fig. " Switch on the appliance w...

en 10 Operating tips ■ While the refrigeration unit is running, water droplets or a thin layer of ice may form at the rear panel of the refrigerator. This is nothing unusual. It is not necessary to scrape off the frost or wipe off the water droplets. The rear panel defrosts automatically. The conden...

en 11 Note the chill zones in the refrigerator compartment The air circulation in the refrigerator compartment creates different chill zones: ■ Coldest zone is between the arrow stamped on the side and the glass shelf situated below. Fig. % Note Store perishable food (e.g. fish, sausage, meat) in th...

en 12 Interior fittings (not all models) Glass shelves Fig. ' If required, you can vary the shelves inside the appliance: To do this, pull out shelf, lift at the front and take out. Adjustable “EasyLift” door shelf Fig. ( The height of the shelf can be adjusted without taking it out.Simultaneously p...

en 13 Cleaning the appliance m Caution ■ Do not use abrasive, chloride or acidic cleaning agents or solvents. ■ Do not use scouring or abrasive sponges. The metallic surfaces could corrode. ■ Never clean shelves and containers in the dishwasher. The parts may become deformed! Proceed as follows:1. B...

en 14 Tips for saving energy ■ Install the appliance in a dry, well ventilated room! The appliance should not be installed in direct sunlight or near a heat source (e.g. radiator, cooker).If required, use an insulating plate. ■ Allow warm food and drinks to cool down before placing in the appliance....

en 15 Eliminating minor faults yourself Before you call customer service:Please check whether you can eliminate the fault yourself based on the following information.Customer service will charge you for advice – even if the appliance is still under guarantee! Fault Possible cause Remedial action Tem...

en 16 Appliance self-test Your appliance features an automatic self-test program which shows you sources of faults which may be repaired by customer service only. Starting the appliance self-test Fig. " 1. Switch off the appliance with the On/ Off button 1 and wait 5 minutes. 2. Switch on the ap...