Audiovox pro 9276 - Manual
Audiovox pro 9276 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 5 – This system is to be used in vehicles with; AUTOMATIC TRANSMISSIONS; personal injury and property damage.
- Page 7 – SEE NEUTRAL START SAFETY TEST FOR FURTHER DETAILS.; Ignition 1 Output
- Page 8 – WIRING THE 4 PIN ALTERNATE IGNITION HARNESS; Parking Brake Input; Do not remove the fuse holders from this wire harness. Fuses must be
- Page 9 – Brake Switch Positive Shutdown Detail
- Page 10 – Ignition 3 / Shock Disable Output
- Page 11 – General Motors VATS By-Pass Diagram; Tach Sensor Input
- Page 12 – Pulsed Ground Output Before Start; Push-Button LED Programming Switch Assembly:; Diesel Wait To Start Input
- Page 13 – Channel 3 Relay Wiring Detail
- Page 14 – Entry Illumination Detail
- Page 16 – ignition switch off. DO NOT attempt to remove the key.
- Page 19 – contact with
128-7855
1 of 20
1
The selectable features can be set manually as explained below, or with the RF feature programmer.
To set features using the RF programmer, follow the instructions packaged with the programmer.
Factory default settings are indicated by bold text.
Note :
The method of manual override can either be selected to operate from the valet switch or operate as custom code.
Be certain to place a check mark indicating the method used in the box located on the last page of the owner's manual.
NOTE: Keyless Entry Models with no horn output will Flash the Parking Lights instead of chirp where chirp is indicated.
Also, No data will be indicated if a feature is not available for a particular model. The unit will enter the feature but no selection will be available.
RF Programmable Feature Bank 1 Is For Transmitter Programming See Transmitter Programming Guide.
RF Programmable Features Bank 2 Is Alarm Selectable Features:
Feature Selection
1 Chirp
2 Chirps
3 Chirps
4 Chirps
5 Chirps
6 Chirps
1st DoorL/UL
1 Sec.
3.5 Sec.
1 Sec L, Dbl. U/L
Dbl L, 1 Sec UL
Dbl L, Dbl UL
1 S l/350mS ul
2nd Accy Lock
Auto Lock On
Auto Lock Off
3rd Accy. UL
Auto UL Dr.
Auto UL All
Auto UL Off
`
4th Headlights
Not Available
5th Passive Locks
Not Available
6th Pass/Act Arm
Not Available
7th Siren/Horn
Not Available
8th Horn Chirp
10mS
16mS
30mS
40mS
50mS
9th O/R Method
Not Available
10th 2 Step U/L
On
Off
11th Chp Del Tx
On
Off
12th Vlot Sense/Hd Wire
Not Available
13th Trigger Circuits
Not Available
14th L/UL Poll
Not Available
15th Aux Ch 5 Sel
P u l s e
Push & Hold
10 Sec
20 Sec
Latch On/Off
Hold 3/S For O/P
16th Aux Ch 6 Sel
P u l s e
Push & Hold
10 Sec
20 Sec
Latch On/Off
Hold 3/S For O/P
17th Aux Ch 7 Sel
P u l s e
Push & Hold
10 Sec
20 Sec
Latch On/Off
Hold 3/S For O/P
18th Trigger Delay
Not Available
When using the RF programmer, enter the program mode as follows:
Turn the ignition on.
Press and release valet switch 3 times;
turn ignition off then on.
Press and hold valet switch for 5 seconds.
Siren and or lights chirp/flash 2 times indicating access to RF feature program mode.
Model PRO-9276
Installation Manual
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
128-7855 5 of 20 5 This Remote Start System is designed for use with Automatic Transmission Vehicles Only! The unitprovides wait to start input for glow plug pre-heat which will be used for all diesel applications. If this wireis not connected, then the unit will remain in the Gasoline mode setting,...
128-7855 7 of 20 7 SEE NEUTRAL START SAFETY TEST FOR FURTHER DETAILS. BLUE WIRE: Ignition 1 Output Connect this wire to the ignition 1 wire from the ignition switch. This wire will show +12 volts when theignition key is turned to the to the "ON" or "RUN" and the "START" or CR...
128-7855 8 of 20 8 WIRING THE 4 PIN ALTERNATE IGNITION HARNESS ORANGE/BLACK Wire: Parking Brake Input This wire is used only when the turbo timer mode, Bank 3, feature # 16 is selected ON. This input insuresthat the vehicle parking brake is applied whenever the vehicle is set up for and the turbo ti...
