Audiovox AS - 9151N - Manual
Audiovox AS - 9151N – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – IGNITION SWITCH KEY POSITION
- Page 3 – WIRING CONNECTIONS: 12 Pin Input / Output Harness; Connect this wire to a solid, clean chassis ground source.; If the alarm system does not incorporate a hood pin switch,
- Page 6 – CYLINDERS
- Page 7 – WIRING THE 12 PIN INPUT / OUTPUT HARNESS
R e m o t e C a r Sta r t e r
I n s ta l l a t i o n I n s t r u c t i o n s
AS - 9151N
For installation in vehicles with 12 volt negative ground circuits,
gasoline engines, with automatic transmission only!
K I T C O N T E N T S
(1) Remote Start Control Module
(2) Wiring Harnesses
(1) Parts Bag Containing
(2) Fuses
(2) Fuse Holders
(1) Control Switch
(1) Hood Diode Bridge
(1) Literature Package
(1) RF Antenna Extender (AS-9166)
F o r m N o . 1 2 8 - 4 5 0 0 B
(1) Ring Terminal
(4) 1/2" Long Screws
(1) Pin Switch
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
BATT 1 BATT 2 ACC IGN 1 IGN 2 IGN 3 START * SPLICE (TYP.) IGNITION SWITCH KEY POSITION OFF ACCESSORY ON / RUN START LT.BLUEWIREFROMAS-9151N VIOLETWIREFROMAS-9151N REDWIREFROMAS-9151N REDw/WHITETRACEWIREFROMAS-9151N SEE"WIRINGTHE12PINCONNECTOR"-LT.BLUEWIREIFREQUIRED. LT.GREENWIREFROMAS-9151N ...
WIRING CONNECTIONS: 12 Pin Input / Output Harness 1. BLACK Wire: Chassis Ground Source Connect this wire to a solid, clean chassis ground source. 2. DARK BLUE Wire: Remote Start Signal Input Connect this wire to the pulsed ground output from the remote alarm system. In most cases, it will be connect...
PROGRAMMING AND TESTING: 1. You will notice a 4 position dip switch on board the remote start module. Dip switch #1 and #2 are used to program the Tach Rate. Refer to the chart below for proper setting of these dip switches. 2. Dip switch #3 controls the run time of the AS-9151N. ON = 10 Minute Run ...
