Audiovox APS-995C - Manual
Audiovox APS-995C – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 3 – SILENT ARMING - ACTIVE (Must be activated during programming)
- Page 4 – PROTECTION WHILE THE SYSTEM IS ARMED
- Page 7 – MANUALLY OVERRIDING YOUR SYSTEM:; override sequence. Turn the ignition switch to the on position.
- Page 8 – (The siren or horn will beep and the lights will flash one time.)
- Page 10 – NOTE: Shock Sensor Icon Is Displayed On The LCD Panel.
- Page 12 – TO BEGIN THE AUTOMATIC START UP TIMER
- Page 15 – TRANSCEIVER ICONS AND THEIR INDICATIONS; When Armed, Press the Disarm/Unlock button to
- Page 20 – SYSTEM FUNCTIONS AT A GLANCE; DASH LED INDICATORS
Model APS-995C
Owner’s Manual
IMPORTANT ! In order to provide you with the highest level of security to your
vehicle, this system is equipped with selectable manual override circuitry. It is
possible that you will need to override you security system if the transmitter
becomes lost, or inoperative due to battery failure. Reading the sections on
"Manually Overriding Your System" is necessary to fully understand the procedure
required to enable your vehicle in such situations. In addition, the chart on the last
page of this manual has a section for the particular features and options installed
in your vehicle as well as the override method selected. Although the default
mode is "Valet Switch" operation, the system can be configured for "Custom
Code" operation for enhanced security. Confirm the override mode selected on
the last page of this manual, and familiarize yourself with the section on it's opera-
tion.
FEATURES :
w
1 Two Way 5 Button Remote Control And 1 One Way 4 Button Remote Control
w
Six Channel Code Learning Programmable Receiver
w
External Superheterodyne Transceiver Antenna
w
Single Or Two User Programmable W/Separate Control Outputs
w
Single Button Lock/Unlock or Separate Button Lock/Unlock or Both
w
Remote Keyless Entry With Optional Access Guard (must have power door
locks)
w
Selectable Manual Override Mode
w
New Enhanced Panic Feature (Any button other than unlock stops siren, no
change to the units state)
w
Smart Disarm (If triggered, elect to shut off siren, or disarm entire unit )
w
Adjustable Shock Sensor Via The Transmitter (Pre-Detect Off, Pre & Full Detect
Off, City Mode)
w
Safe Start Output Controlled From Channel 3 (Option Channel 3 For Trunk, Or
For R/S)
w
24 Hour Time Start Mode
w
Cold Temperature Start Mode
w
2 or 4 Hour Automatic Start Mode
w
Parking Meter Count Down Timer On LCD Remote
w
Additional Count Down Timer Mode
w
Remote Panic In All Modes (Press & Hold Lock /Unlock Button For 3 Seconds
To Engage)
w
Improved Custom Code Override, User Selectable and Programmable
4 Button Remote Start Security System With
Plug-In Shock Sensor & Starter Disable
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Page 3 known as a code grabber, which will receive and store the signal from yourkeychain transmitter and re-transmit at a later time to disarm your system.Your Keeloq Code Hopping transmitters will change their signal every time thebutton is pressed, so when a thief grabs then re-transmits your sig...
Page 4 þ Siren will not sound. If the siren sounds 3 chirps, then you have left a door, trunk, orhood lid ajar. Simply close the opened entry point to providefull protection o Doors Lock - Optional NOTE: If the optional Headlamp illumination feature has been added, and has been selected for operatio...
Page 7 When the system is in valet mode, all alarm functions are bypassed, however theremote panic feature and remote door locks will remain operational. In addition,the parking lights will flash to indicate locking and unlocking. To use the valetmode, the system must first be disarmed either by usi...
