Audiovox APS 685 - Manual

Audiovox APS 685

Audiovox APS 685 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
17 Page 17
18 Page 18
19 Page 19
20 Page 20
Page: / 20

Table of Contents:

  • Page 6 – Brake Switch Positive Shutdown Detail; WIRE THAT IT IS PRESENTLY CONNECTED TO IN THE VEHICLE.
  • Page 8 – General Motors VATS By-Pass Diagram
  • Page 9 – Wire Ground Switched Door Lock/Unlock Wiring Detail
  • Page 11 – Wire Positive Switched Door Lock/Unlock Wiring Detail
  • Page 12 – Blue and Green w/Black Trace Wires - 2 Pin Accessory Output Harness; some remote start trigger inputs, will damage the control module.; Channel 3 Relay Wiring Detail
  • Page 13 – Entry Illumination Detail; certain to connect the tach input wire.
  • Page 15 – change, the above sequence will have to be followed.
  • Page 16 – the ignition switch off. DO NOT attempt to remove the key.
  • Page 18 – METHOD 1
  • Page 19 – mote Start Unit as shown below.; METHOD 2; sure to clean the surface before affixing the label.
  • Page 20 – WIRING DIAGRAM
Loading the manual

Model APS 685

Installation Manual

4 Channel Remote Start / Keyless Entry System

Installation Instructions

This Unit Is Intended For Installation In Vehicles With

12 Volt Negative Ground Electrical Systems,

Gasoline or Diesel With True Tach Reference

And Automatic Transmissions Only.

Kit Contents

APS-685 Control Module

(2) - 4 Button Anti Code Grabbing Transmitters

4 Channel Code Learning Receiver

External Superheterodyne Antenna/Receiver

(1) - Multi Pin Input/Output Harness

(1) - Six Pin Power Harness

(1) - Four Pin Auxiliary Harness

(1) - Two Pin I/O Harness

(1) - Accessory 2 Pin Connector

(1) - 2 Pin Door Lock Harness

(2) - 30 Amp In-line Fuse Holders With Fuses

(1) - Control Switch

(1) - Programming Switch

(1) - Ring Terminal

(4) - 1/2" Long Screws

(1) - Pin Switch

(1) - Remote Start Warning Label

(1) - Literature Package

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 6 - Brake Switch Positive Shutdown Detail; WIRE THAT IT IS PRESENTLY CONNECTED TO IN THE VEHICLE.

BROWN w/ BLACK Tracer Wire: Positive Inhibit Input 2Any time + 12 Volts is applied to the Brown w/ Black tracer wire, the Remote Starter will stop operating, evenif the signal is received from the transmitter. If the brake light switch in the vehicle switches + 12 Volts to thebrake light circuit, co...

Page 8 - General Motors VATS By-Pass Diagram

General Motors VATS By-Pass Diagram DARK GREEN/ORANGE Wire: Tach Sensor InputThis wire will continually monitor the engine tach rate while the unit is under power of the Remote Startmodule. This wire will be routed to the vehicle ECM tach input or through the firewall into the enginecompartment and ...

Page 9 - Wire Ground Switched Door Lock/Unlock Wiring Detail

3 Wire Ground Switched 2 Step Door LocksIn this application, the red wire provides a ground pulse during locking, or the pulsed ground lock output.Connect the red wire to the wire that provides a low current ground signal from the factory door lock switchto the factory door lock control relay.The gr...

Other Audiovox Models