Audiovox APS-92BT-CL - Manual
Audiovox APS-92BT-CL – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – confirm that programming of channel 1 was successful.; TO PROGRAM ADDITIONAL TRANSMITTERS:
- Page 3 – VALET SWITCH
- Page 4 – and dispose of properly.
- Page 5 – ORDERING ADDITIONAL or REPLACEMENT TRANSMITTERS:; Order Form for Additional 2 Button Transmitters
Owner's Manual
The transmitters included in the security system kit are pre-programmed at the factory, with
button # 1 assigned to channel one only. The suggested program arrangement is listed below.
To program channel 2 and 3, please follow the programming instructions listed on pages two
and three of this manual.
Transmitter Button Functions
Transmitter Programming Guide
Remote Arm/Disarm
Remote Emergency Panic
Door Lock/Unlock (Optional)
Pulsed Output
*(Optional Devices)
Switched Output
* (Optional Devices)
3
1
2
Button #2
Both Buttons
Button #1
Factory Settings for Transmitter Buttons
Button
Channel
System Function
* Some of the more common accessories for these channels are;
AS 9151 Remote Car Starter
AS 9256 Remote Trunk Release Relay
AS 9154 Remote Garage Door Interface
AS 9153 Remote Window Roll Up
Model APS-92BT-CL
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
These factory programmed settings can be prioritized based on an individual's frequency ofuse, (i.e. pressing both buttons simultaneously to activate channel 1, arm/disarm etc.) byfollowing the normal programming instructions below.Please note when changing the button sequences of the factory settin...
6. Move the valet/bypass switch on, then off again.7. The dash mounted L. E. D. will flash 2 times, and the siren will "chirp" one time, indicating that the system is ready to accept programming for channel 2, or the pulsedground output for remote trunk release, remote car starter, etc. 8. Y...
The transmitter incorporates a small red L.E.D. built into the case. This L.E.D. can be usedto indicate battery condition. You will notice a decrease in transmitter range as the batterycondition deteriorates. To replace the battery...1. Remove the transmitter cover by removing the small screw from t...
