BISSELL 18P03 - User Manual

Page 2 - hanks for buying a BISSELL vacuum; We’re glad you purchased a BISSELL Garage ProTM vacuum. Everything we

2 T hanks for buying a BISSELL vacuum 2 w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1 We’re glad you purchased a BISSELL Garage Pro™ vacuum. Everything we know about floor care went into the design and construction of this complete, high-tech home cleaning system. Your BISSELL Garage Pro™ va...

Page 3 - MPORTANT SAFETY INSTRUCTIONS; To reduce

3 I MPORTANT SAFETY INSTRUCTIONS When using an electrical appliance, basic precautions should be observed, including the following: READ ALL INSTRUCTIONS BEFORE USING YOUR GARAGE PRO VACUUM. Always connect to a polarized outlet (left slot is wider than right). Unplug from outlet when not in use and ...

Page 4 - roduct view

4 w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1 Wet/Dry Hose Inlet Blower Hose Outlet Dirt Tank Face Plate Power Switch Power Cord Hooks Muffler Dirt Tank Handles P roduct view ug110-4025_18P0_208.indd 4 ug110-4025_18P0_208.indd 4 2/12/08 12:17:17 PM 2/12/08 12:17:17 PM

Page 5 - Your unit will require no tools to put together.; Mounting & installation; ssembly

5 w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1 Your unit will require no tools to put together. 1 . Remove the dirt tank by pulling up on both handles to unlatch. Lift upper half of unit to remove. 2 . Remove all accessories and parts stored in the bottom of the tank prior to use. 3 . If th...

Page 6 - Mounting the Hose Holder (fasteners included); Power switch

Mounting & installation continued Concrete Wall (fasteners not included) You will need; (4) 3/8” x 2-1/4” concrete sleeve anchors. 1 . Drill a 3/8” x 1-3/4” hole with a masonry drill bit. 2 . Insert a bolt and anchor sleeve into the hole. 3 . Align the bracket over the hole and mark remaining ho...

Page 7 - Safety device; peration

Wet or dry vacuuming mode 1. Attach hose to the wet/dry hose inlet opening (located on the front left side of the unit) by pushing fitted end of hose and turning clockwise until you feel it is secure. 2. Attach extension wand, if desired, to end of hose by pushing it firmly into the hose. 3. Attach ...

Page 8 - Thermal motor protection:; Face plate; 2” Flexible crush proof hose

Thermal motor protection: An internal thermal protector has been designed into your cleaner to protect it from overheating. When the thermal protector activates, the main vacuum motor will stop operating. If this happens, proceed as follows.1. Turn the vacuum OFF and unplug from electrical outlet. 2...

Page 10 - aintenance and care; Cleaning the dirt tank; Cleaning the filters; Primary filter

10 w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1 M aintenance and care Cleaning the dirt tank 1. Unplug the unit from electrical outlet. 2. Remove the dirt tank by pulling up on both handles to unlatch. 3. Ensure the dirt tank has been emptied. 4. The dirt tank may be washed in warm water. M...

Page 11 - Cleaning the filters continued; Secondary filter; Clearing clogs

11 w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1 M aintenance and care Cleaning the filters continued Secondary filter 1. The secondary filter is located above the primary filter. 2. To remove the primary filter, see instructions on page 10. 3. To remove the secondary filter, pull filter dow...

Page 12 - Clearing clogs continued; Tool maintenance; Note: The multi surface floor tool

M aintenance and care 12 w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1 Clearing clogs continued If the clog is contained near the bottom of the hose (close to where tools are attached), follow these steps: 1. Remove wand or tool. 2. Attach hose to the blower outlet and turn the power on. 3. ...

Page 13 - roubleshooting; Vacuum cleaner won’t turn on; Vacuum cleaner and tools won’t pick up or low suction; Possible causes; Thank you for selecting a BISSELL product.; Please do not return this product to the store.; For any questions or concerns, BISSELL is happy to be of service.

13 w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1 T roubleshooting Vacuum cleaner won’t turn on Possible causes Remedies 1. Power cord not plugged in 1. Check electrical plug 2. Blown fuse/tripped breaker in home 2. Check/replace fuse or reset breaker 3. Thermal protector activated 3. Allow c...

Page 14 - BISSELL Consumer Services; Saturday; Or visit the BISSELL website -; When contacting BISSELL, have model number of cleaner available.; ISSELL Consumer Services

14 w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1 For information about repairs or replacement parts, or questions about your warranty, call: BISSELL Consumer Services 1-800-237-7691 Monday - Friday 8 a.m. — 10 p.m. ET Saturday 9 a.m. — 8 p.m. ET Or write: BISSELL Homecare, Inc.PO Box 3606Gra...

Page 15 - eplacement parts - BISSELL Garage ProTM Vacuum; Item

16 w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1 15 R eplacement parts - BISSELL Garage Pro™ Vacuum You may purchase parts from your retailer, by calling BISSELL Consumer Services or by visiting our website. Below is a list of common replacement parts. While not all of these parts may have c...

Page 16 - arranty - BISSELL Garage ProTM Vacuum; Limited Two Year Warranty; If your BISSELL product should require service:

16 w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1 16 w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1 W arranty - BISSELL Garage Pro™ Vacuum This warranty gives you specific legal rights, and you may also have other rights which may vary from state to state. If you need additional instru...

BISSELL 18P03 - User Manual

Table of Contents:

Summary

Other BISSELL Vacuums Models