Audiovox APS 675 - Manual

Audiovox APS 675

Audiovox APS 675 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
17 Page 17
18 Page 18
Page: / 18

Table of Contents:

  • Page 2 – MUST HAVE a Tach Signal
  • Page 5 – WIRING CONNECTIONS: 12 Pin Input / Output Harness; Chassis Ground Source
  • Page 6 – Brake Switch Positive Shutdown Detail; THAT IT IS PRESENTLY CONNECTED TO IN THE VEHICLE.
  • Page 7 – General Motors VATS By-Pass Diagram
  • Page 8 – DARK GREEN/ORANGE Wire: Tach Sensor Input; Tachometer Input Wiring Detail; Wire Ground Switched Door Lock Circuits:; WireGround Switched Door Lock/Unlock Wiring Detail
  • Page 9 – Wire Positive Switched Door Locks:; Wire Positive Switched Door Lock/Unlock Wiring Detail; Pin Blue Connector :
  • Page 10 – Blue and Green w/Black Trace Wires - 2 Pin Accessory Output Harness; Delayed 300 mA Pulsed Output/Channel 2; Channel 2 Relay Wiring Detail; 00mA Latched Channel 3 Output
  • Page 11 – Entry Illumination Detail
  • Page 16 – METHOD 1
  • Page 17 – METHOD 2; To connect to the key in sensor circuit as shown for method 2:; COMPLETING THE INSTALLATION:; sure to clean the surface before affixing the label.
  • Page 18 – WIRING DIAGRAM
Loading the manual

Model APS 675

Installation Manual

3 Channel Remote Start / Keyless Entry System

Installation Instructions

This Unit Is Intended For Installation In Vehicles With

12 Volt Negative Ground Electrical Systems,

Gasoline or Diesel With True Tach Reference

And Automatic Transmissions Only.

Kit Contents

APS-675 Control Module

(2) - 3 Button Anti Code Grabbing Transmitters

3 Channel Code Learning Receiver

External Superheterodyne Antenna/Receiver

(1) - Multi Pin Input/Output Harness

(1) - Six Pin Power Harness

(1) - Four Pin Auxiliary Harness

(1) - Two Pin I/O Harness

(1) - Accessory 2 Pin Connector

(1) - 2 Pin Door Lock Harness

(2) - 30 Amp In-line Fuse Holders With Fuses

(1) - Control Switch

(1) - Programming Switch

(1) - Ring Terminal

(4) - 1/2" Long Screws

(1) - Pin Switch

(1) - Remote Start Warning Label

(1) - Literature Package

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - MUST HAVE a Tach Signal

The APS-675 Remote Start/Keyless Entry System is designed to be used with Automatic TransmissionVehicles Only! The unit provides a selectable ignition control that allows a 10 second output for glow plugpre-heat which may be required for certain diesel vehicles, (see selectable feature #9). If the d...

Page 5 - WIRING CONNECTIONS: 12 Pin Input / Output Harness; Chassis Ground Source

WIRING CONNECTIONS: 12 Pin Input / Output Harness Black Wire: Chassis Ground Source Connect the Black wire to a known vehicle ground source or to a solid clean metal part of the chassis. Becertain to remove any paint or grease and secure this wire with a self taping screw and ring terminal. BLACK w/...

Page 6 - Brake Switch Positive Shutdown Detail; THAT IT IS PRESENTLY CONNECTED TO IN THE VEHICLE.

Brake Switch Positive Shutdown Detail YELLOW w/ BLACK Tracer Wire: + 12 Volt Alarm By - Pass OutputNOTE: YOU MUST DISCONNECT THE IGNITION INPUT OF THE ALARM FROM ANY OTHER WIRE THAT IT IS PRESENTLY CONNECTED TO IN THE VEHICLE. This wire provides a + 12 Volt output when the ignition key is turned to ...

Other Audiovox Models