Audiovox VOD122 - Manual
Audiovox VOD122 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Select the color that matches the interior trim.
- Page 3 – MATERIALS INCLUDED IN THIS PACKAGE:; Hardware Package; Optional Accessories
- Page 4 – Installing The Snap On Covers; Place the pod on a soft surface to avoid damaging the plastic.; Housing; Installing The Shroud
- Page 5 – Removing The Snap On Cover (Shroud) From The Housing; pry tool; Removing The Snap On Cover (Screen Back) From LCD The Housing
- Page 6 – VEHICLE PREPARATION:; installation of the VOD122 and related console accessories.; GENERAL INSTALLATION APPROACH:; respective locations.
- Page 7 – GENERAL SYSTEM CONFIGURATIONS:; OSD will appear on the screen for 4~5 seconds; SOURCE; and; FMM; buttons on the unit
- Page 8 – TRIM RING INSTALLATION:; trim ring to video monitor.
- Page 9 – MOUNTING THE TRIM RING
- Page 11 – Figure A; Auxillary Video Display; PODTVT2
- Page 12 – CONNECTING THE DOME LIGHTS; Positive Switched Dome Lighting; Factory Dome light circuit
- Page 13 – Negative Switched Dome Lighting; No power at Video Monitor
Installation Guide
VOD122
12.1" OVERHEAD LCD MONITOR
WITH DVD PLAYER
®
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
An LCD panel and / or video monitor may be installed in a motor vehicle and visible to the driver if the LCD panel or video monitor is used for vehicle information, system control, rear or side observation or navigation.If the LCD panel or video monitor is used for television reception, video or DVD...
1 TOOLS REQUIRED: #2 Phillips Screwdriver#1 Phillips ScrewdriverUtility or Razor Knife or ShearsWire StrippersUpholstery hook tool (for removal of panels as necessary)Electrical TapeMasking TapeMultimeter (to verify 12 volt DC and continuity: Do not use a test light or logic probe)Marker pen – to ma...
2 Installing The Snap On Covers Begin by hooking area “A” (above) over the dome light and slide the cover over the pod. The cover will snap in place. Place the pod on a soft surface to avoid damaging the plastic. Open the screen and hook the two tabs “B” on the bottom edge of the screen. Snap the op...