Audiovox APS-905 - Manual
Audiovox APS-905 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 3 – To program these selectable features
- Page 4 – program these selectable features
- Page 6 – INSTALLATION OF THE MAJOR COMPONENTS:
- Page 7 – Starter Output
- Page 8 – Accessory Output
- Page 9 – WIRING CONNECTIONS: 12 Pin Input / Output Harness; Black Wire: Chassis Ground Source; Control Switch; GRAY WIRE: Negative Inhibit Input 1
- Page 10 – BROWN w/ BLACK Tracer Wire: Positive Inhibit Input 2; Brake Switch Positive Shutdown Detail; Switch
- Page 11 – LIGHT BLUE Wire: Ground Output While Running.; General Motors VATS By-Pass Diagram
- Page 12 – Tachometer Input Wiring Detail; Green/Yellow Wire: Diesel Wait To Start Input
- Page 13 – Wire Ground Switched Door Lock Circuits:; Wire Ground Switched Door Lock/Unlock Wiring Detail; Wire Positive Switched Door Locks:; Wire Positive Switched Door Lock/Unlock Wiring Detail
- Page 17 – KEY IN SENSOR CIRCUITS:
- Page 18 – METHOD 1; METHOD 2
- Page 19 – COMPLETING THE INSTALLATION:; point these out to the customer.
128-7410
1 of 20
Page 1
Kit Contents
(1) Control Module
(1) 5 Button One Way Flashlight Transmitter
(1) 5 Button Two Way Dot Matrix Transceiver
(1) On Glass Mount Superheterodyne Transceiver
(1) Multi Pin Input/Output Harness
(1) Six Pin Power Harness
(1) Four Pin Alternate Ignition Harness
(1) Trunk Release Output Harness
(1) Auxiliary 4 Pin Output Harness
(1) 2 Pin Door Lock Harness
(3) 30 Amp In-line Fuse Holders With Fuses
(1) Control Switch
(1) Plug In Push-Button Programming Switch
(1) Ring Terminal
(4) 1/2" Long Screws
(1) Pin Switch
(1) Remote Start Warning Label
(1) Literature Package
Model APS-905
Installation Manual
3 Channel Remote Start / Keyless Entry System
Installation Instructions
This Unit Is Intended For Installation In Vehicles With
12 Volt Negative Ground Electrical Systems,
Gasoline or Diesel With True Tach Reference
And Automatic Transmissions Only.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
128-7410 3 of 20 Page 3 To program these selectable features; Action System Response Turn ignition on No response Press and release the valet switch 3 times 1 Chirp - LED 1 flash Within 3 seconds, turn ignition Off Then On Short chirp, then long chirp This Action Accesses Feature Bank 2 Alarm Select...
128-7410 4 of 20 Page 4 T o exit program mode, turn ignition of f, or press and release valet switch. RF Programmable Features Bank 3 Is Remote Start Selectable Features: T o program these selectable features; Turn ignition on No response Press and release the program switch 3 times 1 flash Within 3...
128-7410 6 of 20 Page 6 This Remote Start/Keyless Entry System is designed for use with Automatic Transmission Vehicles Only! The unit provides wait to start input for glow plug pre-heat which will be used for all diesel applications. If this wireis not connected, then the unit will remain in the Ga...
